ITM 301 inclass note

Q12: CSMA/CD is a protocol used in what Data Link Layer protocol? a. Polling b. Token Passing bus c. Token Passing ring d. Ethernet e. TDMA f. FDMA g. CDMA h. None of the above

i need clear ans and solve very very fast in 20 min and thank you | ᴅʏʙᴀʟᴀ ?✨؛

middle 4 digit            letter    7 segment output           5206             EhJ             EhJ5206   print that specific combination using one  7 segment display in a serial. the following should be included in the report. 1-- truth table 2--circuit  =>general sop and pos =>simplified sop and pos =>using nand and nor gate =>using decoder  =>using multiplexer   3-- conclusion and discussion

Question 9 only

Write the VHDL code that will implement this function. Please respect the VHDL syntax and upload your answer to Dropbox A EQ B

Hi! I need help with question 1.b

What digital component is implemented in the following VHDL code? What is the role of Process statement in this VHDL code? Explain in detail.   LIBRARY ieee; USE ieee.std_logic_1164.all;   ENTITY test3 IS    PORT (D, Clock : IN STD_LOGIC ;      Q : OUT STD_LOGIC ) ; END test3 ;   ARCHITECTURE Behavior OF test3 IS       BEGIN      PROCESS    BEGIN       WAIT UNTIL Clock'EVENT AND Clock = '1' ; Q <= D ;    END PROCESS ;   END Behavior ;   G. Complete the following VHDL code to implement a 2-to-4 binary decoder with an enable input.   LIBRARY ieee ; USE ieee.std_logic_1164.all ;   ENTITY dec2to4 IS PORT (w : IN STD_LOGIC_VECTOR(1 DOWNTO 0) ; En : IN STD_LOGIC ; y : OUT STD_LOGIC_VECTOR(0 TO 3) ) ; END dec2to4 ;   ARCHITECTURE Behavior OF dec2to4 IS SIGNAL Enw : STD_LOGIC_VECTOR(2 DOWNTO 0) ; BEGIN Enw <= En & w ; WITH Enw SELECT     END Behavior ;

Given that the base address is FoH. 1. Create a new asm project “Lab2_Q1.asm". Assume that port A of 8255A PPI is connected to 8085. Write assembly code to send the value of FFH to FoH. Enter a delay of 2 ms for each transmission.

Please be accurate otherwise I will lose my marks!!!!!!!

B/Select the correct answer: 1) The basic structures in VHDL contain a) Entity b) Architecture The com IVIUE NJIHOVIO. c) Library d) All of them nea 3) VHDL is a design language. a) Software b) Hardware c) Software and Hardware d) Not all is mentioned

Q3 /mention (3) main differences between TCP/IP AND OSI MODEL?

Q31)The bit rate for American PCM-24 system is a. 2.048 Mb/s b. 1.544 Mb/s c. 8 kb/s d. 64 kb/s   This multiple choice question from DIGITAL COMMUNICATIONS course.just write for me the final answer.

A. Registers MODE, PUCR, RDRIV, PTA, DDRA, DDRB have the values $80, $02, $01, $FB, $FF, and $00 respectively. Answer the following:• What is the HCS12 operational mode?• What is the value on port A pins?• What is the value of PTB register?• How to configure the HCS12 to work in

ir I need the solution step by step and clear line please Example Assuming that a 3-bit ADC channel accepts analog input ranging from 0 to 5volts, determine a- The number of quatization levels b- The step size of the quantizer or resolution. c- The quantization level when the analog voltage is 3.2 volts. d- The binary code produced by the ADC. e- The quatization error when the analog voltage is 3.2 volts.

EEE

A. Construct a 4 X 16 decoder with an enable input using five 2 X 4 decoders with enable input. (Use block diagram)

1) Compare between the Serial and Parallel ports from the following points of view 1- The length of the cable 3- Speed of transmission 2) For the AT89C51 programmer: 2- The maximum output swing 4- Number of internal registers What is the total number of pins?, How many ports are there? How many bits does each port have? 3) What is the number of input pins and output pins for the game port? 4) In the address decoder circuit, what are exactly the address lines that should be used as the inputs of the decoder that generates CS signals for twenty input/output devices, each of them contain 5 internal registers? 5) There are the parallel port. inverted bits in the status register and inverted bits in the control register of -

Please draw the the circuit as well in the explanation and not only words/steps to construct and PLEASE DON'T POST ANY CHAT GPT ANSWERS.

(a)A typical TTL IC is numbered as DM54AS04N.Explain the meaning of each portion of this number?- (b) What are types of scale of integration? Briefly explain VLSI?( (c)Draw the diagram of Monostable Multivibrator using 555 timer? -

This is a single question. Can yo send the solution.

true or false

Question is under attachment.