Write the ionic forms of the following elements and compute for the respective milliequivalent weight; 1.Iron= 57 g/mole; 2. Magnesium= 24 g/mole; 3. Potassium=39 g/mole; 4. Ammonium nitrogen= 15g/mole; and 5. Manganese = 54.9 g/mole. (PLEASE PROVIDE FULL SOLUTION)

Write the ionic forms of the following elements and compute for the respective milliequivalent weight; 1.Iron= 57 g/mole; 2. Magnesium= 24 g/mole; 3. Potassium=39 g/mole; 4. Ammonium nitrogen= 15g/mole; and 5. Manganese = 54.9 g/mole. (PLEASE PROVIDE FULL SOLUTION)

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter11: Solutions

Section: Chapter Questions

Problem 9P

See similar textbooks

Related questions

Q: 4. Determine the volume of a gas at STP if: a. 450. mL is collected over water at 27.0°C and 770.…

Q: A healthful diet should have a distribution of macronutrients. In the following, match the caloric…

Q: c) Frequency vs. elnergy 3. When sodium is excited in a flame, two ultraviolet spectral lines at 2…

Q: Classify each of the following amines as primary, secondary or tertiary. NH2 CH3CHCH3 NH2…

Q: 4.A student dissolves 1.18g H2C204. 2H20 (MM= 126.07 g/mol) in water and titrates the solution with…

A: Given, H2C2O4 + 2NaOH ➝ Na2C2O4 + 2H2O mass of H2C2O4.2H2O = 1.18 g molar mass of H2C2O4.2H2O =…

Q: 71/2 0.032 kg mol1 (0.032 kg mol¯)(300 m s-1)2 ] exp -1 [27(8.3145 J K-1 mol)(300 K) 2(8.3145 J K-l…

Q: How many grams of H+ are needed to replace 1 g NH4+?

A: Given:: Mass of NH4+ = 1g molar mass of NH4+= 18 g mol-1 Grams of H+ = ? molar mass of H+=1 g mol-1…

Q: The molar solubility of MnCO3 is 4.2 × 10−6 M. What is Ksp for this compound?

A: Given-> Molar solubility = s = 4.2 × 10-6 M

Q: hv (i) Cp2TiMez +2 [RCH=CHR] (ii) [Cp*Ir"Cl,]2 (iii) NiCl2(PMe3)2+RMGC1

A: D(iii) NiCl2(PMe3)2 + RMgCl → ?

Q: Based on the phase diagram illustated below, what is the phase condition of the given two-component…

Q: Data: 14.60 cm Distance Travelled by HCI 9.00 ст Distance Travelled by NH) Observed ratio of…

A: Given: Distance travelled by HCl = 14.00 cm And distance travelled by NH3 = 21.00 cm

Q: A chemistry student weighs out 0.0874 g of sulfurous acid (H,SO), a diprotic acid, into a 250. mL…

A: Given-> Weight of sulfurous acid=0.0874g Volume of volumetric flask= 250 mL Concentration of…

Q: Fill in the blanks: (a) to (i): Determine whether each stereocenter marked by letters in red is R or…

A: Stereochemistry is branch of chemistry in which we deal with three dimensional arrangement of atoms…

Q: Balance each of the redox reactions for the conditions stated Label the oxidizing agent and the…

Q: Which substance is the primary standard used for the accurate determination of HCl titrant…

A: Which substance is the primary standard used for the accurate determination of HCl titrant…

Q: 9. For 2.AB+C→4+2BC, suppose AH= 100kJ, Ea = 250KJ, and that the intermediate is A+ C. Describe a…

A: To describe a potential energy process for the given reaction. 2 AB + C2 ---> A2 + 2 BC

Q: The addition of 8.00 g of a compound to 300 g of naphthalene lowered the freezing point of the…

Q: A reaction has AS >0 and AH> 0. Which statement about this reaction must be correct? (A) If carried…

A: Answer: This question is based on the basic prediction about a reaction when it is an endothermic…

Q: Question 19 In pure substance, at constant volume, pressure and temperature will dictate whether a…

Q: Provide an IUPAC name for the structure shown. H

A: 1. Select the principle carbon chain 2. Numbering 3. Naming (prefix + word root + suffix)

Q: Given the volume of 0.4810 M NaOH used determine the concentration of 19 ml sample each from…

A: Given that, The concentration of the NaOH is 0.4810 M. The volume of the aqueous layer and the…

Q: Which of the following phase diagrams corresponds to a system wherein boiling occurs before the two…

A: For the liquid-liquid phase diagram, the phase diagram that represents a system wherein boiling…

Q: Question 8 The colligative property is influence by the amount solute that are present. The amount…

Q: A phase is a physical property of which describes the distance of molecules of matter. Phase also…

A: The given statements are : Statement. 1 :- A phase is a physical property of which describes the…

Q: 1a.In which of the following substances does nitrogen exhibit the lowest oxidation number? A. NaNO2…

Q: Consider a solution consisting of 1.75 mol water and 0.97 mol ethanol. What is the entropy of…

A: Answer:- 14.7 J/k

Q: In a two-vessel technique titration set-up, what is the unknown substance if the volume of…

A: Indicator is an important factor for wnd point determination. On the Basis of different…

Q: A 50.0 mL of 0.100 M Cu(NO3) solution and a 50.0 mL of 0.100 M NaBr solution are mixed. If the Ksp…

A: Given, Molarity of Cu(NO3) = 0.100 M Volume of Cu(NO3) = 50.0 mL Molarity of NaBr = 0.100 M…

Q: Make 50 ml of the extraction buffer containing the following ingredients using the stock solution…

A: We need to make 50 mL of the extraction buffer.

Q: or A –→ products, time and concentration data were collected and plotted as shown. [A] (M) t (s)…

Q: In esterification reaction of isopentyl acetate, What is the purpose of the reflux setup in the…

A: Ans : In the Fischer esterification of acetic acid and isopentyl alcohol will give the isopentyl…

Q: (e) Write two synthetic strategies to Fischer carbene complex. Furnish the synthesis and application…

A: Well, Fischer carbene are the carbene which singlet carbene. Fischer carbene follows 18electron…

Q: Which of the following refers to the phase transition from liquid to vapor? Sublimation…

Q: F, E. B. Temp. (°C) 150 135 120 |D 105 06 75 C. 09 45 30 15 Heat (kJ) Created by E. Lee for Virtual…

A: Answer: Given curve represents pattern of the increase in temperature of the crystalline substance…

Q: How was the precipitate obtained after filtration? a. By drying the precipitate on the filter paper…

A: The precipitate is obtained by drying the precipitate on the filter paper using a desiccator.

Q: 13.25 Use the Nernst equation to calculate the cell potentials of the following cells at 298 K. (a)…

Q: 18. What is the equilibrium concentration of barium ions in a 1.0L solution of barium carbonate to…

A: Answer: For the saturated solution of sparingly soluble salt, its solubility product becomes equal…

Q: Liquid mercury has a density of 13.69 g cm-3, and solid mercury has a density of 14.690 g cm-3 both…

A: Given that, at -38.87°C and 1 bar pressure, The density of liquid mercury is dl = 13.69 g/cm3. The…

Q: C. Questions and Problems. Answer the following. 1. Write a rate expression for the disappearance of…

A: Rate law :- The equation or expression which gives the relationship between rate of reaction and…

Q: . For the reaction, SO2 (g) + O2 (g) ↔ SO3 (g). If the concentration of SO2 (g) is increased, the…

A: Le Chatelier's principle states that when concentration, pressure or temperature of an equilibrium…

Q: Calcium hydroxide topical solution is done by slaking Calcium Oxide. How much Cao (56 g/n) is needed…

Q: Do QUESTION (b) (i) early as possible I upvote

Q: (e) Write two synthetic strategies to Fischer carbene complex. Furnish the synthesis and application…

A: All the reactions are shown below.

Q: Which of the following phase diagrams corresponds to a system wherein the upper critical temperature…

A: The phase diagram corresponds to a system wherein the upper critical temperature is less the boiling…

Q: Write the equilibrium-constant expressions and obtain numerical values for each constant in the…

A: Here we are find the equilibrium constant expression for the basic dissociation of aniline and…

Q: 170.50 ml of 1.23 M organic salt was mixed with 236.23 ml of Ethanol (d= 0.789 g/mL, MW…

A: Given, Volume of the organic salt (solute) = 170.50 mL Molarity of organic salt = 1.23 M Volume…

Q: In an electrochemical cell, a metal anode lost 0.190 g while a total volume of 0.04507 L of hydrogen…

Q: 3. Convert the following perspective drawing into Newman projections by looking along the bond as…

A: Note : Put dashed bonds left side on Newmann projection. Put wedge bonds right side on Newmann…

Q: Which practice is NOT used to gauge accuracy? raw data and results from calibration checks B.…

A: Correct option is (e) sample rejection .

Q: Assuming 100% of the sugars are hydrolyzed/isomerized into glucose, and that 100% of the glucose is…

Concept explainers

Solutions

Solutions can be considered as homogeneous mixtures which contain two or more than two chemical substances. The chemical substance which is the greater part is defined as solvent. And the chemical substance that is dissolved in a solvent is referred to as solute. Solution chemistry plays an important role in chemistry since it supports many commercial applications of solutions.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Mixtures of gases are always true solutions. True or false? Explain why.
Calculate the mass of dissolvednitrogen at 25°C in an aquariumcontaining 64.7 L of water. Assume thetotal pressure is 97.8 kPa and the molefraction of nitrogen in air is 0.78.Recall that the partial pressure ofa gas in a gas mixture can bedetermined from the full pressure andits mole fraction (Henry's law, Dalton'slaw).
DON’T ROUND OFF ANY COMPUTATIO UNTIL TO THE FINAL ASWER. (OR AT LEAST USE 4 DECIMAL PLACES) USE: GIVE, REQUIRED, SOLUTION FORMAT) Determine the percentages of each element in benzoic acid in terms of: 1. percent by weight b. the mole percentage.
Complete the table by computing Volume HClused, Normality of HCl and Average normality of HCl. The given are written in the photo attached. Kindly include the complete solution.
A gas mixture of 2.31 g NH3, 31.2 g N2, and 0.58 g mol of H2O vapor is contained at a total pressure of 89. mmHg and 336 K. assuming ideal gas behavior.Solve for; a. volume percent composition of the mixtureb. partial pressure of each componentc. total volume of the mixture just solution
A sulfuric acid solution containing 572g of sulfuric acid per liter of solution has a density of 1.33g/mL. Calculate the its mole fraction.
what is the correct volume of 2.5M PhMgBr in THF is needed to completely react with 1.5ml of methyl benzoate?you do not need to consider and excess and should calculate (and choose) the minimum amount as required by the reaction stoichiometry Enter your answer to one decimal place with the proper unit of measurement.
Calculate the concentration of of CO2 gas in water at 25 oC and standared conditions. Assuming that the water is saturated with air that contains several gases among them is 350 ppm of CO2. The Henry’s law constant for CO2 is: KH = 3.40 x 10-2 mol/L-atm. Express the results in molarity, moles/L?
State Henry’s law and mention two of its important applications.
For letter b, mass percent of water is to be computed. Will you be able to resolve this part? These are the questions to be determined. b.) - mass of solute = ? g - mass of solvent = ? g - mass percent of water = ? %
Determine the number of moles in water (H2O) Given 591ml of refresing water.
Please for image attached do Molarity of NaOH and Show: (A) Sample calculation of NaH molarity. (B) Calculation of average NaH molarity, and its relative range. Mass of NaOH used is 39.997 g/mol