IMG_1148

Please solve No. 19 below. Please provide a clear and readable solution. I appreciate any help you can give me. The course subject is Electrical Machines. NOTE: The answer is given below(The answer is letter B.); show the solution. Please follow this format: Write the Given, Required, and Solution, then Box the Final answer. Thanks!!!

Electric machines/I need the correct solution for the points.

Solve question no.1 and show a clear and readable solution. Super thanks!!! Note: Please include the circuit diagram if possible. The course subject is Electrical Machines.  Thanks!!!

1. It describe the relationship of current voltage and resistance. 2. There are the available options for the pilot, In case of a single generator failure in large multiengine aircraft. Choose all the correct answers. 3. This system converts 115AC to 28VDC in most large body aircraft.

QUESTION -7 In the following figure a power line to drive a Load is represented. The wires are made of copper and shaped as solid round. Under the following requirementsi. The length of each positive voltage and ground wire is 30ft.ii. The maximum allowable resistance of each power line is 0.006 Ω.iii. The maximum allowable current is 110A for each power line.Find the followinga) Using the AWG table (given in this exam sheet) find the suitable cable type with minimum size.b) Considering power supply as E=24V and current drawn by the load as I=12A, find the total voltage drop over the cables and voltage difference over the Load.

The strain gauge can be classified into three types which are not  based on __________________________ Principle  a. Thermoelectric  b. Electrical c. Piezoelectric  d. Mechanical

Please solve question no.6 and show a clear and readable solution. Choose the letter of the correct answer. Thanks!!!

Please solve question no.15 and show a clear and readable solution. Choose the letter of the correct answer. Thanks!!!

i need the answer quickly

The timer wil continue to run if you leave the test Remaining Time: 59 minutes, 13 seconds. Question Completion Status: A Moving to another question will save this response. Quèstion 6 «< Question 6 of 10 Save Answer "The per unit value of impedance, voltage and current of a transformer are same regardless of whether they are refereed to primary or the secondary side" 1 points O True O False DOLL Home End F11 F12 F9 F10 Peet Scre F7 F8 201 SysRa F4 F5 F6 GIO &

In equal area criterion, the area under accelerating power and the area under deaccelerating power become ___________ for the unstable operation of the power system. a. Equal b. Zero c. Unequal d. Infinity

The emergency generator is required to be sized for all the loads that can be connected to it. a. true b. false

14

i need the answer quickly

Identify the installation symbol O Two way One gang switch O Two way Two gang switch O One way Two gang switch O One way One gang switch

Please choose the correct answer for question number 1. EXPLAIN BRIEFLY why it is the correct answer. Thanks!

i need the answer quickly

At standstill condition, the back emf is zero, so the motor should be safely turned ON with the help of a starter. Select one: True False

solve question 4

I need the answer as soon as possible

Which among these statements is false or incorrect? O A. The bigger the value of the Breaking Stress, the longer the Sag. O B. The bigger the Safety Factor used, the longer the Sag. O C. The older the conductor, the longer the Sag. O D. The heavier the weight per unit length, the longer the Sag.

Name things required and to look for before a correct size  standby generator can be determine to assist during load sheeding. and how to install it in an on-grid utility power  supply, also include a correct an automatically change-over switch panels to improve efficidency of power supply during load sheeding.

Choose the correct answer and show your solution. *Kindly provide a COMPLETE and CLEAR solution* (Answer should be typewritten) *Please answer it ASAP if you can

Could you answer this?!

6