An urgent physical chemistry question!!!! 1A 4 The molar mass of a newly syntbesized fluorocarbon was measuredin a gas microbalance. This device consists of a glass bulb forming oneend of a beam, the whole surrounded by a closed container. The beam ispivoted, and the balance point is attained by raising the pressure of gasin the container, so increasing the buuyancy of the enclosed bulb. In oneexperiment, the balance point was reached when the fluorocarbon pressurewas 327.10 Torr, for the same setting of the pivot, a halance was reached whenCHE, (M= 70.014g mol") was introduced at 423.22 Torr. A repeat of theexperiment with a different setting of the pivot required a presure of 293 22Torr af the fluorocarbon and 427.22 Torr of the CHF, What is the malat massof the fluorocarbon? Suggest a molecular formula.

According to Ideal gas Law: PV=nRT where, P= pressure of gas, V= volume of gas R=universal gas…

1A4 The molar mas of a newly synthestred fluorucarbon was meanured in a gas microbalance. This device consists of a glass bulh forming one end of a beam, the whole surrounded by a closed container. The beam is pivoted, and the balance point is attained by raising the presure of gas in the containet, so increasing the buuyancy of the enclosed bulh In une experiment, the balance point was reached when the fluorocarbon pressure was 327.10 Torr, for the same setting of the pivot, a balance was reached when CHF, (M= 70014g mol') was introduced at 421.22 Tur. A repeat of the experiment with a different setting of the pivet required a pressure of 29322 Torr of the fluorocarhon and 427.22 Tort of the CHF, What is the melat mass of the fluorocarbon? Suggest a molecular formula.

1A4 The molar mas of a newly synthestred fluorucarbon was meanured in a gas microbalance. This device consists of a glass bulh forming one end of a beam, the whole surrounded by a closed container. The beam is pivoted, and the balance point is attained by raising the presure of gas in the containet, so increasing the buuyancy of the enclosed bulh In une experiment, the balance point was reached when the fluorocarbon pressure was 327.10 Torr, for the same setting of the pivot, a balance was reached when CHF, (M= 70014g mol') was introduced at 421.22 Tur. A repeat of the experiment with a different setting of the pivet required a pressure of 29322 Torr of the fluorocarhon and 427.22 Tort of the CHF, What is the melat mass of the fluorocarbon? Suggest a molecular formula.

Introductory Chemistry: An Active Learning Approach

6th Edition

ISBN:9781305079250

Author:Mark S. Cracolice, Ed Peters

Publisher:Mark S. Cracolice, Ed Peters

Chapter4: Introduction To Gases

Section: Chapter Questions

Problem 67E: The compression ratio in an automobile engine is the ratio of the gas pressure at the end of the...

See similar textbooks

Similar questions

What is the value of FP for a sample of gas whose temperature is -33.0 C and volume is 0.0250 L? What temperature is required to change the volume to 66.9 cm3?
5-39 An 8.00-g sample of a gas occupies 22.4 L at 2.00 atm and 273 K. What is the molar mass of the gas?
perform stoichiometric ca1cu1uions for reactions involving gases as reactants or products.
The gas in the discharge cell of a laser contains (in mole percent) 11% CO2, 5.3% N2, and 84% He. (a) What is the molar mass of this mixture? (b) Calculate the density of this gas mixture at 32C and 758 mm Hg. (c) What is the ratio of the density of this gas to that of air (MM=29.0g/mol)at the same conditions?
The compression ratio in an automobile engine is the ratio of the gas pressure at the end of the compression stroke to the pressure in the beginning. Assume that compression occurs at constant temperature. The total volume of the cylinder in an automobile is 350 cm3, and the displacement the reduction in volume during the compression stroke is 309 cm3. What is the compression ratio in that engine?
5-107 If 60.0 g of NH3 occupies 35.1 L under a pressure of 77.2 in. Hg, what is the temperature of the gas, in °C?
Methane (CH4) gas flows into a combustion chamber at a rate of 200. L/min at 1.50 atm and ambient temperature. Air is added to the chamber at 1.00 atm and the same temperature, and the gases are ignited. a. To ensure complete combustion of CH4 to CO2(g) and H2O(g), three times as much oxygen as is necessary is reacted. Assuming air is 21 mole percent O2 and 79 mole percent N2, calculate the flow rate of air necessary to deliver the required amount of oxygen. b. Under the conditions in part a, combustion of methane was not complete as a mixture of CO2(g) and CO(g) was produced. It was determined that 95.0% of the carbon in the exhaust gas was present in CO2. The remainder was present as carbon in CO. Calculate the composition of the exhaust gas in terms of mole fraction of CO, CO2, O2, N2, and H2O. Assume CH4 is completely reacted and N2 is unreacted.
A cylinder of compressed gas is labeled Composition (mole %): 4.5% H2S, 3.0% CO2, balance N2. The pressure gauge attached to the cylinder reads 46 atm. Calculate the partial pressure of each gas, in atmospheres, in the cylinder.
A McLeod gauge measures low gas pressures by compressing a known volume of the gas at constant temperature. If 315 cm3 of gas is compressed to a volume of 0.0457 cm3 under a pressure of 2.51 kPa, what was the original gas pressure?
P1A.6 The molar mass of a newly synthesized fluorocarbon was measured in a gas microbalance. is device consists of a glass bulb forming one end of a beam, the whole surrounded by a closed container. e beam is pivoted, and the balance point is attained by raising the pressure of gas in the container, so increasing the buoyancy of the enclosed bulb. In one experiment, the balance point was reached when the fluorocarbon pressure was 327.10Torr; for the same setting of the pivot, a balance was reached when CHF3 (M = 70.014 g mol−1) was introduced at 423.22 Torr. A repeat of the experiment with a di erent setting of the pivot required a pressure of 293.22 Torr of the uorocarbon and 427.22 Torr of the CHF3. What is the molar mass of the fluorocarbon? Suggest a molecular formula.
P1A.6 The molar mass of a newly synthesized fluorocarbon was measured in a gas microbalance. is device consists of a glass bulb forming one end of a beam, the whole surrounded by a closed container. The beam is pivoted, and the balance point is attained by raising the pressure of gas in the container, so increasing the buoyancy of the enclosed bulb. In one experiment, the balance point was reached when the fluorocarbon pressure was 327.10Torr; for the same setting of the pivot, a balance was reached when CHF3 (M = 70.014 g mol−1) was introduced at 423.22 Torr. A repeat of the experiment with a di erent setting of the pivot required a pressure of 293.22 Torr of the uorocarbon and 427.22 Torr of the CHF3. What is the molar mass of the fluorocarbon? Suggest a molecular formula.
Gaseous ammonia is injected into the exhaust stream of a coalburning power plant to reduce the pollutant NO to N2 according to the reaction:4 NH3( g) + 4 NO( g) + O2( g)----> 4 N2( g) + 6 H2O( g)Suppose that the exhaust stream of a power plant has a flow rate of 335 L/s at a temperature of 955 K, and that the exhaust contains a partial pressure of NO of 22.4 torr. What should be the flow rate of ammonia delivered at 755 torr and 298 K into the stream to react completely with the NO if the ammonia is 65.2% pure (by volume)?