Answered: 1. What can you say about the pressures…

1. What can you say about the pressures at points 1, 2, and 3? A. pi =P2=P3 B. pi =P2>p3 C. p3>p1 =P2 D. p3> pı >p2 E. p2=P3>Pi

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter11: Fluid Statics

Section: Chapter Questions

Problem 22PE: The left side of the heart creates a pressure of 120 mm Hg by exerting a force directly on the blood...

See similar textbooks

Related questions

Q: 2. a) A submarine can withstand a maximum pressure of 1MPA exerted by seawater. If the density of…

Q: Q2) The figure below represents a hydraulic car jack has an output cylinder 30 cm in diameter and an…

Q: Question 19 What is the difference between the pressure on the bottom of a pool and the pressure on…

A: Pressure which is experienced by a fluid is called fluid pressure. It mainly depends on two factors.…

Q: 2. The coefficient of kinetic friction under the sliding supports at A and B in figure is 0.30. What…

Q: 3. (a) What is the mass of a deep breath of air having a volume of 2.00 L? (b) Discuss the effect…

A: 3. Given Data:- The volume of deep breaths of air is v = 2.0 L.

Q: 7. A large container, 122 cm deep is filled with water. If a small hole is punched in its side 79.0…

Q: Q2. The height of Mercury in a barometer reads 85 cm. Given the density of mercury is 13.6 g/cms,…

A: As per the guidelines, i can only answer the 1st question. Kindly post separately for other answers.

Q: 2. Use the figure to answer the problem. Calculate the difference in pressures (in atmospheres) that…

Q: 5. The small piston of a hydraulic lever has a diameter of 5cm. The large piston has a diameter of…

A: Given: The diameter of small piston is 5cm The diameter of the larger piston is 50cm

Q: 2) The pressure at the bottom of an average spot in the Narragansett Bay is only about 7.800 x 10°…

Q: 10 Approximate the change in the atmospheric pressure when the altitude increases from z = 6 km to z…

A: Given: The pressure is given as, P(z)=1000e-z10 Initial altitude z1 = 6 km. final altitude z2 = 6.05…

Q: 3. A research submarine has a 30-cm-diameter circular window 10.0 cm thick. The manufacturer says…

A: The pressure at the depth can be expressed as, P=hρg

Q: QI: The U tube (in Fig.1) is open at (D) and closed in (A). What will be the pressure at point (A, B…

Q: 11.3 Pressure and Depth in a Static Fluid A diver descends from sea level at a constant rate of 1.0…

A: Given:- v= 1 m/s P= 4Po Where; P= pressure at depth h Po=…

Q: 14) The figure below shows a container filled with water to the height shown. When we compare the…

Q: 2. Use the figure to answer the problem. Calculate the difference in pressures (in atmospheres) that…

A: Detailed solution of this question is given in below steps.

Q: 7. (II) A house at the bottom of a hill is fed by a full tank of water 6.0 m deep and connected to…

A: Given,height of the tank, h = 6.0 mlength of the pipe, l = 75 minclination of the hill, θ = 60°

Q: We are interested in measuring the pressure at different depths below the surface of the ocean.…

A: Pressure increases by approximately 1 atmosphere for every 10 m of depth below the surface of the…

Q: 6. The shape of the eye is maintained by fluid pressure, called intraocular pressure. When the…

Q: Salmah is a 55-kg woman, wearing high heels covering the area of A cm?. She is standing on the soft…

Q: (10%) Problem 2: Nail tips exert tremendous pressures when they are hit by hammers because they…

A: In order to calculate the number of people to stand on the nail to exert the same force, we use the…

Q: 13- The flow rate of blood through a 1.50 ✕ 10−6 m radius capillary is 3.80 ✕ 10−9 cm3/s. (a)…

Q: Chapter 14, Problem 059 Water is moving with a speed of 6.4 m/s through a pipe with a…

A: Given information:

Q: An aquarium was filled with salt water at a depth of 0.5 m. What is the pressure due to the liquid?…

A: Given Depth is h=0.5 m Density of salt water is d = 1.03 x 10 3 kg/m3. Acceleration due to gravity…

Q: 1. (a) Calculate the absolute pressure at the bottom of a fresh water lake at a depth of 27.5 m.…

Q: ** 6. A diver experiences a doubling of the pressure by descending about 10.3 meters in fresh water…

A: Let h be the depth.

Q: 5. A gender neutral individual having a mass of 70 kg owns two pairs of shoes: 1) a pair of…

Q: Q2) The figure below represents a hydraulic car jack has an output cylinder 30 cm in diameter and an…

Q: 2. Which unit of pressure is equivalent to 1 Pa? B. dyne/cm? C. N/m D. N/m? A. dynel cm

Q: h other. How many of these blocks do you need to create a pressure, from their total weight, that…

Q: Question 7 of 18 You come across an open container that is filled with two liquids. Since the two…

A: Given : Gravitational acceleration = g = 9.81 m/s2 Density of water = w = 1000 kg/m3 Density of the…

Q: 1. You are designing a diving bell to withstand the pressure of seawater (density 1030 kg/m3) at a…

A: density of sea water (d) = 1030 kgm3depth (h) = 200 m

Q: 1. The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer…

Q: (I) How fast does water flow from a hole at the bottom of a very wide, 4.7-m-deep storage tank…

A: Consider two points A and B. Point A denotes the free surface of water on the top of the tank and…

Q: 1. A diving bell is designed to withstand pressure of sea water at a depth of 600 meters. (a) What…

A: Please see the answer below.

Q: 2. An airplane wing with an average crosssectional area 10 m2 experiences a lift force of 60 000 N.…

A: Given data *The given average cross-sectional area of the airplane wing is A = 10 m2 *The given lift…

Q: 2. The input and output pistons of a hydraulic car lift have diameters of 3.00 in and 25.0 in,…

A: Given, Diameters,d1=3 in,d2=25 in Mass of car,m=2890 lb Height of raising of car, h=5 ft

Q: 9. A liquid is flowing through a horizontal pipe whose radius is 2.22 x10-2 m. The pipe bends…

A: The radius of the bottom pipe, r1=2.22×10-2 m The cross-sectional area of the bottom pipe,…

Q: 1) Calculate the pressure at the bottom of the Narragansett Bay, which is 56 m below sea level at…

A: 56 m below the sea level

Q: (II) One liter of alcohol (1000 cm3) in a flexible container is carried to the bottom of the sea,…

A: When we apply some pressure on a liquid's surface, the volume of the liquid decreases. The change in…

Concept explainers

Variation of pressure

From the equation of pressure, pressure is directly proportional to the applied force.

Question

Provide justification

1. What can you say about the pressures at points 1, 2, and 3?
A. pi =P2=P3
В.
pi = p2 > p3
C. p3> pi =P2
2
D. p3 > pı> p2
E. p2= P3 > pi

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An 81.5kg man stands on a horizontal surface. (a) What is the volume of the mans body if his average density is 985 kg/m3? (b) What average pressure from his weight is exerted on the horizontal surface. If the mans two feet have a combined area of 4.50 109 m3?
(a) What is the pressure drop due to the Bernoulli effect as water goes into a 3.00-cm-diameter nozzle from a 9.00-cm-diameter fire hose while carrying a flow of 40.0 L/S? (b) To what maximum height above the nozzle can this water rise? (The actual height will be significantly smaller due to air resistance.)
When two soap bubbles touch, the larger is inflated by the smaller until they form a single bubble. (a) What is the gauge pressure inside a soap bubble with a 1.50-cm radius? (b) Inside a 4.00-cm-radius soap bubble? (c) Inside the single bubble they form if no air is lost when they touch?
. A blimp used for aerial camera views of sporting events holds 200,000 ft3 of helium. (a) How much does the helium weigh? (b) What is the buoyant force on the blimp at sea level? (c) How much can the blimp lift (in addition to the helium)?
A 50.0-kg woman wearing high-heeled shoes is invited into a home in which the kitchen has vinyl floor covering. The heel on each shoe is circular and has a radius of 0.500 cm. (a) If the woman balances on one heel, what pressure does she exert on the floor? (b) Should the homeowner be concerned? Explain your answer.
You are pumping up a bicycle tire with a hand pump, the piston of which has a 2.00-cm radius. (a) What force in newtons must you exert to create a pressure of 6.90105 Pa (b) What is unreasonable about this (a) result? (c) Which premises are unreasonable or inconsistent?
(a) The pressure inside an alveolus with a 2.00104 -m radius is 1.40103 Pa, due to its fluid-lined walls. Assuming the alveolus acts like a spherical bubble, what is the surface tension of the fluid? (b) Identify the likely fluid. (You may need to extrapolate between values in Table 11.3.)
The aqueous humor in a person's eye is exerting a force of 0.300 N on the 1.10-cm2 area of the cornea. (a) What pressure is this in mm Hg? (b) Is this value within the normal range for pressures in the eye?
The pressure drop along a length of artery is 100 Pa, the radius is 10 mm, and the flow is laminar. The average speed of the blood is 15 mm/s. (a) What is the net force on the blood in this section of artery? (b) What is the power expended maintaining the flow?
(a) Verify that work input equals work output for a hydraulic system assuming no losses to friction. Do this by showing that the distance the output force moves is reduced by the same factor that the output force is increased. Assume the volume of the fluid is constant. (b) What effect would friction within the fluid and between components in the system have on the output force? How would this depend on whether or not the fluid is moving?
(a) Suppose a blood vessel's radius is decreased to 90.0% of its original value by plaque deposits and the body compensates by increasing the pressure difference along the vessel to keep the flow rate constant. By what factor must the pressure difference increase? (b) If turbulence is created by the obstruction, what additional effect would it have on the flow rate?
What is the difference between flow rate and fluid velocity? How are they related?