Topic 11 Quick Check OPS_330T

The system having ±0.5% of F.S.D if the full scale deflection is 50 units, then accuracy is _____ a. ±0.25 b. ±1 c. ±0 d. ±0.5

Schedule of Loads and Basic Calculation — Create a tabulated load schedule of your home.

QUESTION 3 a) b) Briefly describe the following terms for a generic second order instrument response. i. time constant (T) ii. rise time (Tr) iii. settling time (Ts) iv. peak time (Tp) Indicate the following characteristics on the generic second order response given in Figure Q3(b). i. Rise Time ii. iii. iv. Settling Time Min Settling Time Max Settling Time V. Overshoot vi. Undershoot vii. Maximum peak viii. Peak Time Amplitude 4 3.5 3 2.5 1.5 1 0.5 0 0 5 Step Response 10 Time (seconds) Figure Q3(b) 15 20 25

Can you solve in detail? Other wise ready for Downvote. And not give copy paste other or online platform. explain type of electronic material in detail.

For the following activities, draw the network diagram and by using forward and backward pass, determine:- 1. Project duration. 2. Critical path. Preceding Duration Activity (day) 3 Act. A - -- A 4 C A 2 B E C 1 F C 2 D,E F,G G 4 H. 3

A load of 120 MW at a power factor of 0.65 lagging can be delivered by a 3-phase transmission line. The voltage at the receiving end is to be maintained at 63 kV and the loss in the transmission is 6 % of the power delivered. (Consider the line to be a short transmission line) Find Single phase Power delivered Per phase voltage Current flowing through the transmission line 3 Phase Losses in the transmission line Per phase resistance of the transmission line

Which level(s) of measurement is(are) considered qualitative? * Ratio and Interval Interval and Nominal Ordinal and Nominal Ratio and Ordinal

Question 3 and 4

The following problems refer to grounding requirements. Give the source of yourresponses. 1. If they are present, what items are required to be bonded together to form a groundingelectrode system?

Part 2: Analysis and selection of the Wind Turbine. The team decides at install a 30 MW wind farm. The turbine that has been selected by the local contractor is an Enercon wind turbine. The specifications of all the available Enercon wind turbine is shown in the attached datasheet. 1. Decide on the required number of wind turbines needed. 2. In your own words, explain what the Betz limit for wind turbines means.

Subject : Electrical Engineering

appropriate answer. Statement one The most common causes of death are falls from heights and being struck by vehicles in the workplace Statement two Following HSE guidance should significantly reduce the risk to an individual a) Statement one is correct and statement two is correct b) Statement two is correct and statement one is incorrect c) Both statements are incorrect d) Statement one is correct and statement two is incorrect actclass.co.uk 25 Questi 26 Questi 27 Questi 28 Questi 29 Questi 30 Submit Answers

Subject : Cercit *Please answer as fast as you can ?? thanks

08:32 ☑ < Block Test Assign... 96% Q : 4. Solutions to this assignment should be submitted via Google Classroom by the due date. 5. No late submissions will be accepted. 6. A cover page should accompany your submission. 7. You will be penalized if you fail to adhere to instructions. MARK ALLOCATION Question Question 1 Question 2 Marks 15 10 Question 1 a) Determine Thévenin's equivalent circuit for the circuit shown in Figure 1. given that, is the load of interest. 1000 480 F [15] Question 2 10/45° V 1 kHz 33002 ли 22002 Figure 1 ZL 75 mH Given the circuit of an ideal OPAMP, as shown in Figure 2, determine the output voltage phasor V [10] V 2.50/30.0° V f=1.00 kHz 1.00 ΚΩ Figure 2 470 nF OV 2/3 3/3

diff b/w aproximated & Interp0leted Curves. (Brief explanation with sketches)

Question 5 & 6

Write short note on the below mentioned questions, Each question carries one mark. Students has to answer the questions typewritten in the word (.docx) format. Figures / Diagrams, equations and solving of problems should be written by hand. Take a picture of it and attach it inside the word file. a) High Voltages are preferred for Transmission of Electricity. Why? b) Why Generation Voltage Levels are low in the range of 11 kV/ 33 kV etc? C) Why ACSR Conductors are preferred over Copper Conductors? d) Overhead Transmission Lines are preferred for Transmission of Power for Long Distances, why? e) Alternating Current is preferred over Direct Current in Power System, Why? f) Write the Installed Generation Capacity of Sultanate of Oman with current energy share of Conventional and Non-Conventional Energy Sources. g) Why the Capacitance effect is neglected in Short Transmission Line. h) Distinguish between Lumped or Distributed elements in a Transmission Line.

: A) Select the best answer from multiple choices: 1. The system ete-5 is: a. Linear, time invariant, casual. b. Non-linear, time invariant, non-casual. c. Non-linear, time varying, casual. d. Not all the above. 2. Noise can be reduced through: a. Increasing So. b. Increasing Si. c. Both (a) and (b). d. Note all the above.

the course is power transmission system... Question : Differentiate between capacitance grading and Intersheath grading? dont just copy from google. thanks :)

22. Determine the standard deviation of the height of trees in meters with the data values 5, 4, 8, 9, 9, 14, 6, and 12. (Round off your answer in 2 decimal places and without unit)

Question : Explain the concepts of lattice matched hetero-structure. Don’t copy other works. Sub:Optoelectronic  Dept: EEE

The variables vary with respect to time is called as ___________________ a. Static characteristics b. Resolution c. Accuracy d. Dynamic characteristics

Which of the following Surge Diverter use non-linear resistances in its fabrication? Rod - Gape SD. Lightning Arrester SD. Expulsion Tube SD. O All of the above.

Find the minimum size EMT raceway required to carry three (3) 500kcmil, three (3) 3/0AWG and two (2) #6 AWGconductors

I need the answer as soon as possible

(c) Draw a circuit diagram to represent a TN-C-S earthing system and briefly explain its advantages and disadvantages.   (d) Briefly explain how to estimate the height of air termination of a lightning protection system network using the rolling sphere method and protection angle method. (e) Briefly explain what is meant by Ground Potential Rise (GPR) and explain why an animal like cow would not be adequately protected against GPR.   Note : answer all or else dnt attempt the question

University of Baghdad College of Engineering Department of Computer Eng. Subject: Electronics I Date: 26 /7 /2020 Time: 3 Hrs. Year: 2019-2020 Class: First Attempt: 1" 15) For the circuit shown below, which choice do you expect is the voltage VR? Si R=IKsh Vis 18 Sinwt a) 18v 9.7v -18v VRA 9.7v b) 18v 9.7v 91 -18v 8.3v tz Scanned with CamScanner

QUESTION 2: What is the approximate voltage amplitude and frequency of the waveform below

pdf - OneDrive pdf - OneDrive A pdf - OneDrive rive personal/a_ghali_bau_edu_lb/_layouts/15/onedrive.aspx?id=%2Fpersonal%2Fa_ghali_bau_edu_lb%2FDocuments%2FFa 1 Gmail ch24 - OneDrive Print Download O Copy to Version history 13- Find the Thevenin and Norton equivalent circuits between ab. 2 A a 18 V ЗА 10 V 14- Find Vo by superposition theorem. of 6 2 62°F Clea prt sc 144 40 &

What is ampere circuital law?