Which of the ff. is accounted by theFourier's Law of Heat Conduction?O Rate of heat inO Rate of heat generationO rate of heat outO rate of heat accumulationO a, b, and cO a and bO all of the above

Answered: Which of the ff. is accounted by the…

Which of the ff. is accounted by the Fourier's Law of Heat Conduction? O Rate of heat in Rate of heat generation O rate of heat out O rate of heat accumulation O a, b, and c a and b

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter4: Numerical Analysis Of Heat Conduction

Section: Chapter Questions

Problem 4.1P

See similar textbooks

Related questions

Q: ne čórrect statement in relation to first law of thermodynamics i.e. Q=W+A U is, . [A] Q is negative…

A: About the correct statement in relation to the first the of thermodynamics.

Q: We lose heat from our body by not sufficient information conduction radiation convection

A: There are three modes of heat transfer 1) Conduction - The transfer of heat from one substance to…

Q: 2. The radial heat conduction through a hollow cylinder increases as the ratio of outer radius to…

A: Conduction is the mode of heat transfer in which energy transfers from higher energetic particle to…

Q: Pls. Answer thank you! An air-conditioning system is used to maintain a house at 65°F when the…

Q: Q4) Define Fourier's law of heat conduction with units?

A: Define fourier's law of heat conduction.

Q: What is the difference between Energy transfer and Energy transformation With an example؟

A: Solution:

Q: Which of the following provides the basis of conduction heat transfer? O Stefan-Boltzmann Law O…

A: Fourier law gives the basic of conduction of Heat transfer. Q=-K*A*∆T/∆x Where K is the thermal…

Q: The ratio of heat flow through walls A and B (Q/Qµ) having the same thickness having thermal…

A: Given, Relation between thermal conductivities of A and B : kA = 4 kB Relation between temperature…

Q: Which of the following is source of sensible and latent heat A. Infiltration B. Light C. Radiation…

A: Correct answer: Infiltration

Q: odynamics The temperature gradient in a slab at steady conduction is -1000°C/m. The slab conducts…

A: Given:temperature gradient=dTdx=- 1000o C/mQ=250 W/m2

Q: Q1) Prove that the equation for one dimension unsteady state conduction with heat generation 9_ 1 dT…

A: Find the one dimensional heat equation.

Q: Newton's Law of cooling: (3.1 p. 88) A cake is removed from an oven and its temperature is 300°F.…

A: The initial temperature of the cake when it is removed from the oven θ1=300oFafter three minutes its…

Q: 7. An automobile engine consumes fuel at a rate of 22 L/h and delivers 55 kW of power to the wheels.…

Q: lock in ‘meter’ capable of being charged to 2.4 x 106 Volt potential before sparking into the air,…

Q: A house, for cooling purposes, consists of two zones: the attic area zone A and the living area zone…

A: Solution: Given Data: K1 = 1/4 K2 = 1/8

Q: A device expends 172.31 kJ of energy while pressurizing 8.812 kg of water initially at 11.44°C. The…

Q: Q17) The unit of thermal conductivity (k) is: B) w/m k C) m/sec A) w/m e The unit of thermal…

A: Find the unit of thermal conductivity and thermal diffusivity and heat transfer coefficient.

Q: Choose the wrong statement. Convective heat transfer depends on A) none of the above…

A: Convection: Convection is a mode of heat transfer that takes between the solid body and the…

Q: XIV- NTC and PTC are where the first with negative and second one with positive coefficient. a)…

A: Problem is based on basic electrical and can be solved as

Q: 5. In class, we have learned the effectiveness of fin as ŋ = (Actual heat loss)/(Ideal max heat…

A: Ideal maximum heat loss from the fin surface is the heat loss when the entire fin becomes isothermal…

Q: Determine the quantity (volume) of saline water in a steam generator. The heat energy of 1590 kJ is…

Q: A device expends 174.78 kJ of energy while pressurizing 3.472 kg of water initially at 17.4°C. The…

A: Useful heat given by the system will be used to raise the water temperature. Q = 174.58 kJ…

Q: Q2: A person of skin temp. of 30 K and body surface area 1.75 cm, find: (a): net total power if he…

A: Given: The skin temperature, T = 30°C The area, A = 1.75 cm^2 The wall temperature, Tw = 22°C The…

Q: 2 Find the thermal efficiency of a Carnot engine whose hot and cold bodies have temperatures of…

A: Given:Cold body tempearture,TL=15οC=(15+273)K=288KHot body temperature,TH=154οC=(154+273)K=427K

Q: Q1/ Drive the work in polytrophic process when( n-1),(n%3D1.3)

A: The solution of the same is attached below:

Q: 1) Briefly explain the following. Why the temperature of heat conduction study bench should not…

A: Heat conduction is a medium of heat transfer in which the heat is transferred to the whole material…

Q: onsider an aluminum pan used to cook stew on top of an electric r nd' has a diamețer of 14 cm. The…

A: given:η=0.9d=14cmQ=900W

Q: nit of thermal conductivity in S.I. units is (A) J/m² sec

A: Given: Thermal conductivity

Q: is |Q|=-kA(dt/dx) the law that defines the rate of heat transfer by conduction (fourier's law of…

A: Q=-kAdt/dx is the Fourier's law of heat conduction which defines the rate of heat transfer by…

Q: We are walking outside in a very hot summer day. The climate is such that the wind velocity is zero…

A: There are three types of heat transfer possible 1. conduction 2. convection 3. Radiation…

Q: A steady-state electric motor operates under 10 Ampere and 220 Volt operating conditions. The output…

Q: The amount of heat flow through a body by conduction is Directly proportional to the surface area of…

A: As per Fourier's law of heat transfer, amount of heat flow rate is given by, Q = k A ∆T∆x Here, Q =…

Q: To solve heat conduction equation, we have assumed O steady case O all of the above O constant…

A: The heat conduction equation is based on the Fourier law. It states that the heat transfer per unit…

Q: A house is cooled by a heat pump driven by an electric motor using the inside as the low-temperature…

Q: Heat conduction is a physical process analogous to mass advection.

A: FALSE

Q: If the unit of heat flux is [X] and the unit of heat transfer rate is [Y] None of the above. [X]…

Q: Describe each of the three methods of heat transfer, in your own words. Make sure to explain how you…

A: As per given We have to describe a. Conductionb. Convectionc. Radiation

Q: Unit of thermal conductivity in S.I. units is (a) J/m2 sec (b) J/m °K sec (c) W/m °K (d) (a)…

Q: A steam turbine operates with 1.6 MPa and 350 °C steam at its inlet and saturated vapor at 30 °C at…

Q: relation between the heat capacity of a plate (q) and time (t). If the relation between the leachate…

Q: Q1: A// The thermal conductivity k of a liquid metal is predicted via the empirical equation K = A…

A: For the equation to be dimensionally stable, units at the left side should be equal to the units of…

Q: A building consists of two zones A and B (see Figure 5.5). Only zone A is heated by a furnace, which…

Q: (a) Use the following data to calculate the area of solar domestic hot water collector that would be…

A: Given Temperature of water required by the family is Th=60°C. Temperature of supply water is…

Q: 5. In class, we have learned the effectiveness of fin as n = (Actual heat loss)/(Ideal max heat…

Q: نقطة واحدة The minus sign in Fourier's law is necessary because heat is always transferred in the…

A: Fourier law of conduction The rate of heat transfer by conduction along a given direction is…

Q: A cylinder contains 0.45 m' of a gas at 1x 105 Nim' and 80°C. The gas is compressed to a volume of…

A: Given:- T1=80°C =353K P1=1x105 N/m2 P2=5x105 N/m2 V1=0.45m3 V2=0.13m3 To find: 1) Mass, m 2) Index,…

Concept explainers

Conduction and Convection

When energy travels from one object to another it is said to have undergone heat transfer. Heat transfer is nothing but the transfer of thermal energy or internal energy from one thing to another, like e.g., when a vessel with water, kept on top of a burner, heats up because of the flame underneath it.

Question

Which of the ff. is accounted by the
Fourier's Law of Heat Conduction?
O Rate of heat in
O Rate of heat generation
O rate of heat out
O rate of heat accumulation
O a, b, and c
O a and b
O all of the above

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Heat is transferred at a rate of 0.1 kW through glass wool insulation (density=100kg/m3) with a 5-cm thickness and 2-m2 area. If the hot surface is at 70C, determine the temperature of the cooler surface.
3.17 A 1.4-kg aluminum household iron has a 500-W heating element. The surface area is . The ambient temperature is 21°C, and the surface heat transfer coefficient is . How long after the iron is plugged in does its temperature reach 104°C?
Show that the rate of heat conduction per unit length through a long, hollow cylinder of inner radius ri and outer radius ro, made of a material whose thermal conductivity varies linearly with temperature, is given by qkL=TiTo(rori)/kmA where Ti = temperature at the inner surface To = temperature at the outer surface A=2(rori)/ln(ro/ri)km=ko[1+k(Ti+To)/2]L=lenthofcyclinder
8.12 An electric room heater has been designed in the shape of a vertical cylinder 2 m tall and 30 cm in diameter. For safety, the heater surface cannot exceed . If the room air is at , find the power rating of the heater in watts.
The heat transfer coefficient between a surface and a liquid is 57 W/(m2K). How many watts per square meter will be transferred in this system if the temperature difference is 10C?
2.46 The wall of a liquid-to-gas heat exchanger has a surface area on the liquid side of with a heat transfer coefficient of . On the other side of the heat exchanger wall flows a gas, and the wall has 96 thin rectangular steel fins 0.5 cm thick and 1.25 cm high as shown in the accompanying sketch. The fins are 3 m long and the heat transfer coefficient on the gas side is . Assuming that the thermal resistance of the wall is negligible, determine the rate of heat transfer if the overall temperature difference is .
is |Q|=-kA(dt/dx) the law that defines the rate of heat transfer by conduction (fourier's law of heat conduction) or is it |Q| = hA(tb-Tf)?
the question is in heat conservation
THE QUESTION IS ABOUT HEAT TRANSFER SUBJECT
What is the difference between internal heat generation and heat transfer in any direction. Thank you
What are the three methods of Heat Transfer? Explain each.
If the heat rejected to the surroundings is 40% larger than the heat absorbed at the food compartment, determine COP.