The firing lines on an oscilloscope pattern are all abnormally low. Technician A says that the problem is probably low coil output. Technician B says that the problem could be an overly lean air-fuel mixture. Who is correct? Select one: a. Technician A b. Technician B c. Both A and B d. Neither A nor B

The firing lines on an oscilloscope pattern are all abnormally low. Technician A says that the problem is probably low coil output. Technician B says that the problem could be an overly lean air-fuel mixture. Who is correct? Select one: a. Technician A b. Technician B c. Both A and B d. Neither A nor B

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter8: Preventive Maintenance And Basic Services

Section: Chapter Questions

Problem 8RQ: Technician A says that if a drive belt does not have the proper tension, it may produce squealing...

See similar textbooks

Similar questions

Describe briefly the ways that knowledge of equal loudness contours can help you balance a mix.
While discussing secondary voltage: Technician A says that the normal required secondary voltage is higher at idle speed than at wide open throttle conditions. Technician B says that the maximum available secondary voltage must always exceed the normally required secondary voltage. Who is correct?
While discussing ignition timing requirements: Technician A says that more advanced timing is desired when the engine is under a heavy load. Technician B says that more advanced timing is desired when the engine is running at high engine speeds. Who is correct?
Explain with details (a) Exhaust gas recirculation (b) Charge cooling.
An engine starts and runs briefly after a small quantity of fuel is put into the spark plug hole, but it doesn't not start when fuel is added to the carburetor throat. Tech a says that the problem may be that the exhaust valve is not closing completely due to carbon buildup. Tech b says it may be due to a defective carburetor mounting gasket. Who is correct?
What does a slope in the spark line represent? a. Low secondary resistance b. High resistance in the primary circuit c. An incorrect air-fuel mixture d. High resistance in both the primary and secondary circuit
Consider the following statements relevant to the ignition system of SI engine: 1. Too small a dwell angle will lead to the burning of condenser and contact points. 2. Too small a dwell angle will result in misfiring. 3. Too large a dwell angle will result in burning of condenser and contact points. 4. Too large a dwell will result in mistiring. Which of these statements are correct?
How can you use a dual trace scope to make sure that the injectors are firing at the correct time?
What is meant by sequential firing of fuel injectors?
Which of the following will cause one or more, but not all, firing lines to be higher than normal? a. High resistance in the spark plug wire b. Faulty fuel injector c. Defective spark plug d. All of the above
1) What is the effect if it occurs error data reading on Throttle Position Sensors? 2) What are the effects of accelerating and slow ignition timing?
While discussing quick-disconnect fuel line fittings: Technician A says that on some hand-releasable, quick-disconnect fittings, the fitting may be removed by pulling on the fuel line. Technician B says that some hand-releasable, quick-disconnect fittings may be disconnected by twisting the large connector collar in both directions and pulling on the connector. Who is correct?