You were asked to prepare (a) poly(2-hexene) and (b) acrylonitrile Draw the reactants and products. What initiator (cationic or anionic) would you choose for each of them? Explain your answer!

Q: Determine the chemical formula of a compound that contains 56.6% K, 8.69% C and 34.7% O. Write any…

A:

Q: Ksp for CaSO4 is 2.4x10^-5.  Calculate the molar solubility of calcium sulfate

A:

Q: Q1/ Draw the smoothing curve resulting from the reaction of 10 milliliters of sodium hydroxide of…

A:

Q: A cell is prepared by dipping a copper rod in 0.01 M CuSO4 solution and zinc rod in 0.02 M of ZnSO4…

A: Given :  E°Zn+2/Zn  = -0.76 V  E°Cu+2/Cu = 0.34 V  [CuSO4] = 0.01 M  [ZnSO4] = 0.02 M

Q: Key Point #3 What is the Law of Conservation of Energy and how was it applied in your calorimetry…

A: Calorimeter is the instrument that is used to calculate experimentally the amount of heat absorbed…

Q: In the experiment on "Chemical Equilibrium and Le Chatelier's Principle", what complex ion is…

A:

Q: Writing Empirical Formulas from Chemical Formulas

A:

Q: 0.2963 g of copper was deposited at the cathode after undergoing an electrolysis reaction. The…

A:

Q: 5. For 2C3H6 +9026CO₂ + 6H₂O, if the rate of production of CO₂ is 0.40 mol/L*s, the rate of…

A:

Q: The rate of a chemical reaction is NOT affected by which of the following: O temperature O…

A:

Q: Draw the structure of the hypothetical molecule that has a chemical formula of JX4 Note: • J does…

A: Given,  The valence electrons of J = 6 and X = 7 The structure of hypothetical molecule of JX4 is:

Q: Identify the conjugate acid-base pairs in the following reaction: HCO3 - (aq) + H2O(l) ⇌ CO3 2- (aq)…

A:

Q: Your answer is partially correct. A laboratory technician wants to determine the aspirin content of…

A: Given, The Ka= 3.0×10-4 Concentration = 10-5M

Q: Write the chemical formula and indicate the physical state of the barium chromate (aq) + products.…

A: Write the chemical formula and physical state of the given reactant -->

Q: Dilution: 1.How many mL of 6 M solution should be diluted to 200 mL to make a 1.5 M soln? 2. To…

A:

Q: (3.9) How many grams of hydrogen are present in 255 mL of propane at room temperature? The density…

A: Hydrocarbon are the organic compounds made up of carbon and hydrogen.  There are aliphatic and…

Q: Fluorescence occurs within (a) none of the above (b) 10-5 s (c) 10-5 ms (d) 10-5 ns

A: In fluorescence matters absorbs light energy at at lower wavelength (higher energy) and emits light…

Q: Q1) A closed system of 2.0 moles of an ideal gas where Cv.m = 1.5R and Cp.m = 2.5R at an initial…

A:

Q: 38. Magnesium chloride (MgCl2) is the product of a reaction between magnesium (Mg) and chlorine…

A: The reaction of metal with halogen will form metal halides.  For group two elements, as they have +2…

Q: Copper wire which has an area of 2.9 x 104 m² is pulled in tension with 44,500 N force, producing…

A:

Q: ◆ What is the role of phosphoric acid in the synthesis of acetylsalicylic acid? (Use equations to…

A: Acetylsalicylic acid is also known as aspirin. In the aspirin synthesis, we need a protic acid to…

Q: 2. How do you accomplish the following synthesis? Page 9 of 11 Lo

A: In this question, we will synthesized the final organic product from the given starting material.…

Q: Q\3: Oxygen gas produced from the reaction below was collected above the water at 30 Cº and in a…

A: Given :  Temperature = 30°C = 303 K  Volume of O2 = 150 cm3  Since 1 cm3 = 10-6 m3  => Volume of…

Q: 5. The instantaneous rate of consumption of N:O is -4.2 x 107 mol/L's at the start of the following…

A: For a reaction      wA +xB= yC +zD where  A, B are reactants and C and D are products. w, x, y and z…

Q: My gold ring looks dull. I asked the goldsmith to make it shine and new again. The goldsmith will do…

A: Electroplating is a process of depositing a metal into the surface of a different metal. During…

Q: What is the systematic name of the following compound? Pentanone Hexanal Hexanone Pentanal QUESTION…

A: In the given question one approch chemical name and other approach functional group in them--

Q: Identify the unknown particles (AZX) in the equations below. Show your work and mention the names of…

A:

Q: Consider the following reaction: HBrO (aq) + H2O (l) ⇋ H3O+ (aq) + BrO- (aq) If the value of Kc for…

A:

Q: 10. For the reaction A + B → C + D, which diagram below would best represent the rate of formation…

A:

Q: Increasing the temperature will increase the kinetic energy of particles, therefore increasing the…

A:

Q: Calculate the number of protons and neutrons in 100In

A: The number or protons and neutrons can be determined by the atomic number and mass number. It can be…

Q: 8. Sketch an Energy Level Diagram with activation energy (Ea) OR a Maxwell-Boltzmann distribution.…

A: The explanation is given below-

Q: TABLE 3. PERCENT YIELD Mass salicylic acid Mass of synthesized aspirin Theoretical Yield (aspirin)…

A:

Q: c) Imagine that the high-strength metal casing housing the nuclear reactor had a failure strength of…

A: In this question we will find out minimum amount of zirconium available in nuclear reactor to cause…

Q: Draw the structure of the hypothetical molecule that has a chemical formula of JX4 Note: • J does…

A: Given,  The structure of the hypothetical molecule JX4 is: The valence electrons of J = 6 and X = 7.…

Q: Deduce the structure of compound A C9H1002 , Amax= 253 cm-1 , IR bands,3035, 2960, 2870, 1680, 1610,…

A:

Q: Draw the structure of the hypothetical molecule that has a chemical formula of JX4 Note: • J does…

A: Valence electron of J=6,that indicates the element must 16 group element such as O,S ,Se,Te,Po. And…

Q: how to work out the shape of a molecule? write the rules

A: The rules are :-  VSEPR Rules:-  i) Identify the central atom. ii) Count its valence electrons. iii)…

Q: How many molecules are in a 0.921 mol sample of ethane?

A: Given,  Moles of ethane = 0.921 mol.  The number of molecules in 0.921 mole of ethane is:

Q: ASAP How many moles of Aluminum are produced by decomposing molten Al2O3 in 1.05 hours when the…

A:

Q: Draw the schematic or plant layout. Draw the T-s diagram A reheat cycle with two stages of…

A: The explanation is given below-

Q: 2. The combustion of glucose is given by, C6H1206(s) + 602(g) The amount of heat involved in burning…

A: Reaction equation of combustion of glucose is C6H12O6 (s) + 602(g) -->  6CO2(g) + 6H2O(l) ∆H=…

Q: Given the tabulated data, what is the lattice energy of crystalline calcium chloride? heat of…

A: Given, the tabulated data, what is the lattice energy of crystalline calcium chloride?heat of…

Q: 6. On the image below, label the structures below (image is in color-view it online). "Not present"…

A: Since you have posted a question with multiple sub parts we will answer the first three for you. To…

Q: Calculate the value of K for the following reaction if the equilibrium concentrations are: [CO2] =…

A:

Q: Among the following samples of water, which contains the highes K carbonate hardness? O oxygenated…

A: Given in following question  which water highest carbonate hardness

Q: Reduction half Reaction (Reducitur potentiatu) Cu2+ caa) + 25 → (4 (5) 0.34 Ni (aq) + 2e → Ni(s)…

A:

Q: Which equilibrium system will show an increase in product formation when the volume is decreased? A.…

A: Le Chatelier's principle: According to the Le Chatelier's principle when a change in concentration…

Q: 35. What do you call the minimum amount of energy needed to start a chemical reaction? A. Bond…

A: We are authorised to solve only one question at a time. Please post rest of the questions…

Q: of the following questions A. What is the lack in using composite materials in automotive? B. What…

A: Composite materials are used widely in automotive industries.This composite materials are lighter,…

Polymers

Polymers are naturally occurring or synthetically produced large molecules or compounds which are made up of series of repeating units called monomers. They are joined together by chemical bonds. The term polymer is coined from Greek roots meaning 'many parts' and are found almost everywhere from the plastics bags to the rubber of our tires to our DNA strands.