2. A mixture of CO and O, is to be prepared in the proportion of 7 kg to 4 kg in a vessel of 0.3 m capacity. Ifthe temperature of the mixture is 15°C, determine the pressure to which the vessel is subjected. Ifthe temperature is raised to 40°C, what will then be the pressure in the vessel ? 1Ans. 29.9 bar, 32.5 bar]

2. A mixture of CO and O, is to be prepared in the proportion of 7 kg to 4 kg in a vessel of 0.3 m capacity. Ifthe temperature of the mixture is 15°C, determine the pressure to which the vessel is subjected. Ifthe temperature is raised to 40°C, what will then be the pressure in the vessel ? 1Ans. 29.9 bar, 32.5 bar]

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter2: The First Law Of Thermodynamics

Section: Chapter Questions

Problem 2.89E

See similar textbooks

Similar questions

Numerically evaluate for one mole of methane acting as a van der Waals gas at a T = 298 K and V = 25.0 L and b T = 1000 K and V = 250.0 L. Comment on which set of conditions yields a number closer to that predicted by the ideal gas law. pVT,n
Oxygen O2 ,at 200 bar is to be stored in a steelvessel at 20 0 C .The capacity of the vessel is 0.04m3 . Assuming that O2 is a perfect gas .calculate the mass of oxygen that can be stored in the vessel . Thevessel is protected against excessive pressure by a fusible plugwhich will melt if the temperature rises too high .At whattemperature must the plug melt to limit the pressure in the vesselto 240 bar ? .the molar mass of oxygen is 32 Kg/Kmol
7. Two vessels A and B of different sizes are connected by a pipe which valve. A pipe with a valve. Vessel A contains 142 L of air at 2,767.92 kPa, 93.33 OC. Vessel B, of unknown volume, contains air at 68.95 kPa, 4.44 OC. The valve is opened and, when the properties have been determined, it is found that the pressure and temperature of the mixture of gasses is 1378.96 kPa, and 43.33 OC. What is the volume of vessel B. Use R = 287.08 Joules/Kg-KO for Air
It can be useful to approximate the behavior of real gases. Imagine you find a gasapproximately obeys the equation of state p(Vm − b) = RT and that you decrease the volume.Based on this equation of state, would it be possible to liquefy this gas? Would you predict a gasbehaving this way has a critical temperature? Explain.
1. A perfect gas undergoes compression at constant temperature, which reduces its volumeby 3.08 dm3. The final pressure and volume of the gas are 6.42 bar and 5.38 dm3, respectively. Calculate the original pressure of the gas in (a) bar, (b) atm. 2. Consider an isothermal column of an ideal gas at 25oC. What must be the molar mass ofthis gas be if the pressure is 0.80 of its ground level value at (a) 10km and (b) 1km ? Please show complete solutions
What Is The Ideal-Gas Equation of State?
13.3p. If you allow one pound of carbon dioxide to sublime (change from CO2(s) to CO2(g)) at room conditions of roughly 1atm and 25C, what volume would it occupy?
The virial equation of state may also be written as an expansion in terms of pressure: Z = 1 + B'p + ... The critical constants for water, H2O, are 218.3 atm. 55.3 cm3 mol-1 and 647.4 K. Assuming that the expansion may be truncated after the second term, calculate the value of the second virial coefficientB' at the critical temperature.
A sample of propane (C3H8)(C3H8) is placed in a closed vessel together with an amount of O2O2 that is 3.10 times the amount needed to completely oxidize the propane to CO2CO2 and H2OH2O at constant temperature. Calculate the mole fraction of each component in the resulting mixture after oxidation, assuming that the H2OH2O is present as a gas.
Two guys where I grew up once threw a 25 kg chunk of sodium into the Eno River. When it hit the water, it exploded and shot back up into the air, over and over again for a few miles. Assuming that the pressure was 1 bar and 30 °C, how much work was done by the expanding gasthat was created by the reaction of sodium and water?
The Prandtl number of common gases at 1 atm is about 1 for a very wide range of temperatures. Why is that so? Please explain.
The isothermal compressibility, κT, of lead at 293 K is 2.21 × 10−6 atm−1. Calculate the pressure that must be applied in order to increase its density by 0.10 per cent.