Answered: 1.) The flow energy of 0.124 m³/min of…

1.) The flow energy of 0.124 m³/min of a liquid crossing a boundary to a system is 18 kW. Find the pressure at this point. (A) 4.53 MPa (C) 8.71 MPa (B) 6.26 MPa (D) 10.19 MPa

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Water is flowing in a fire hose from point A with a velocity of 10 m/s and a pressure of 300 kPa as…

Q: speed (in m/s) of 2 kg mass

A: Given; A small ball having; mass,m= 1 kg Velocity,v= 12 m/s It undergoes a direct central impact…

Q: 8. The specific volume of steam at atmospheric pressure and 212 deg. Fahrenneit is 26.80 ft3/lb.…

A: 8. Given ν=26.80 ft3/lb Now the relation between Specific Volume and density are,…

Q: Convert the following inappropriate quantities into SIunits: ( a ) 2.283 E7 U.S. gallons per day; (…

A: ( a ) One gallon per day equals to 4.3812 E(-8) m3/s. Thus, 2.283 E7 gal/day is 1.0002 m3/s.

Q: The Figure of a stream of water in steady flow from a kitchen faucet. At the faucet the diameter of…

A: Given data The diameter of the stream, d1 = 0.960 cm. The volume of the container, V = 125 cm3. The…

Q: While the pressure remains constant @ 689.5 KPa, the volume of a system of air changes from 0.567m3…

Q: 5.42 PQ If an automobile tire develops a leak, how does the mass of air and density change inside…

A: Given question: If an automobile tire develops a leak, how does the mass of air and density change…

Q: Can you show the solution in which you converted m=5gal/min=30.05 lbm/min using dimensional analysis

Q: P1.26 When we in the United States say a car's tire is filled "to 32 lb," we mean that its internal…

A: Given, Internal gauge pressure = Pg = 32 lbfin2 = 32 lbfin2 × (12 in)2(1 ft)2 = 4608 lbfft2 Volume =…

Q: b. If the Farmville community needs 5.5 m/s to sustain its activities, how much water (in m) does it…

A: (b) Write the given data. QA=20 m3/sQB=30 m3/sQdown=46 m3/s

Q: Q6• For figure below, caleu late the forces on Surfaces A f B. surface 8 (area =o.1m) air 2 wn water…

Q: Based on the figure below, how much water is stored after 25 minutes in each of the tanks? How long…

Q: kg 2. Two liquids of different densities ( p1 = 1,500 - ) are poured together ma : P2 = 500 into a…

Q: 11. The water contained in a tanker truck that is moving up with a constant acceleration as in…

Q: A tank of 10ft3 capacity is half filled with glycerin. The weight density of glycerin is 78.6…

A: Volume of tank fully filled with glycerin,V=10ft3Weight density of glycerin=78.6lbsft3So,weight of…

Q: 2. A 10 kg/s of water flows through a pipe at a velocity of 2 m/s the specific vol. of water is…

Q: Find h when the pressure in tank B is 21 kPa. A Air Air SG = 0.91 h Oil D 1 m B 2 m Water 1.25 m…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: Air is accelerated in a nozzle. The mass flow rate in kg/s and the exit area in cm? of the nozzle…

Q: A liquid flows through a pipe with a diameter of 15 cm at a velocity of 10 cm/s. If the diameter of…

Q: What time (in second) is required to fill the circular tank with incompressible water from h= 2 m to…

A: Given Data H=7.5 m h=2 m D=20 cm=0.2 m

Q: Suppose that a person eats 2387 Calories per day. Convert this amount of energy into unit kJ.

A: A person takes energy per day E=2387 Cal. The unit conversion factor to convert Calories into…

Q: A fluid has a specific volume of 0.00007353 m3/kg. If 500 grams of fluid is poured in a container,…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 1. A jet with a velocity V impinges a curved plate moving at velocity u in the direction of jet, as…

Q: A customized section of pipe is used to deliver water at a rate of 30 kg/s as shown Fig. Q1(b). The…

Q: ?Q5- In fig. if D1= 4 cm ,V1= 10 m/s , Q Control volume (CV)- Fluid element of velocity , El - Area…

A: find the flow rate through the pipe.

Q: What form of energy from the list below is an extensive system property (choose all what apply)…

A: Extensive propeties: An extensive property is a property that depends on the amount of matter in a…

Q: Consider the low speed flight of the space shuttle as it is nearing a landing. If the air pressure…

A: Pressure = 1.15 atm Temperature = 207 K R = 287 J/kg.K

Q: 3.39 Calculate the following specific volumes: a. R-134a: 50°C, 80% quality b. Water: 4 MPa, 90%…

A: As per Guidelines we have to solve 1 question We have to determine specific volume

Q: Suppose that a person eats 2387 Calories per day. Convert this amount of energy into unit J.

A: The person takes energy per day is E=2387 cal. The unit conversion factor to convert Calories into…

Q: ees. Oil (µ = 0.02

A: given:θ=30µ = 0.025 Pa.sA=0.1×0.1Y=0.5mmu=0.2m/s

Q: Q2 // A 30 cm diameter pipe, conveying water branches in to two pipes of diameter 20 cm and 15 cm…

A: Given Data Diameter of pipe = 30cm =0.30 m Velocity at inlet v1=2.5 m/s V2= 2m/s d2=0.2m d3=0.15…

Q: A compressor draws in 500 min of air whose density is 0.079 and discharges it with a density of…

A: Given that, Volume flow rate of air in compressor at entry, v˙=500 ft3/minDensity of air at…

Q: The volume of air delivered by fan is 26 m^3/sec and 186 mm water gage. The density of air is 1.5…

A: Given data: Airflow rate, V = 26 m3/s. Air pressure, P = 186 mm water gage. Input power, Pin = 48…

Q: An air bubble rises from the bottom of the well where the temperature is 20 degrees celsius to the…

Q: ank contains air, oil, and water, as shown in Fig. 1 ; the air is under gage pressure p = 4 lb/in'.…

Q: A car can accelerate at 4 m./sec.. How long will it take to reach 90 (ans.: 6.25) km./h. from rest ?

A: Given Acceleration, a = 4 m/s2 Velocity, v = 90 km/h = 25…

Q: A wind tunnel draws atmospheric air at 2b° C and lab by a large fan located near the exit of the…

A: Given P1=137 kPa T1=27+273=300K

Q: A tank contains 80 ft 3 of air at a pressure of 340 psi. If the air is cooled until its pressure and…

Q: A Ford Explorer can refuel with 10 gallons of gasoline in 2 minutes. Given gasoline has an energy…

A: Given data, Mass flow rate of the gasoline, m˙g = 10 gallons/2 min Calorific value of the gasoline,…

Q: A substance weighing 6 N and moving at 70 m/s enters a viscous liquid and comes to a hait before…

Q: A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open…

A: Option b is correct.

Q: 1- A pressure head of 1.5 m of fluid with a specific weight (v) 0.8 is equal to a. 14.7 kN/m2 b.…

A: Head = 1.5 m Density = 0.8 ×1000 = 800 kg/m³

Q: Q1: Water at (T1 c) and quality X1. Has the temperature raised (a)c at constant volume process:…

A: Let us consider that the temperature of the water is 150 degrees Celsius and the quality of the…

Q: QI. A hydroelectric station has a cubic tank of height 50m above the earth. This cubic tank has an…

Q: P3. A piston-cylinder system contains 1 L of water at 105°C and 85% quality. I know adds energy,…

Q: A horizontal water jet with a velocity of 5.4 m/s strikes a moving object with a velocity of 0.8. If…

Concept explainers

Thermodynamic Relations

Thermodynamics is the division of physics that deals with the transfer of any kind of energy, whether it be heat, temperature, or work, from one object to another.

Question

Answer the following problem.

Show Complete Solution.

View Image.

1.) The flow energy of 0.124 m³/min of a liquid crossing a
boundary to a system is 18 kW. Find the pressure at this point.
(A) 4.53 MPa
(C) 8.71 MPa
(B) 6.26 MPa
(D) 10.19 MPa

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Answer seems to be 736kpa, please show Formula and calculation as fast as (handwritten only) A 75-m-high water body that is open to the atmosphere is available. Water is run through a turbine at a rate of 200 L/s at the bottom of the water body. The pressure difference across the turbine is
A pump delivers water, density =1000kg/m3, at a volume flow rate of 0.004256 m3/sec. If the head developed by the pump is 4.01 m, determine the fluid power in Watts. Take g=9.81 m/s2. State the answer to two decimal places.
A two floor building has two faucets, one in the basement and one in the first floor. The maximum water (\rho = 1000 kg/m3) velocity at the basement faucet, when the first floor faucet is closed, is 12m/s. The faucet diameter is 1.5 cm. Neglect all losses. (a) How much is the maximum velocity at the first floor faucet, when the basement faucet is closed? (b) What would be a maximum height (from the basement floor) for a faucet, to still get a maximum exit velocity of 5 m/s?
A pipe has an initial radius of r1, which then changes to a radius of r2. The velocity of the water in the initial part of the pipe is v1. The segment of the pipe with the smaller radius is also 0.5 m higher than the initial pipe segment. What is the pressure difference between the two parts of the pipe? let r1=10cm let r2=6cm let v1=5m/s b) What is the volume flow rate in the pipe?
The pressure in a water tower is 27,030 Pascals (N / (m ^ 2)) higher than at an open faucet. The density of water is 1000Kg / (m ^ 3). Use Bernoulli's equation to determine the velocity of outflow from the open faucet. the height difference between the top water level in the tower and the faucet is 9 meters, then the velocity of outflow is
a. the total dynamic head in meters b. the water power in kW c. the motor horsepower if the pump efficiency is 66%
A room has a volume of 349 m3. An air-conditioning system is to replace the air in this room every 81.5 minutes, using ducts that have a square cross section. Assuming that air can be treated as an incompressible fluid, find the length of a side of the square if the air speed within the ducts is (a) 2.00 m/s and (b) 7.00 m/s. a: b:
Find the flow rate of water through the system shown for the turbine to produce 20 kW. Neglect friction in your calculations. Q=10.75 m^3/s, P=204 kW/273 Hp
For a tank, calculate the volumetric flow of water, which comes out through a pipe, the tank is sealed, the depth is h1=2M, Qexit=0.05,substance water Vexit=? and Q=?.
A tank half full of water is accelerated to the right at 9.81 m/s^2. If the motion is laong the side with a length of 4 m, the water surface on the rear wall will: a. rise 2 m b. rise 1.5 m c. drop 2 m d. drop 1.5 m
The diameter of pipe carrying water changes gradually from 20mm at A to 450mm at B. A is 4.57m lower than B. What will be the difference in pressure,in N/mm2, between A and B, when 0.176cu.m/s is flowing loss of energybeing neglected?
Answer is: V = 14.17 ft/s