EET-115 Lab 1 - Terminating Non-Metallic Sheathed Cable

write down the slection of wiring accessories used in electrical installation

3. The three bus-bar conductors in an outdoor sub-station are supplied by units ofpost insulators. Each unit consists of a stack of 3-pin insulators fixed one on the top of the other. The voltage across the lowest insulator is 8-45 kV and that across the next is 7-25 kV. Find the bus-bar voltage of the station. [38-8 kV]

subject : Electrical engineering

The term "____" is defined in NEC® Article 100 as "connected to establish electrical continuity and conductivity." Select one: A. BENDED (BENDING) B. BONDED (BONDING) C. SHUNTED (SHUNTING) D. GROUNDED (GROUNDING)

Please answer in typing format solution

i need the answer quickly

7.B. The size of a grounding electrode conductor for a service or separately derived system is generally basedon the size of the largestA. ungrounded supply conductor.B. equipment grounding conductor.C. grounded electrode.D. bonding jumper.7.C. Which of the following statements about bonding is true?A. The joint or termination must offer opposition in the circuit for effective electrical connections.B. Effective bonding keeps impedance high if a fault should occur.C. The entire electrical safety circuit is only as good as its strongest bonded link.D. Bonding connections must endure high levels of fault current until overcurrent protective devices can operate.

Why ACSR Conductors are preferred over Copper Conductors? Note please don’t handwringing.

15. What does a grounding symbol on a construction drawing convey?A. A single ground rodB. A grounding electrode systemC. A ground-fault current pathD. An equipment grounding conductor

Discuss the types of oil circuit breakers. Please write more answer

Name and explain the process to join any electrical component on strip board

Building Service Subject

Grounding lighting fixtures. Threre are specific requirements for grounding lighting fixtures. How must they be grounded and with what size conductors?

1. What is mean by equipment grounding and system grounding? 2. Discuss any two types of grounding methods.

8.a. A _______ conductor does not carry current during normal operation.A. neutralB. groundingC. phaseD. grounded8.b. "The complete path of an electric current" describes an electric(al)A. fault.B. circuit.C. source.D. component.

Discuss the concept of an Electrical fault. How can we prevent such catastrophic incidentfor such fault in an electrical system?

Question.

The protection against direct lightning strokes and high voltage steep waves is provided by a. Earthing of neutral b. Lightning arresters and ground wires c. Lightning arresters d. Ground wires

Differentiate the mechanism of electrical breakdown thet occurs in liquid and solid insulation.

Estimate the length of conduit to perform the next bends. EMT will be bend using a hand bender. Provide your answer in inches (just the number) using up to 2 decimals. The picture shows two panels connected by a back-to-back 23.5" stubs EMT 3/4" 6.25 ft P

13. Which of the following is a method for identifying a grounding terminal for connecting an equipmentgrounding conductor to a device?A. The letters EGCB. A green octagonal nutC. A red pressure wire connectorD. A green screw with a hexagon head

Airframe Electrical System Question: By what means should aircraft electrical circuits/wires be protected from excessive current? (Source: FAA AC 43.13-1B/2B)

Four No. 12 and four No. 10 conductors are to be installed in a EMT conduit 600 V jacketed. What size EMT conduit is required if a. The conductors are Type T90 Nylon? b. The conductors are Type RW90?

Need help with second question if all that would be helpgul