Which of the following is TRUE regarding the distillation set-up? a. None of the above O b. "Water in" should be closer to the receiving flask than the distilling flask. O c. The condenser should be directly attached to the distilling flask. d. The distilling flask should be heated directly under the hotplate to hasten distillation.

Which of the following is TRUE regarding the distillation set-up? a. None of the above O b. "Water in" should be closer to the receiving flask than the distilling flask. O c. The condenser should be directly attached to the distilling flask. d. The distilling flask should be heated directly under the hotplate to hasten distillation.

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter87: Steam Distillation

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

DATA Note: Use the videos as references except when data is provided here. Table 1. Selection of Recrystallizing Solvent. Solvents Dissolution at room temperature? (+ or −) Dissolution at elevated temperature? (+ or −) Distilled water - - Acetone + n/a 95% ethanol - + Toluene + n/a Solid sample: Naphthalene Table 2. Mass Measurements. Mass, g Sample solid 0.5021 Empty watch glass 35.7602 Watch glass with recrystallized sample 36.2485 Table 3. Melting Point Determination. Temperature, oC Appearance of Sample in Capillary Tube … Solid 78.4 Solid 79.3 Solid with signs of liquid 79.9 Solid, liquid 80.6 Liquid, solid 81.3 Liquid with signs of solid … Liquid Theoretical Melting Point, oC: 80.2°C (176.4°F) QUESTIONS Which solvent should be used as the recrystallizing solvent? Check if your chosen solvent satisfies all characteristics of a good…
True or False. It is very important to regulate the temperature of the heating mantle so that the distillation occurs at a rate of about 1 drop per 2 seconds. Why?
distialltion on 30 mL of a mixture of cyclohexane and toluene was perfromed. Their literature values ar given. You need to designate all distillation fractions and pot residue as mostly cyclohexane, mostly toluene, or a mixture
True or False. It is very important to regulate the temperature of the heating mantle so that the distillation occurs at a rate of about 1 drop per 2 seconds. Explain why?
a) What percent of X can be extracted with 100 mL hexane? b) What will be the percent X remaining in water after extraction with four batches of 25 mL hexane? c) Using 100 mL water sample and portions of 25 mL hexane, determine the minimum number of extractions to obtain an efficiency of approximately 99 % Show solution and explanation.
In the reflux distillation, an Erlenmeyer or distilling flask can be used depending on the availability of the condenser or glass tube. A. True B. False
An overachieving student determines that their neutral liquid unknown contains impurities. Suggest at least one method that could be used to further purify the liquid compound.
Fractioned Distillation Microscale Looking at this set up, are there any potential problems with it? Please explain.
kindly help me with this problem thank you ill give like for the answer mixture consists of a certain amount of caffeine dissolved in 100 ml. of water a) How much caffeine was originally used when 0.31 g of the organic compound was devolved n watt:, and 150 ml ether was used as extraction solvent b) How much was dissolved n ether
Taylor was harvesting her beautiful, pure crystals via vacuum filtration from a methanol/water mixedsolvent system. She poured the solution containing her crystals into the Büchner funnel. Then sherinsed her flask with some warm methanol and poured that over the crystals resting in the Büchner…oops! Tell what happened and why
D. Preparation of 3% (vol/vol) Alcohol Solution1. Compute for the volume of denatured ethanol needed to prepare 25 mL of 3% (vol/vol) solution. Note that the concentration of the denatured alcohol stock solution is 98%.2. Explain in detail how the solution will be prepared in the laboratory.
Which technique is more best from flirtation and centrifugation and how??