109) A customer complains that his vehicle will not move when first shifted into gear. Technician A says torque converter drainback could be the cause. Technician B says the vehicle may have to sit with the engine off for several hours before the concern is duplicated. Which technician is correct? O Technician A O Technician B O Both technicians A and B O Neither technician A nor B

109) A customer complains that his vehicle will not move when first shifted into gear. Technician A says torque converter drainback could be the cause. Technician B says the vehicle may have to sit with the engine off for several hours before the concern is duplicated. Which technician is correct? O Technician A O Technician B O Both technicians A and B O Neither technician A nor B

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter8: Preventive Maintenance And Basic Services

Section: Chapter Questions

Problem 8RQ: Technician A says that if a drive belt does not have the proper tension, it may produce squealing...

See similar textbooks

Similar questions

Technician A says that changes in engine load cause changes in hydraulic pressure inside the transmission. Technician B says that engine load is monitored by throttle pedal movement or by engine vacuum. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B
An engine cranks slowly: Technician A says that a possible cause of the problem is poor starter circuit connections. Technician B says that an engine problem could be the cause. Who is correct? Technician A Technician B Both A and B Neither A nor B
A vehicle is producing a sharp, metallic rapping sound originating in the upper portion of the engine. It is most noticeable during idle. Technician A diagnoses the problem as piston pin knock Technician B says that the problem is most likely a loose crankshaft thrust bearing. Who is correct? Technician A Technician B Both A and B Neither A nor B
True or False? The first step in removing an engine is usually the removal of the intake and exhaust manifolds.
Technician A says that if a drive belt does not have the proper tension, it may produce squealing and chirping noises. Technician B says belt tension should be checked even if the engine has an automatic belt tensioner. Who is correct? Technician A Technician B Both A and B Neither A nor B
While diagnosing an engine that overheats after frequent hard accelerations: Technician A checks for a collapsed lower radiator hose. Technician B checks the cooling fan electrical circuit. Who is correct? Technician A Technician B Both A and B Neither A nor B
Which of the following will cause one or more, but not all, firing lines to be higher than normal? a. High resistance in the spark plug wire b. Faulty fuel injector c. Defective spark plug d. All of the above
True or False? To eliminate the drain of engine power during times when cooling fan operation is not needed, many of todays belt-driven fans have a fan clutch that prevents the operation of the fan when the engine and radiator are heated up.
A small horsepower Briggs engine's spark plug is firing too late. Tech a says that the spark plug gap may be to small. Tech b says that the spark plug gap may be too big. Who is correct?
Technician A believes the stall test damages transmissions. This includes the torque converter clutch as well as other clutches and bands, says Technician B. Who is right? O Technician A Tech B, O O Neither technician A nor B
37- Technician A says that all transmission opening pressure are derived from the regulated output flow of the oil pump. Technician B says that every automatic transmission uses one, or more, pressure regulator valves. Who is correct? A- Technician A B- Technician B C- Both A and B D- Neither A nor B
Tech A says that the weight of the flywheel smoothes out the engine’s power pulses. Tech B says that the flexplate and torque converter perform this same function. Who is correct?