ec.1039. A car accelerates for t sec from rest to a velocity of 48 ft per sec, the accelera-tion increasing uniformly from zero to 12 ft per sec². During the next 4 sec, thecar decelerates at a constant rate to a velocity of 4 ft per sec. Sketch the a-t, v-t,and 8-t curves.ight line

Answered: Image /qna-images/answer/3c3f8cb7-1770-4b85-ac45-a1fdee5e7d18.jpg

1039. A car accelerates for t sec from rest to a velocity of 48 ft per sec, the accelera- tion increasing uniformly from zero to 12 ft per sec?. During the next 4 sec, the car decelerates at a constant rate to a velocity of 4 ft per sec. Sketch the a-t, v-t, and 8-t curves. line

1039. A car accelerates for t sec from rest to a velocity of 48 ft per sec, the accelera- tion increasing uniformly from zero to 12 ft per sec?. During the next 4 sec, the car decelerates at a constant rate to a velocity of 4 ft per sec. Sketch the a-t, v-t, and 8-t curves. line

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Let's assume the rocket has a rest length of 57 m and the hangar has a rest length of 51 m.…

Q: A steel rod is 2.2 m long and must not stretch more than 1.2 mm when a 8.5 kN load is applied to it.…

Q: 4. A centrifugal pump is taken into consideration of this design. If you assign a fluid particle P…

A: We can see that a centrifugal pump has been considered in this design. If you put a fluid particle P…

Q: : Find the resultant couple moment of the two couples that act on the pipe assembly. The distance…

Q: Water at 200∘F enters the radiator at A with an average velocity of 4 ft/s and a pressure of 60 psi.…

A: given data for a radiator Vavg=4ft/spa=60 psi…

Q: e maximum allowable load

A: To find Maximum allowed load

Q: Air conditioner using R-22 works on the condensing and evaporating temperatures of 50 F and -30 F…

A: Given:Evaporating temperature, Te=-30 FCondensing temperature, Tc=50 FCoP=2.855

Q: The mechanism in the figure is given input on rod 2 with angular velocity (w2) = 4 rad/s. Calculate…

Q: 7.22 Casing with an ID of 10.05 in. and a strength in tension of 450,000 lbf in the joints and…

Q: How much force P parallel to the horizontal plane must be applied so that the 100 lb block will be…

A: Answer: The force P that must be applied parallel to the horizontal plane is 25 lb.

Q: Develop the shear and bending moment diagrams for the beam 6 kN/m 2.4 kNm B 4 m .6m.

Q: 2. Bar AB is rotating in the counterclockwise direction at 5 rad/s. The disk rolls on the horizontal…

Q: single-pass, cross-flow heat exchanger uses hot exhaust gases (mixed) to heat water (unmixed) from…

Q: Three uniform rods, ABC, DCE and FGH are connected as shown. Which of the following statements are…

A: The correct answer is (A) As per given figure the length of the rod FGH is less than the road ABC…

Q: b) Estimate the yield stress of copper containing an array of equally spaced second phase…

A: Yield strength alludes to the pressure at which the event of a foreordained measure of super durable…

Q: 20- Air enters a nozzle steadily at 280 kPa and 77°C with a velocity of 50 m/s and exits at 85 kPa…

Q: A rod hanging from a support whose unit mass is 3900 kg/ m² has a cross sectional area of 400 mm²…

A: GIVEN DATA- unit mass is 3900 kg/ m² area of 400 mm² E= 200 x 10³ MPa load of 18 KN

Q: Round everything to four decimal places. When an air conditioner is reversed it can operate as a…

Q: Six years ago, an 80-kW diesel-electric set cost $160,000. The cost index for this class of…

Q: A 12-in diameter pump rotating at 600 rpm develops a head of 500 ft. Determine the peripheral…

Q: 4. If the maximum force that any member can support is 8 kN in tension and 6 kN in compression,…

Q: 5. Dry winter atmospheric air at latm, 8°C and 50% humidity enter an HVAC system at a rate of…

A: human comforts refers to the physical comforts of the human being which can be adjusted by adjusting…

Q: 1. Water flows steadily with a velocity of 3.05 m/s in a 304.8 m long horizontal pipe having an…

Q: Determine the maximum acceleration that the 12 kg rear wheel drive go-cart can achieve (the front…

Q: A square steel alloy plate 400 mm on a side has a 90-mm-diameter circular hole at its center. The…

Q: Three rods jointly support a 9kN load. Assuming that there was no stress in the rods before the load…

A: Given that: Three rods joints support a load of 9 kN. Two rods are of bronze material and one rod is…

Q: A line shaft is to transmit 200 hp at 900 rpm. If the line shaft is connected to a 2” counter shaft…

A: Given Data: Diameter of the countershaft, d=2 inch

Q: A 1-inch solid shaft is to be replaced with a hollow shaft equal torsional strength having an…

Q: A pipe AB carries water and tapers uniformly from a diameter of 4" at A to 8" at B over a length of…

Q: Connecting rod (as shown below) is a car part that connects engine piston to crankshaft and converts…

Q: Describe at least five (5) orebody configurations that lend themselves to surface mining methods…

A: Surface mining is a type of mining that involves removing the soil and rock that covers mineral…

Q: In your biomechanical testing lab, you perform a series of compression tests to determine the…

A: Please note that you have to sort the data given for density in ascending order for…

Q: For a 34.4 mm diameter smooth pipe, calculate the threshold velocity (m/s) and corresponding flow…

A: Given data:

Q: What is the specific enthalpy (kJ/kg) and specific entropy (kJ/kg-K) of a steam with a specific…

A: Given Data: Pressure, P=2.25 MPa Specific volume, v=125x10-3 m3/kg

Q: Find the upward velocity v of the car hoist when e = 53°. The piston rod of the hydraulic cylinder…

Q: Problem 1) Determine the spring constant, k if the unstretched length of the spring is 3.2 meters…

A: Given Data: Unstretched length, L=3.2 m

Q: A 02-series single-row deep-groove ball bearing is to be selected from Table 11-2 for the…

Q: At the lowest and highest points on its trajectory, the pendulum cord, with a length L = 2 ft, forms…

Q: Water in the 15-in.-diameter concrete drain pipe runs full with a flow of Q = 15 ft3/s. The pipe is…

A: As per given question D=15 in Q=15 ft^3/s f=0.07 L=18ft Specific weight =62.4 lb /ft^3 We have to…

Q: A propeller shaft in a ship is 400 mm in diameter and 6 m in length. The allowable shearing stress…

A: Answer: The maximum torque that the shaft can transmit is 754 kN•m.

Q: A double-pipe heat exchanger (tubes are concentric with very thin walls) has a length of 5 m while…

Q: Six kilogram of water has 7166.46 kJ entropy and 7212.12 kJ enthalpy. Determine its (a) temperature…

Q: The velocity ratio (v1/v2) of an isentropic flow through a supersonic wind tunnel is 0.615. if the…

Q: Problem 2) Determine the weight of cylinder Cif the weight of cylinder A is 40 newtons.

Q: A wooden sled supporting a large stone is pulled up the track inclined at 15ᵒ with the horizontal.…

Q: Following the pump, the pressure in a 6-inch inner smooth pipe conveying water is 20 pounds per…

A: SOLUTION : Given Data: Inside diameter of the pipe (d) = 6 inch = 0.1524 m Pressure (ΔP) = 20 psia =…

Q: 3. From a gross height of 65m, water flows at a rate of .85 m3/s and drives a hydraulic turbine…

Q: In the figure shown, If v=700 mm/s, solve for the (a) velocity (in m/h) of D and (b) the angular…

Q: Blocks A and B are released from rest in the position shown. Neglecting friction, the normal force…

Q: 1. A piston-cylinder device contains 10.0 lbm of water initially at 225 psia and 25.59 ft. Now 4000…

Concept explainers

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.

Question

ec.
1039. A car accelerates for t sec from rest to a velocity of 48 ft per sec, the accelera-
tion increasing uniformly from zero to 12 ft per sec². During the next 4 sec, the
car decelerates at a constant rate to a velocity of 4 ft per sec. Sketch the a-t, v-t,
and 8-t curves.
ight line

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An airplane starts from rest at t=0.the mass of aircraft is 1500kg. During a curvilinear flight path, airplane’s acceleration in cartesian components is defined by ax= 0.46t + 0.2 m/s2 and ay= 0.6t m/s2. At t = 4 sec, determine a) Cartesian components of Velocity and Acceleration b) Magnitude and direction of Velocity
Q) A driver is driving a car in a circular ring which is 120 m in diameter. At one instant, his total acceleration is 12 m/s2 with a direction of 30° relative to the tangent. a) Determine his radial and tangential acceleration. b) Starting from the state described above and maintaining the same tangential acceleration, how long does he need to perform one complete circuit?
A particle, originally at rest and located at point (3 ft, 2 ft, 5 ft), is subjected to an acceleration a={6ti+12t2k}ft/s2 .
A skydiver jumps from a height of 4000 m. After 55 seconds, he reaches the terminal speed of 200 km/h. At 58 seconds, his acceleration is
A crank of length 30 cm, starting from an initial horizontal position P, rotates in a positive sense (counterclockwise) at a uniform rate of one revolution per second.a) Determine a function that gives the height of the end of the crank from the initial position line at any time t.
Applying principles of dynamics, with step by step solutions pls (i give 5 stars) A freighter is moving at a speed of 8 nautical miles per hour. The engines then had to be suddenly stopped. If it takes 10 minutes for the freighter to reduce its speed to 3 knots, determine the distance moved by the ship and its speed at the end of this interval. The deceleration of the ship is propor-tional to the square of its speed such that a = -kV^2.
A material point moves along a straight path such that in 2 s it moves from an initial position SA = +0.5 m to a position SB = -1.5 m. Then, in 4 s it moves from the SB position to SC = +2.5 m. With that we will have that the average speed and the average speed of travel of the material point during the time interval 6 s are, respectively: Choose one:a. 1 m / s and 0.333 m / sB. 0.333 m / s and 1 m / sc. both equal to 1 m / sd. 0.4 m / s and 2 m / se. 2 m / s and 0.4 m / s
For the acceleration analysis question, how do you find tangential acceleration ab (a^t ab)?
In curvilinear kinematics, can tangential acceleration = net acceleration? If yes, when does it occur?
At t=0, a train approaching a station begins decelerating from a speed of 96 mi/hr according to the acceleration function a(t)=−1536(1+8t)-3 mi/hr2, where t≥0. How far does the train travel between t=0 and t=0.1? Between t=0.1 and t=0.3?
A ball is thrown vertically upwards with a velocity of 48 ft/s from the top of a building 35 ft high. How high from the top of the building will the ball go? Consider two objects moving along x-axis are starting at the same time. Their positions are measured in centimeters at time t in seconds. If the equation of motion of objects 1 and 2 are s1 = 2t2 -3t and s2 = 3t-t2 respectively, determine the distance between the objects at the instant when they have the same velocity. If , x = Arctant3 , y = √1+t6 find the value of a if 2ay'' / y' when t =√2
A bowler throws a bowling ball of radius R = 11 cm along a lane. The ball slides on the land with an intial speed vcom = 8.5 m/s and initial anbular speed ω0=0. The coefficient of kinetic friction between the ball and lane μk= 0.27. Use g = 9.8 N/kg. The magnitude of the linear acceleration of the bowling ball = 2.65 m/s^2 The angular acceleration of the bowling ball = 60.2 rad/s^2 Time it takes ball to slide - 0.92 s a) How far does the ball slide? b) Determine center of mass velocity when the sliding stops.