Question
Asked Dec 8, 2019
32 views

While discussing valve body assemblies in late-model transmissions: Technician A says that the valve body is no longer needed in some electronically controlled transmissions. Technician B says that an EPC solenoid maintains constant fluid pressure through the valve body regardless of the vehicle’s operating condition. Who is correct?

check_circle

Expert Answer

Step 1

Automatic transmission valve body is a major part of a vehicle’s automatic transmission system. It consists of number of small valves, which control the fluid flow. The body directs the pressurized transmission fluid to the network of valves which packs the clutch appropriately, a...

Want to see the full answer?

See Solution

Check out a sample Q&A here.

Want to see this answer and more?

Solutions are written by subject experts who are available 24/7. Questions are typically answered within 1 hour.*

See Solution
*Response times may vary by subject and question.
Tagged in

Engineering

Mechanical Engineering

Other

Related Mechanical Engineering Q&A

Find answers to questions asked by student like you
Show more Q&A
add
question_answer

Q: Given 603.06 kW electrical power supplied to a boiler when the temperature of the entering water is ...

A: On the basis of entropy and enthaly table, 

question_answer

Q: The hammer consists of a cast iron head and wood handle. The iron head has 7000 kg/m3 density, and i...

A: Calculating mass,

question_answer

Q: I need parts 1, 2, and 3, answered pertaining to the print and instructions.

A: (1). The name of the circuit is HYDRAULIC CIRCUIT FOR 90 TON COMPACTION PRESS.

question_answer

Q: I need answers to this part, thank you.

A: The details of common roughness height values with a surface description are,

question_answer

Q: M4.24 (Sl units) Aluminum has a density of 2.70 g/cm2 at room temperature (20°C). Determine its dens...

A: Given data as per question

question_answer

Q: I need answers to questions 10, 11, and 12 pertaining to the print provided.

A: 10.Yes, it's a drawing constructed of several parts. This diagram shows the mounting of two metal pa...

question_answer

Q: M5.19 (Sl units) A GO/NO-GO plug gage will be designed to inspect a 50.00 0.20mm diameter hole. Awea...

A: Calculate the tolerance band.

question_answer

Q: I need parts 3 and 4 answered pertaining to the print provided.  I asked this question previously on...

A: (3) In the empty space of revision A9 a general note 3.6 is added stated that the revised geometric ...

question_answer

Q: Five Kg of water contained in a piston-cylinder assembly expands from an initial state where T1 = 40...

A: Consider the expression of the entropy change for the system,