Which of the following is the purpose of fail-safe circuits? O Fail-safe circuits are designed to protect electric motors against voltage surge O All of these are true O Fail-safe circuits are designed to provide overload protection for system componen Fail-safe circuits are designed to maintain constant current in electric motor coils

Which of the following is the purpose of fail-safe circuits? O Fail-safe circuits are designed to protect electric motors against voltage surge O All of these are true O Fail-safe circuits are designed to provide overload protection for system componen Fail-safe circuits are designed to maintain constant current in electric motor coils

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter18: Starting And Motor Systems

Section: Chapter Questions

Problem 6RQ: Which of the following tests would not be performed to check for high resistance in the battery'...

See similar textbooks

Similar questions

True or False? A zero reading on an ohmmeter means the circuit or component is open.
Which of the following is not made of semiconductor material? Zener diode Thermistor PM generator Hall-effect switch
Which of the following tests would not be performed to check for high resistance in the battery' cables? Cranking voltage test Insulated circuit resistance test Starter relay by-pass test Ground circuit resistance test
True or False? A batteny is an electromechanical device.
While diagnosing the location of a wire-to-wire short: Technician A checks the wiring of the affected circuits for signs of burned insulation and melted conductors. Technician B checks common connectors shared by the two affected circuits. Who is correct? Technician A Technician B Both A and B Neither A nor B
Which type of resistor is commonly used in automotive circuits? a. Fixed value b. Stepped c. Variable d. All of the above
While measuring the resistance of a wire with an ohmmeter: Technician A says that if low resistance is shown on the meter, the wire is shorted. Technician B says that if no resistance is measured, the wire is shorted. Who is correct? Technician A Technician B Both A and B d. Neither A nor B
What is the device that consists of two unlike metal strips that are attached and have a different rate of expansion and contraction? A. Thermistor B. Thermocouple C. Diaphragm D. Bimetal
Parallel circuits are used in the airconditioning industry to __________.a. supply the correct line voltage toseveral circuitsb. act as a safety circuitc. divide the voltage between twomajor loadsd. all of the above
From the following identify the false statement . A) In electrical safety precaution, necessary steps should be taken to avoid overloading of electrical circuits. B) In housekeeping safety precaution, the machine should be cleared with tools before starting the operation. C) In general safety precaution, the operator should be familiar with the emergency stop button on the machines. E) In general safety precaution, the machine tool should be cleared with metal chips after the machining process.
True or False: When troubleshooting a small system, the first step is to attach the high- and low-pressure gauges.
There is a short circuit in an electric motor winding when A. there is an adverse weather condition. B. a winding conductor is worn bare and touches anotherpart of the conductor that is also bare. C. there is a defect in the centrifugal start switch. D. the motor will not start.