02_HW_EEE598
.docx
keyboard_arrow_up
School
Arizona State University *
*We aren’t endorsed by this school
Course
598
Subject
Electrical Engineering
Date
Apr 3, 2024
Type
docx
Pages
2
Uploaded by UltraInternet11400
Homework 02
EEE 598 – Electric Energy Markets Professor Kory W. Hedman
Homework 2: Due by 5pm AZ time, Tuesday, January 30. Price Takers: 1) 30 Points
There are two firms (producers) in the market and they are price takers. Total Cost Function
for firm 1: 0.3(Q
1
)
2
+ 30Q
1
+ 150
Total Cost Function
for firm 2: 0.25(Q
2
)
2
+ 40Q
2
+ 100
Each firm has a minimum capacity of 0 but no maximum capacity; note that Q stands for quantity and P below stands for price. Note that, if the unit is not producing anything, it does not incur the fixed cost (no-load cost) term.
The inverse demand curve for the market is: P = 400 – 0.9Q = 400 – 0.9(Q
1
+ Q
2
). a) What is the inverse supply curve for the entire market? When calculating this curve, make sure you account for the minimum capacity of the firms. If the price is too low, firms produce nothing, not a negative quantity. (note that you may have a non-smooth curve). Draw it.
b) What is the market clearing price for this market? What is the market quantity?
c) Calculate the Consumer Surplus (CS), the Producer Surplus (PS), and the Social Welfare (SW).
Monopoly:
2) 35 Points
Take the information from problem 1 above. Assume that these two firms now act as a monopoly (a single entity owns both units and acts as a monopoly in this market). You can assume that both units will produce.
a) What is the marginal revenue? Draw the marginal cost curve (supply curve), the demand curve, and the marginal revenue curve. b) What is the market clearing price for this market with this monopoly? What is the market quantity? Does the resulting marginal revenue equal marginal cost? c) Calculate the Consumer Surplus (CS), the Producer Surplus (PS), the Social Welfare (SW), and the Deadweight loss. Label these on your drawing from part (a) above. Page 1 of 2
Homework 02
Cournot Equilibrium:
3) 35 Points
Take the information from problem 1 above. Assume that these two firms now act based on the Cournot model. Each firm has complete information (knows the other firm’s cost curve and they know the demand curve). You can assume that both firms will be producing.
a) Calculate and write down the best response function for each firm.
b) What is the market clearing price for this market with this Cournot competition between these two firms? What is the market quantity?
c) Calculate the Consumer Surplus (CS), the Producer Surplus (PS), the Social Welfare (SW), and the Deadweight loss. Compare and comment on these values as compared to the values for problems 1 and 2.
Page 2 of 2
Your preview ends here
Eager to read complete document? Join bartleby learn and gain access to the full version
- Access to all documents
- Unlimited textbook solutions
- 24/7 expert homework help
Related Questions
The efficiency of any real wind turbine
O a. can be more than 59.3%
O b. can be less than 59.3%
O c. is nearly 100%
O d. is always equal to 59.3%
arrow_forward
Draw the circuit diagram of Two quadrant chopper which is having average load voltage might be positive or negative. Explain each quadrant operation with neat sketch. I want more than 350 words and I do not want it in handwriting
arrow_forward
Electrical Engineering subject
arrow_forward
Please help will like
arrow_forward
8- The annual fixed costs for a plant are $100,000, and the variable costs are
$140,000 at 70% utilization of available capacity, with net sales of $280,000.
What is the breakeven point in units of production if the selling price per
unit is $40?
9- A plant has capacity of 4100 hydraulic pumps per month. The fixed cost is
$504000 per month. The variable cost is $166 per pump, and sales price is
arrow_forward
Choose which answers are correct
What is the unit of slope of a Fuel cost curve ? a . $ / MWh
b . $ /h
c. $ /Tones
d . MW
arrow_forward
B) The probability that it is Friday and that a student is absent is 0.03. Since there are 5
school days in a weck, the probability that it is Friday is 0.2. What is the probability that a
student is absent given that today is Friday?
arrow_forward
seven coins are tossed simultaneously. Find the probability that they will have just three heads (in fraction form)
answer asap please
arrow_forward
Identify the settling time of a meter.
a. Time taken by output to reach final constant value from Zero value
O b. Time taken by output to reach 95% of value from 10%
c. Time taken to settle inside 2% of the final value
O d. None of the options
arrow_forward
q7/
Complete the blank
...................................................tariff is used when rate per unit of energy consumed is based on fixed charge, semi fixed charge and running charges.
arrow_forward
Please help
arrow_forward
Select in descending order based on percentage the primary energy use of the world
O a. petroleum, gas, coal and other
O b. gas, petroleum, coal and other
O c. coal, petroleum, gas and other
O d. coal, petroleum, gas and other
arrow_forward
Please please answer the question
I want more information about digital wattmeter
Identify, how to work, advantage and disadvantage....like that
arrow_forward
Assume the maximum amount of power a plant can generate is 10,000 MW. For half the year it generates 8,990 MW of power, for a quarter of the year it generates 8,600 MW of power, for 15% of the year it generates 5,000 MW, and for 5% of the year it generates 2,500 MW. For the remainder of the year, the plant is not operating. What is the capacity factor of the plant for the year?
arrow_forward
The data for a wind turbine is given below:
Wind speed = 14 meters/sec, Length of blade = 10 meter
Choose the correct statement for this wind turbine.
a.
The input wind power to the turbine is 517KW
b.
The input wind power to the turbine is 258 KW
c.
The input wind power to the turbine is 25.8KW
d.
The input wind power to the turbine is 51.7KW
arrow_forward
In a PWM, how do we calculate duty cycle?
arrow_forward
Betz limit applies to
O a. solar cells
O b. heat engines
C. wind turbines
O d. generator
arrow_forward
Solve for the ff
1. Current in every resistance
2. Voltage drop in every resistance
3. Total power of the ckt
arrow_forward
A 6 ampere supply has a frequency of 25 Hz. Find the instantaneous value of current
a. at 0.00986sec from zero going to the positive direction.
b. at 0.00986 sec from zero going to the negative direction.
c. at 986 degrees.
Show complete solutions.
arrow_forward
Hydro
3.10%
DIST, 0.1%
HYD, 14.8%
Solar
Others
0.60%
0.10%
Gas
COAL, 26.3%
GAS, 58.8%
42.30%
Coal
53.90%
TNB Generation Fuel Mix FY 2009
TNB Generation Fuel Mix FY 2019
Figure 1
TNB Generation Fuel Mix for 2009 and 2019
arrow_forward
The levelised cost of electricity (LCOE) is often used to
compare the costs of electricity production from different
types of electricity generation plant. Carefully describe the
significance of the LCOE and give one advantage and one
disadvantage of using this metric to compare plants.
arrow_forward
3. State the number of significant figures in each of the following: (a)
542, (b) 0.65, (c) 27.25, (d) 0.00005, (e) 40 x 10°, (f) 20,000.
arrow_forward
The below table shows all the combinations considered when solving a unit commitment problem involving 3 thermal units, along with each unit's cost (in $/h)
obtained when solving the economic dispatch for each combination.
Unit 1
Off
Off
Off
Off
On
On
On
On
Unit 2
Off
Off
On
On
Off
Off
On
On
Unit 3
Off
On
Off
On
Off
On
Off
On
F₁ ($/h) F₂ ($/h) F3 ($/h)
infeasible infeasible infeasible
infeasible infeasible infeasible
infeasible infeasible infeasible
1,753
0
3,855
5,484
0
0
5,006
0
681
3,125
2,535
0
2,882
2,339
681
Which one of the below combinations is the solution of the unit commitment problem?
Select one:
O a. None of these
O b. Unit 1: ON, Unit 2: OFF, Unit 3: ON
O
c. Unit 1: ON, Unit 2: ON, Unit 3: OFF
d. Unit 1: ON, Unit 2: OFF, Unit 3: OFF
arrow_forward
QUESTION 1
(a)
Table Q1(a) is given. Calculate the precision of the 9th measurement. The actual value
for 9th resistor is 2000 Q. Calculate the absolute error, percentage error and percentage
els come t
what
accuracy for 9ª measurement.
Table
Q1(a)
Resistor
Measurement (N)
1
2002
2010
3
1987
+6d 72
4
2007
5
1999
for
pary mot work
6.
1993
17209
7
1997
8.
2008
2010
10
2001
11
1995
12
1991
(b)
A DC source is connected in series with a resistor. A ±1% full scale accuracy
voltmeter with range of 150 V and ±1.5% full scale accuracy ammeter with range of
100 mA ammeter are used to measure voltage and current in a circuit. The voltmeter
and ammeter reading is 80 V and 70 mA respectively. Calculate the limiting error of
the
power. Determine the power dissipated and the absolute error.
arrow_forward
Define conventional energy resources. Name any one of them and mention its disadvantage.
A-
B
arrow_forward
q20) please need correct answer fast and short
make it clear
arrow_forward
Find the upper limit (in ohms)for the
:give color code
Grey Blue Red Gold
اخترأحد الخيارات
a. 9.030K
b. None of these
c. 9030K
d. 8500
arrow_forward
Q1. Draw flowchart to find the average of 10 positive numbers.
[Hint: Read the number in a loop, add them if it is positive and then find average]
Q2. Draw flowchart to read 5 numbers from a user and then find the second largest
number of them.
arrow_forward
Marked out of 1.50
P Flag question
13. i) The data for a wind turbine is given below:
Wind speed = 14 meters/sec, Length of blade = 10
meter.
Choose the correct statement for this wind turbine.
a. The input wind power to the turbine is 258 KW
b. The input wind power to the turbine is 51.7KW
c. The input wind power to the turbine is 25.8KW
d. The input wind power to the turbine is 517KW
13. ii) Refer to the above wind turbine choose the
correct statement
a. The wind rotor swept area is 40square meters.
b. The wind rotor swept area is 62.4 square meters.
c. The wind rotor swept area is 314 square meters.
d. The wind rotor swept area is 31.4 square meters.
O O
O O
arrow_forward
The indication of a lagged demand meter approaches the value of the actual load at a rate which is proportional to
A. Quotient of the load and the meter indication.
B. product of the load and the meter indication
C. Difference between the load and the meter indication
D. sum of the load and the meter indication
arrow_forward
SEE MORE QUESTIONS
Recommended textbooks for you
Electricity for Refrigeration, Heating, and Air C...
Mechanical Engineering
ISBN:9781337399128
Author:Russell E. Smith
Publisher:Cengage Learning
Related Questions
- The efficiency of any real wind turbine O a. can be more than 59.3% O b. can be less than 59.3% O c. is nearly 100% O d. is always equal to 59.3%arrow_forwardDraw the circuit diagram of Two quadrant chopper which is having average load voltage might be positive or negative. Explain each quadrant operation with neat sketch. I want more than 350 words and I do not want it in handwritingarrow_forwardElectrical Engineering subjectarrow_forward
- Please help will likearrow_forward8- The annual fixed costs for a plant are $100,000, and the variable costs are $140,000 at 70% utilization of available capacity, with net sales of $280,000. What is the breakeven point in units of production if the selling price per unit is $40? 9- A plant has capacity of 4100 hydraulic pumps per month. The fixed cost is $504000 per month. The variable cost is $166 per pump, and sales price isarrow_forwardChoose which answers are correct What is the unit of slope of a Fuel cost curve ? a . $ / MWh b . $ /h c. $ /Tones d . MWarrow_forward
- B) The probability that it is Friday and that a student is absent is 0.03. Since there are 5 school days in a weck, the probability that it is Friday is 0.2. What is the probability that a student is absent given that today is Friday?arrow_forwardseven coins are tossed simultaneously. Find the probability that they will have just three heads (in fraction form) answer asap pleasearrow_forwardIdentify the settling time of a meter. a. Time taken by output to reach final constant value from Zero value O b. Time taken by output to reach 95% of value from 10% c. Time taken to settle inside 2% of the final value O d. None of the optionsarrow_forward
- q7/ Complete the blank ...................................................tariff is used when rate per unit of energy consumed is based on fixed charge, semi fixed charge and running charges.arrow_forwardPlease helparrow_forwardSelect in descending order based on percentage the primary energy use of the world O a. petroleum, gas, coal and other O b. gas, petroleum, coal and other O c. coal, petroleum, gas and other O d. coal, petroleum, gas and otherarrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Electricity for Refrigeration, Heating, and Air C...Mechanical EngineeringISBN:9781337399128Author:Russell E. SmithPublisher:Cengage Learning
Electricity for Refrigeration, Heating, and Air C...
Mechanical Engineering
ISBN:9781337399128
Author:Russell E. Smith
Publisher:Cengage Learning