Q: Sample Number of Fe content measurements mg/L on the sample 1 3 1.56, 1.45, 1.51 1.42, 1.39, 1.46…
A:
Q: On the Excel spreadsheet (available in the Lab folder on HuskyCT), enter the mass of KNO3 used and…
A: Trial number 1 2 3 4 Total volume of water, mL 14 16.5 19 21.5 Total volume of…
Q: Q1. A 100 g soil containing 20% smectitie mineral matter was mixed with 150 mL solution containing…
A:
Q: Complete this table for H,O: T, "F P, psia u, Btu/lbm Phase description 300 782 40 Saturated liquid…
A: Solution - According to the question - Given - The given problem is solved using steam tables by…
Q: 4. A 0.1475-M solution of Ba(OH)2 was used to titrate the acetic acid (60.05 g/mol) in a dilute…
A: Molar concentration, also known as molarity, is defined as the number of moles of solute present in…
Q: Calculate the solubility at 25 °C of PbCO3 in pure water and in a 0.0100M Pb(NO3)2 solution. You'll…
A: Given : Molarity of Pb(NO3)2 = 0.0100M
Q: Fine aggregate sample was tested to find its physical properties. The test results were as follows:…
A: Given data: Bulk specific gravity is G=2.45 Apparent specific gravity is Gm=2.5 Mass of vessel full…
Q: 1. Which balance would result in 0 degrees of freedom? Mixture 100 kg/h x=0.2 kg S/kg Xw=0.8 kg W/kg…
A: Here we have to find that which balance would result in zero degrees of freedom? The structure is…
Q: Calculate the heat loss or heat gain of the 3 solution mixtures (qrxn). Then calculate the ΔH for…
A: Mass = Volume × Density qreaction = Mass × Specific heat capacity ×temperature change
Q: boiling point boiling point BPtof pure A vapour composition liquid composition Bpt of pure B OA 1.0B…
A:
Q: 0 A foo Rmal/h stream that is 97 msle % Carbon betrachlorice Cccl4) and 3 % Carbon disulfide ccs) is…
A:
Q: Calculate the pl values after addition of the following volume 0.0500 M NH41 to 30.00 mL 0.0500 M…
A: The volume of AgNO3 = 30.00 mL The molarity of AgNO3 = 0.0500 M The moles can be calculated as…
Q: A liquid stream flowing at 100 g/min contains 0.3 mole fraction benzene (Mw=78) and the balance 0.7…
A: Given data mass flow rate of stream = 100 g/min mole fraction of benzene in stream Xb = 0.3 mole…
Q: Enumerate and describe the signs of emulsion instability. At least 5-7
A: Emulsions are combinations of two or more types of liquids, one of which is spread throughout the…
Q: 4. A 0.1475-M solution of Ba(OH)2 was used to titrate the acetic acid (60.05 g/mol) in a dilute…
A: Given data :- Molarity of Ba(OH)2 solution = 0.1475 M Molar mass of Acetic acid = 60.05 g/mol
Q: 1. A 4.59 mL sample of HCl, specific gravity 1.3, required 50.5 mL of 0.9544N NaOH in a titration.…
A:
Q: Select the closed system that contains the lowest molar concentration of gas dissolved in water at…
A: We know that higher the value of Henry's law constant Kh at a given pressure, the lower is the…
Q: (1/ The volume of an aqueous solution of KBr at 25 °C was measured at a series of molalities, m, and…
A:
Q: Describe the primary and secondary criteria for having achieved V ̇O2 max.
A: V̇O2 max (also maximal oxygen consumption, maximal oxygen uptake or maximal aerobic capacity) is…
Q: Substances A and B with capacity factors 6.3 and 11.4, respectively, are being carried by a mobile…
A: van Deemter equation is a plate height (H) equation, it gives a relation between plate height and…
Q: H.W. Fine aggregate sample was tested to find its physical properties. The test results were as…
A:
Q: Basis for extraction Nernst Distribution Law differences in solubilities of a solid and an impurity…
A: The solution is given below -
Q: 4. Demonstrate the effect of composition on chemical potential in following Fig. -Free surface-…
A: In the following figure, compartment-I has pure water(solute) and compartment-II has…
Q: 3-28 A 1.8-m3 rigid tank contains steam at 220°C. One-third of the volume is in the liquid phase and…
A: Introduction: In the above question two phases coexist in equilibrium ,thus we have a saturated…
Q: What volume (in mL) of the prepared high alcoholic elixir is needed if Rx requires 120 mL of an…
A: Answer: In this question we have to mix two different alcohol solution in such a combination that we…
Q: 2- Equivalent conductance of 1 M propanoic acid CH3CH2COOH 10 ohm cm? eq and that at infinite…
A:
Q: SeO2 Solvent/Heat H20 H3C. CH3 DDQ/C6H6 → ?. Reflux
A: Reaction 1 is selenium based oxidation of aldehyde which gives ketone at two position via 2,3…
Q: Complete this table for refrigerant-134a T, °C P, kPa v, m/kg Phase description -8 320 30 0.015…
A: Introduction : Refrigerant temperature is likely around 4–5 degree. It does not change with…
Q: 02. Comlete the following Table for water P, kPa T, °C U, m'/ kg u, kJ/kg Phase description 200…
A:
Q: (25.3-9) Find a 99% confidence interval for the mean of the copper content of a brass alloy sampled…
A:
Q: Using the Mg-Pb phase diagram below, if you start at point A and cool down very slowly to room…
A: Based on the vertical line M and starting from the origin of the given graph, phases are α solid and…
Q: Carboxylic acids, including fatty acids and benzoic acids, are often present in both municipal and…
A: As a result of a thorough waste characterization program and preliminary evaluation of the costs…
Q: Initial 1 Final-2 Volume Pressure Temperature Volume Pressure Temperature VI Pi V2 P2 80.0 mL 96 kPa…
A: ★ P1 = 96 KPa = 0.947 atm V1 = 80.0 mL = 0.08 L T1 = 27°C = (27 + 273 ) K = 300 K V2 = ? P2 = 99…
Q: expleain Humidification and dehumidification mass transfer operations with suitable example and…
A: Answer - Humidification mass transfer - The transfer of material between a pure liquid phase and a…
Q: Given the following data, prove that the distribution of benzoic acid in water and benzene follow…
A: The total number of moles/mass of benzoic acid is not given to calculate the extracted number of…
Q: When trying to calculate the Kav for glutamate dehydrogenase I keep getting a negative value using…
A: Glutamate dehydrogenase is an enzyme which has a role in living beings to generate ammonia for urea…
Q: A 5.00 ml sample of white vinegar is diluted in acetone and analyzed by GC-TCD using 1-propanol as…
A: Given options,
Q: If 500 mL of a 15% (v/v) solution of methylsalicylate in alcohol is diluted to 1500 mL, what will be…
A: Original stock volume was = 500 mL Final volume = 1500 mL So, dilution factor = final…
Q: What is meant by isothermal elution?How does temperature programming improve the separation?
A: Isothermal elution: A technique in which the column temperature remains fixed through out the…
Q: Make schematic sketches of the microstructures that would be observed for conditions of very slow…
A:
Q: 2-14. Estimate the critical temperature and critical pressure for a mixture of 80 weight percent…
A: Given:- Estimate the critical temperature and critical pressure for a mixture of 80 weight percent…
Q: Q2: (A) Sketch the following Miller indices: 1.[102] 2. (2110) 3.(312)
A: The planes are explained by Miller indices . These are the raceprocal of the intercepts of the each…
Q: 4. For the system in question 2, estimate tlGo for micellization if the molecular weight of the…
A: Gibb’s free energy (∆G)– Formula is, ∆G=∆H-T∆S Where, ∆G= Gibb’s free energy ∆H=change in…
Q: K.m 10,20,30 and 40 К. ol /hr of a mixture containing mol % of propane, n-butane, n-peutane, and…
A: I think some values are missing,as i have tried this problem.please look it once,I will solve for…
Q: Introduction for polymer molecular weight determination by dilute solution viscosity measurement.
A: The polymer is made by the combination of a greater amount of repeating units in the…
Q: 100 Membrane Potential 50 아 1-50 .100 K+ Membrane Current 300 1200 100 of -200 Na+ 3 msec -300…
A: The above picture is of axon potential picture.The function of nervous system is sensation,…
Q: 6. A 30-m vertical column of fluid (p = 1878 kg/m³) is located where g = 9.65 m/s². Find the…
A:
Q: T, °C Р. КРа v, m³/kg Phase description 50 7.72 400 Saturated vapor 250 500 110 350
A:
Q: 1. Part A Solution temperature = 24 °C ce%3D Conductivity of instrument grade water = 1.043 uScm!…
A:
Q: An analyte with a partition co-efficient of 4.0 is extracted from 10 mL of the aqueous phase (Phase…
A:
Step by step
Solved in 2 steps with 1 images
- Solid Na2S is slowly added to a solution of 1.0 x 10-3 M Cr3+ (with no change in volume). At what [S2-] will Cr2S3 start to ppt? For Cr2S3, Ksp = 1.0 x 10-20What volume (mL) of the prepared low alcoholic elixir is needed if the prescription requires 120 mL of an alcoholic elixir with 35% v/v alcoholic strength? Low alcoholic elixir alcoholic strength: 20% Low Alcoholic ElixirCompound Orange Spirit 10mLAlcohol 100mLGlycerin 200mLSucrose 320gPurified water, qs ad 1000mL High alcoholic elixir alcoholic strength: 79% High Alcoholic ElixirCompound Orange Spirit 4mLSaccharin 3gGlycerin 200mLAlcohol, qs ad 1000mL a 30.51 mL b 119.39 mL c 89.49 mL d 30.61 mLVolatile and semi-volatile compounds can be analyzed by GC
- 1-3: A stock solution of 70% v/v ethanol was diluted with distilled water to prepare 1L of 21% v/v ethanol. (Density of ethanol = 0.789 g/mL; MW of ethanol = 46 g/mol) 1. Determine the initial volume of 70% v/v ethanol used in the preparation. 2. How much water was added to the stock solution to make 1L of the final concentration? 3. The molarity of 5.0 mL of 70% v/v ethanol was found to be __________. 4-6: A solution contains 45.0 g of methanol, CH3OH, dissolved in sufficient water to give a total mass of 210.6 g. 4. Compute for the number of moles of the solute present in the given solution. 5. What is the mass (in kg) of water used to dissolve the solute from the given problem? 6. Determine the molal concentration of the said solution.Prepare 1500mL of 0.5N H2SO4 solution with specific gravity of 1.84g/mL and assay of 97%Give the molar concentration of hydrochloric acid with a specific gravity of 1.18 and has 37% (w/w) purity. MW=36.5
- Describe the primary and secondary criteria for having achieved V ̇O2 max.A 100 g soil containing 20% smectitie mineral matter was mixed with 150 mL solution containing 0.10 M Pb. CEC of pure smectitie is 110 emol(+)/kg. CEC of the soil (cmol(+)/kg) is:Use E5C.1(a) to Plot the data in excel. Place two data sets on the same graph: one for temp vs. x and one for temp vs y (remember, x and y are the mole fractions and they belong on the x-axis). Don’t forget to include the boiling points of the pure substances – they are data, too. Add a trendline (polynomial, 3rd order should work) to each of the coexistence lines separately. Scale the plot appropriately and use the graph to answer the questions. Then complete E5C.1(b)
- Six 50.0 ml volumetric flask 1-6 are labeled. 10.00 ml of 2.00 x 101 M Fe(NO3)3 solution was then pipet into each volumetric flask. A 1.00,2.00,3.00,4.00 and 5.00ml of 2.00 x 10-3M NaSCN solution was then pipetted to flask 2 through 6 respectively. A sufficient 0.10 M nitric acid was then added to each flask to make them total volume of 50.00ml. 1.a)Calculate the final Fe(NO3)3 concentrations for each. 1.b)Also how would you find the initial concentration of SCN- for each flask? Please show calculations to solutions.Thanks2.3-3 Calculate the Ksp of the following aqueous solutions: a) 3.60x10-5M Ag2CO3 b) 4.30x10-3M of Ag+ in Ag2C2O4 solution c) 4.80 mol of PbCrO4 dissolved in 2.00 L container.A second spectrophotometric method for the quantitative analysis of Pb2+ in blood yields an Ssamp of 0.712 for a 5.00 mL sample of blood. After spiking the blood sample with 5.00 μL of a 1560 ppb Pb2+ external standard, an Sspike of 1.546 is measured. What is the concentration of Pb2+ in the original sample of blood?
