Answered: 4. Find the inductance per unit length…

4. Find the inductance per unit length of a single-phase line shown (Fig. 1). Conductors a, b and care of 0.2 cm radius, and conductors d and e are of 0.4 cm radius. T 4m ** b 4m 6m Figure 1 4m

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.11MCQ

See similar textbooks

Related questions

Q: Draw the Bode plot for the following

A: The given function is,Ys=106s+1s+1+j100s+1-j100.

Q: The values of the components in a simple series RC circuit containing a switch (see figure below)…

A: In this question We need to determine the charge, current, rate of energy. We know Rate of energy…

Q: 5.3. A circular loop, of loop radius λ/30 and wire radius λ/1000, is used as a…

A: We need to analyse the given loop antenna. a)The radiation resistance of the loop is given by…

Q: 5. For the system in Figure 1, determine the output y[n] when the input x[n] is 8[n] and H(ejw) is a…

Q: Q2 Determine the current Iy in figure shown by using Nodal analysis method. 20 30 w 40 10 SA 20

Q: F(s) = 10/[s(s+2)(s+3)²]

Q: If the forward voltage drop on a diode is 774 mV, what is the current passing through it? Assume I s…

Q: hello, i’m studying coordinate system from electromagnetics. In the cartesian coordinate system,…

A: Solution: Part (A) In the cylindrical coordinate system, the coordinate variable phi is an angle…

Q: What will be the negative peak voltage (in V) of the circuit below if the diode Vth is 1.45 V…

Q: EX for finding the capacitance of Coaxial cable Let the potential between the two conductors is Vo…

Q: 7.14 Calculate the time constant of the circuit in Fig. 7.94. 20 ΚΩ 10 ΚΩ ΑΛΛ ΑΛΛΑ 40 ΚΩ ΜΑΛΛ 5 mH…

A: Given:

Q: Given the following circuit, solve for Io. Must use source transformation.

Q: 20.11 Obtain the state equation for the circuit shown in Fig. E20.14. Given L= 1H ; C=0.25 F ; R=59.

A: It is given that: L=1 HC=0.25 FR=5 Ω

Q: ANSWER: PROBLEM 11 A three phase 12 pole wye connected alternator has 24 slots/pole. It employs a…

Q: a What is the magnitude of voltage at node "1", to the nearest volt? b. What is the voltage at node…

A: The node voltages can be obtained by using the nodal analysis and the node equation can be obtained…

Q: - For e(t) = ³1 (a) Express E*(s) as a series. (b) Express E*(s) in closed form. (c) Express E*(s)…

A: When a binomial is raised to a number, the binomial expansion formulae are employed to determine the…

Q: According to Coulomb's Law, the force exerted by two charges is proportional to the product of the…

A: Let the two charges be Q1 and Q2 and distance between them be r units.

Q: Draw the Bode plot for the following

A: The given transfer function is,Ys=501+0.025ss1+0.05s.

Q: For the circuit Shown below draw the DC-lord line and determine the value of R2 so that the Q-Point…

A: The given circuit is a voltage divider bias, If analyzed on an exact basis the sensitivity to…

Q: Find the bias voltages and currents of the transistor circuit below.

Q: Use mesh/loop analysis Given a = 2, b = 4, c = 2, d = 1, e = 2, f = 3, g = 6, h = 5, x = 0, y = 0…

Q: The number of chords in the graph of the given circuit will be

A: Given circuit:

Q: This question asks for the magnitudes and phase angles of V1 V2 V3 and V4, i couldn't get the right…

Q: W X ➤ Z a. b. F Derive a truth table for the above circuit. G Determine the Boolean functions F(W,…

A: here we have to determine the function F and G and we have to write the truth table.

Q: الله 1 4 ^-- -4 4 xf41 ī ( ( Draw graph of (f(t)=f(+=')) 2 fit) is periodic and its period equals G

Q: A function y(t) satisfies the following differential equation : dy(t) + y(t) = 8(t) dt where 8(t) is…

A: We need to find out the output for given system .

Q: 200 mm square single core copper conductor cable operating at 22kV, 50Hz has the following…

Q: سدهه ± 10 k AR₂ чол 7 50v Calculate the Max- power deliver to RL.

Q: Consider the joint PDF: fx,y (x, y) = (1/15 0≤x≤5,0 ≤ y ≤ 3 otherwise. Find the probability that Y…

A: given here PDF and asked to find the Probability that y>ax where a=2.

Q: If the voltage Vx is 10.99 V, what will be the measured voltage if we take the output from the anode…

Q: For the circuit at right, answer with magnitude and angle in degrees: a) Line voltage Vab= ___ VRMS…

A: In this question We need to determine the line voltage, line current , neutral current and real…

Q: vi(t)u(t) + R L R C vo(t) See the dynamic RLC circuit shown above. It has a time dependent input of…

Q: The current and voltage at the terminals of the capacitor in the circuit in are where t is in…

A: Under steady state condition, a capacitor will behave as Open circuit. In d.c. analysis, the voltage…

Q: Draw the logic diagram for the following Boolean expression. The diagram should correspond exactly…

A: The given boolean function can be implemented by using the basic gates and the simplified expression…

Q: Find the value of C, in μF, if the energy stored in the capacitor in Fig.P6.28 equals the energy…

A: We need to find out the value of capacitance for given circuit .

Q: please where did the root 3 value come from

Q: The switch in the circuit has been in position a for a long time. At t=0 the switch is moved to…

Q: Learning Goal: To analyze an RC circuit to determine the initial voltage across a capacitor, then to…

Q: The voltage across a capacitor with the value C = 4 F is given by the waveform in Fig.P6.10. Find…

A: We need to find out current through capacitor for given voltage .

Q: In a series L-C circuit, the inductance and capacitance are 5 H and 2 HF respectively. of the…

A: Given data, Capacitance is given as C=2 μF. Inductance is given as L=5 H.

Q: Using D flip-flops, design a synchronous counter that counts in the sequence 1, 3, 0, 2, 1,.... The…

A: To design a synchronous counter that counts in the sequence 1, 3, 0, 2, 1, ..., we need to use a…

Q: Draw a multi-level, multiple-output, circuit equivalent to the following figure using NAND gates…

A: Answer : to draw the given logic diagram in NAND gates form

Q: 7. How many AM stations can be accommodated in a 150 kHz bandwidth if the highest modulating signal…

A: Solution: The bandwidth required to transmit an AM signal is twice the maximum frequency of the…

Q: 4. Solve for the circuit below, given the values specified. XC= IC= VR= PR= Es = 10V f = 10 KHz R1…

A: It is given that:

Q: For numbers 59-60, refer to the figure below + + (15) 1 B (A) (B) (C) (D) Which of the following is…

Q: The current and voltage at the terminals of the capacitor in the circuit in are i(t) = 3.5e-2500 mA,…

A: In this question We need to determine the value of Is , initial voltage across the capacitor and…

Q: Q19 v(1) 10 5 0 1 2 3 4 v(t) 1 F reee 1H The voltage v (t) across the parallel capacitor and…

Q: em 4. in Figure 5.6. 50 V min 4Ω e value of voltage tage shown 6Ω V

A: Given circuit:

Q: 4. For a simple two-generator power system with the following generation functions: F₁(P) = 120 +…

Q: In the circuit below what is the voltage VAB? lok ZK 12K 12K бок

Question

4. Find the inductance per unit length of a single-phase line shown (Fig. 1).
Conductors a, b and care of 0.2 cm radius, and conductors d and e are of 0.4
cm radius.
T
4m
9
**
b
4m
6m
Figure 1
4m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and DBC = 2·5 m. Find line-to-neutral capacitance per km if diameter of each conductor is 1·24 cm. The conductors are transposed at regular intervals
The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and DBC = 2·5 m. Find line-to-neutral capacitance per km if diameter of each conductor is 1·24 cm. The conductorsare transposed at regular intervals.
The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and DBC= 2·5 m. Find line-to-neutral capacitance per km if diameter of each conductor is 1·24 cm. The conductors are transposed at regular intervals. [0·0091 μF/km]
8/ The shape of the conductor sag in a span is a semi-circle. Select one: True False
The three conductors of a 3-φ line are arranged at the corners of a right angled isosceles triangle. If each equal side of this triangle is 2 m, find line-to neutral capacitance per km. Take the diameter of each conductor as 1·24 cm. The conductors are transposed at regular intervals. [0·0094 μF/km]
A.Derive the formula for the internal inductance in H/m of a hollow conductor having inside radius r1 and outside radius r2 and also determine the expression for the inductance in H/m of a single-phase line consisting of the hollow conductors described above with conductors spaced a distance D apart.
The three conductors of a 3-φ line are arranged at the corners of a right angled isosceles triangle. If each equal side of this triangle is 2 m, find line-to-neutral capacitance per km. Take the diameter of each conductor as 1·24 cm. The conductors are transposed at regular intervals.
A three phase, 11 KV, underground cable system, consider a single core of conductor radius 0.5 cm diameter and lead sheath of 1.25 cm. The core and lead sheath have been separated by two intersheaths with radius 0.75 cm and 1 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same.
The conductors of a 10 km long, single phase, two wire line are seperated by a distance of 1.5 m. The diameter of each conductor is 1 cm. If the conductors are of copper, the inductance of the circuit is ??
Find the capacitance in picofarad between inner and outer curved conductor surfaces shown in the figure containing two dielectrics, εr1 = 4.9 and εr2 = 3.5. Here r1 = 39.4 mm, r2 = 64.4 mm, α1 = 19.7 degrees, α2 = 41.2 degrees and L = 158.6 mm.
In a 10 km long three phase line the diameter of the conductor is 25 mm hence the conductors are symmetrically arranged with a space of 2 m.So find the capacitance per phase.
GMR of a bundled conductor for inductance calculations was found as 7 cm. A, B and C phases of a transposed transmission line have a horizontally flat arrangement with D = 10.8 m between the centre points of the three phases. Find inductance per phase per km of length. Express your answer in mH/km and leave 3 digits after decimal point