Write a program in assembly language for the 8085 microprocessor to find the sum of the elements in an array of 16-bit numbers stored in consecutive memory locations starting from address 2000H. The array has 10 elements, and the sum should be stored in memory location 3000H. Assume that the carry flag (CY) is initially cleared and you can use the registers B, C, D, E, and H for any intermediate calculations.

Write a program in assembly language for the 8085 microprocessor to find the sum of the elements in an array of 16-bit numbers stored in consecutive memory locations starting from address 2000H. The array has 10 elements, and the sum should be stored in memory location 3000H. Assume that the carry flag (CY) is initially cleared and you can use the registers B, C, D, E, and H for any intermediate calculations.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Similar questions

Consider two microprocessors having 8-bit and 16-bit wide external data buses, respectfully. The two processors are identical otherwise and their bus cycles are the same speed. Suppose all instructions and operands are two Bytes. By what factor do the maximum data transfer rates vary? Suppose all instructions and operands are one Byte. By what factor do the maximum data transfer rates vary? Discuss your answers.
Write an assembly language program for 8085 microprocessor to add 2 digit BCD numbers stored in memory location C050H and C051H respectively and store the result in memory location C052H.
Draw the figure for memory segments with 8086 microprocessor software model. Explain the logical address structure used for each segment (Explain which registers are used in logical address presentation of each segment; segment address : offset address). Give an example solution to find the physical address in a segment from the logical address for 8086 microprocessor.
Write an assembly language program in microprocessor 8085 so that I can fetch 2 8 bit numbers from memory locations and store the product, whether it's 8 bit or 16 bit, in 2 different memory locations. I am aware with programming logic. So, only give me the working program and attach a snapshot of the output. No need to explain.
Assume SS=5000H, DS=6000H, ES=7000H, CS=9000H, BX=1000H, DI=2000H, BP=3000H, IP=4000H, SI=2000H, the physical address and the addressing mode of the following memory location specified in the instruction MOV [DI+3000H], AL are ……… and ……… .
Detail the stages of executing the MOV instructions assuming an 8 bit processor and a 16 bit IR and program memory following a 8 bit pipeline model.
Construct a bus system using tri state buffer for 2 registers having 4 bits each.
Microprocessor Systems Question: A 20-bit address bus, an 8-bit processor uses a 3-to-8 decoder to partition the memory space. What is the size of each portion?
Given a 8-bit number at memory location 2050H. Write 8085 instruction to move the value stored at the following locations: Register B Accumulator 2052H Write a single program and show register and accumulator screenshot and also attach memory view. In sim8085 software.
Explain the program memory structure of 8051 microcontroller. Write an ALP using 8085 online simulator tool to perform logical XOR operation for two 8 bit data. Load the accumulator with 34 H and load the B register with 1AH.
Using logic gates, design an active low chip select for the memory a 256 K memory device starting at address 38000016 in a 16 Megabyte memory space.
answer: If a memory of 0.5K bytes is connected to 8085 MP, Then the number of lower order address lines required are -------lines, and if 2 higher order address lines are considered as don't care lines,then a fold back space is exists and equals .to----bytes