1. The 'IF' counter is a counter that has the following sequence : following. 0011 1100 1010 0101 0000 1111 0001 1001 0011 1100 And when the state is outside of that sequence, it will go through state 0000. Draw a sequential circuit using. A. JK Flip-Flop B. D Flip-Flop

1. The 'IF' counter is a counter that has the following sequence : following. 0011 1100 1010 0101 0000 1111 0001 1001 0011 1100 And when the state is outside of that sequence, it will go through state 0000. Draw a sequential circuit using. A. JK Flip-Flop B. D Flip-Flop

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Related questions

Q: 7. Two edge-triggered J-K flip-flops are shown in below Figure. If the inputs are as shown, draw the…

Q: A sequential circuit using a D flip-flop and logic gates is shown in the figure, where X and Y are…

A: J-K Flip-flop- The J-K flip flop is the same as the S-R flip-flop with the addition of a clock input…

Q: Design a gray code counter using T flip-flops based on the following state diagram. (Hint: Use truth…

Q: If LM = 00, the next state of the flip-flop is 1. If LM = 01, the next state of the flip-flop is the…

A: Flip-flops: Flip-flop is used as a storage device that stores 1 bit at a time. This is used in…

Q: Q4: Please type the description of all the parts to this question part 1: Explain the function of…

A: 1) flip flop have function of sampling the input at the output when ever an external signal applied…

Q: 3 (a) Determine the missing entries (i) to (vii) in Table Q3(a) of flip-flop excitation values…

Q: How many flip flops are there in a Johnson counter with 50 different count states. Lütfen birini…

Q: at is the difference between latch and flip flop? at is sequential circuit? e some information about…

A: In this question we will write about difference between latch and flip flop, sequential circuit and…

Q: 4. (a) Design a 3-flip-flop counter which counts in the following sequence: АВС 000 010 111 100 110…

Q: Which one is true for D flip flop? a) It has 2 inputs 1 output b) It has always the output 1. c)…

A: D flip flop or delay flip flop is used to remove the limitation of SR flip flop. When S=1 , R =1…

Q: Design the circuit that counts 1-2-8 synchronously up and down using J K flip flop.

Q: 6. In your notebook, sketch a 2-bit asynchronous counter using D flip-flops and a HEX display,…

A: Note: Since you have posted multiple independent questions in the same request, we will solve the…

Q: Draw a circuit for an asynchronous counter (using JK flip-flops and gates) that counts from decimal…

A: consider the given circuit:

Q: Design a synchronous counter that will count according to the following sequence: D-1-6 -7-3 and…

A: We need to design synchronous counter by using of T flip flops . First we will draw truth table for…

Q: (Assume the clocks of flip-flops are connected.) (FA block is full adder.) Q2 Q0-10 Q2- Q1–11 Q2 S3…

A: i have explained in detail

Q: :D nalyze the following sequential circuit: O What type of state machine is this circuit and why?…

A: We need find out input and output expression for given state machin circuit .

Q: DESIGN THE SYNCHRONOUS COUNTER WITH THE FOLLOWING STATE TRANSITION DIAGRAM. USE J-K FLIP FLOP IN THE…

Q: (a) Determine the missing entries (i) to (vii) in Table Q3(a) of flip-flop excitation values…

Q: 79 Suppose a circuit is constructed from three D-type flip-flops, with Do = Q2 Di = Q2 e Qo D2 = Q…

A: Given: The equation of D flip-flops is shown as: D0=Q2D1=Q2⊕Q0D2=Q1

Q: 2) If a down counter has 4 flip-flops and its initial count is 6, what count will it hold after 38…

A: The solution is given below.

Q: 4. Use a JK flip-flop and logics to implement the following. x:T2: F+ z y T1: F +/F J >F

Q: 2. How does a J-K flip-flop differ from an S-R flip-flop in its basic operation?

A: Note: As per the company policy, we experts are allowed to answer only one question. Kindly post the…

Q: Construct a 4-bit Johnson counter using J-K flip-flops. What sequence of states does the counter go…

A: The Johnson counter is also known as the twisted ring counter. In Johnson counter, the inverted…

Q: Design a 2-bit countdown counter using D flip-flops and binary coding. This circuit has an input X.…

A: Given : input X. When X= 0 ,Next State remains in The Present state. When X= 1, Next state…

Q: 5. Explain the working of Master-Slave D Flip-Flop What is the basic usage of Flip-flops Y D D D D…

Q: Design a counter to count-up from 2 to 6 using D Flip Flops

A: K-map is used to minimized the expression . The K-map is arranged in such way that its differ by 1…

Q: (b) (i) Describe the the operational of J-K Flip Flop. Use an approprite diagram and truth table to…

A: To describe the operation of JK flip flop

Q: The following timing diagram corresponds to which of the following flip-flops? CLK Input Output…

A: We need to select correct option for given input and output waveform .

Q: Design synchronous counter using negative edge T- type flip flop to count the following states : ( 4…

A: Given:- Count sequence Tff present state Next state T 0…

Q: Figure shows the function table of a certain flip-flop. Identify the flip-flop. K Qn+1 Qnt1 Pr CI…

A: From the given below truth table we need to identify the type of option it suits for. Lets go…

Q: 5. If the flip-flop is set, what are the output states of the master and slave when a high is…

A: The given circuit diagram is

Q: show the waveforms for each flip-flop output with respect For the ring counter in Figure to the…

A: Truth table of the given ring counter Clock pulse Q0 Q1 Q2 Q3 Q4 Q5 Q6 Q7 Q8 Q9 0 1 0 0 0 0 0…

Q: 5. If the flip-flop is set, what are the output states of the master and slave when a high is…

A: As per BARTLEBY GUIDELINES, I answered one question (Q-5) and repost other questions separately.…

Q: The flip-flops in the drawing below are positive edge triggered D flip-flops. Let Q2, Q1, QO = 0,0,0…

A: D Flip-flop acts as a data transfer element. When an appropriate clock is provided, data at the…

Q: [3] Complete the following timing diagram for the D type flip-flop covered in class (the flip-flop…

A: D flip-flop: The D flip-flop is a single-digital-input timed flip-flop. The output of a D flip-flop…

Q: DESIGN THE SYNCHRONOUS COUNTER WITH THE FOLLOWING STATE TRANSITION DIAGRAM. USE J-K FLIP FLOP IN THE…

A: There are 8 states so total flip flop required is 3. Let the three states of flip flop be Q1Q2Q3.…

Q: Derive the state table and the state diagram of the for the following sequential circuit. Note that…

Q: What is NOR gate R-S flip flop?

A: Flip flop is bi-stable device. In RS flip flop there are two inputs used one is called SET which is…

Q: 1. If a j-k flip flop has the j and k inputs connected to 5volts while being clocked it will: A.…

A: In this question, Choose the correct options in question 1. If a j-k flip flop has the j and k…

Q: Q3 (a) Determine the missing entries (i) to (vii) in Table Q3(a) of flip-flop excitation values…

Q: Briefly explain the difference between T and D Flip-Flops

A: Flip Flops: A flip flop is a digital circuit that has two stable states which store one bit of…

Q: When signal LD = 0, * D3 D2 D1 DO D Q D Q D Q CR CR CR CR CLR LD CLK Q2 Q1 QO Q3 Input C (Clock) at…

A: When LD =0 then the inputs to the Or gate is 1 and clock signal, Whenever one of the input to the…

Q: In general, how many rows does the state table consist of for a sequential circuit consisting of 'm'…

A: Given the number of flip flops are: m And, the number of inputs is: n

Q: Q ) Among the flip flops frequency of operation for the following circuit? which combination can…

A: Flip flop is a latch with additional control input (clock or enable ). A flip flop is used to store…

Q: 1) If an up counter has 10 flip-flops and its initial count is 0, what count will it hold after 2070…

A: In this question, We need to choose the correct options What is count will be hold after 2070…

Q: Which one is true for D flip flop? It has always the output 1. The output of it will be equal to…

A: SR flip flop is one of the most important flip flop but disadvantage of it is that when both S =0…

Q: 3- Design a counter with a control input. When the input is high, the counter should sequence…

Concept explainers

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.

Question

Please Answer my question in the Image... And solve All sub parts in the question.... Thank u... Im needed

1. The 'IF' counter is a counter that has the following sequence :
following.
0011
1100
1010
0101
0000
1111
0001
1001
0011
1100 And when the state is
outside of that sequence, it will go through state 0000.
Draw a sequential circuit using.
A. JK Flip-Flop
B. D Flip-Flop

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step by step

Solved in 6 steps with 6 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For the standard synchronous decade up counter circuit using JK flip-flops, shown in Floyd, the counter starts in the state decimal 11 after the power is first turned on. Determine the next state of the counter in decimal.
Design an Octal Counter with D flip-flops.a) Draw the state diagramb) Draw the state tablec) Draw the counter circuit
Design the asynchronous counter circuit using JK flip-flops, starting from the smallest decimal digit to the largest decimal digit in the following numbers. (1180501624)
Design a traffic light system with 2 push button input and 3 light output (red, orange, green) using sequential or counter circuit using counters and use flip-flops (use logic.ly for design).
about 4 bit Synchronous Up/Down Counter using JK flip flops and explain how it functions, find real life applications.
3) "JK" type flip flops with asynchronous counter counting as-1-2-3-4-5-6-1-2-3-4-..." Design and draw the circuit using
Assume that there is a flip-flop with thecharacteristic given in Figure, where A and Bare the inputs to the flip-flop and Q is the next stateoutput. Using necessary logic gates, make a T flip-flopfrom this flip-flop.
Question 2: The circuit below is a synchronous sequential circuit based on D-type flip-flops (DFFs): (a) Write the excitation and state equations for the two DFFs. (b) Express the output equation for the outputz. (c) Determine the present and next state table of the circuit. (d) By using the result obtained in (c), sketch the circuit using JK flip-flops (JKFFs).
Convert a single J-K flip flop to a T-flip flop. Include all steps involved. What is the next count if the counter started with 000 and 011 (unused states)? i want the anwer for the second qustion
Use D flip-flops to design a mod-16 binary down counter, whose counting sequence is 1111->1110->1101->1100->1011-> … ->0000->1111…. Derive the logic expressions for the D inputs of the flip-flops and draw the circuit diagram.
Subject 3 Logic Circuit and Switch Theory Determine the state diagram for the D flip-flop equations given below: DA = AB' + X'A' + XA; DB = (X' + A' )B; Y = B'
Draw the diagram of a 2-bit asynchronous ripple counter using T flip-flops. Draw the diagram of a 5-bit ring counter using D flip-flop.