4. TLC is still useful in the lab but is being replaced by automated chromatographic methods. For example, TLC, FPLC, and HPLC are now automated processes, and computers can control various parameters, such as flow rate, blends of solvent mixtures, etc. Can you think of how the ability to manipulate the parameters of these automated chromatographic methods (sample size, column plate length, flow rate, solvent gradients, etc.) might accentuate or improve an investigator's ability to separate amino acids or other biomolecules?

4. TLC is still useful in the lab but is being replaced by automated chromatographic methods. For example, TLC, FPLC, and HPLC are now automated processes, and computers can control various parameters, such as flow rate, blends of solvent mixtures, etc. Can you think of how the ability to manipulate the parameters of these automated chromatographic methods (sample size, column plate length, flow rate, solvent gradients, etc.) might accentuate or improve an investigator's ability to separate amino acids or other biomolecules?

Principles Of Pharmacology Med Assist

6th Edition

ISBN:9781337512442

Author:RICE

Publisher:RICE

Chapter8: Forms Of Drugs And How They Act

Section: Chapter Questions

Problem 30RQ

See similar textbooks

Similar questions

1. What would be the effect of the following errors in chromatographic work? a. The solvent level in the developing chamber is higher than the spotted sample. b. Too much sample is applied to the paper. c. The paper is allowed to remain in the chamber after the solvent front has reached the top of the plate.
4. Attheendoftheprocedureforthisexperiment,arecrystallizationisdoneina mixed solvent system. Which solvents are used? In which solvent is caffeine LESS SOLUBLE? Briefly explain the significance (i.e. why it is done) of adding one of the two solvents, “to turn the solution faintly cloudy,” during the recrystallization
1. Why does fresh milk can form a film and sour milk cannot?
When a mixture of various molecular sized dyes are run through a gel chromatography column, what is eluted in the Void Volume? A. Blue Dextran B. Flourescein C. Both D. Nothing
3. What is the difference between common rich media and defined media?
1. What is the hazard of the spattering tendency in heating a wire loop with specimens over a flame? 2. Why is heat a highly effective sterilizing agent?3. Which of the three methods of heat sterilization is the most appropriate and practical to use in sterilizing antibiotic solutions? (Direct flame, Dry heat, Moist heat)
4) You are interested in the total bacterial load of the bat guano. In order to determine this, you go back to your original broth culture and prepare a dilution series. You then spread 100 ml of each dilution onto 3 separate plates. You obtain the following results: Plate 1, 10 -1 dilution: 362 colonies Plate 2, 10 -3 dilution: 76 colonies Plate 3, 10 -5 dilution: 8 colonies. Based on your results, calculate the CFUs/ml in your original broth culture. show your work
1. COMPARE AND CONTRAST the GEL FILTRATION and ISOELCTRIC PRECIPITATION in terms of the principles governing their functions. Explain it thoroughly and do not just cope it from somewhere.
1. What is the purpose of the oil when using oil immersion objective? 2. Why should the oil immersion objective be cleaned immediately after use?
In UV/Visible spectrophotometer analysis for a multicomponent system, there are only two dyes used in the mixture, the two proportions should be totalled to 1.0. but on finding You got 0.6 in total. Explain the reasons for the difference.
Which of the following statements about AAS and AES is FALSE a)Sample used in AAS are usually in the form of aqueous solution b)In flame AAS, the flame is used for atomization as well as excitation purpose c)The graphite furnace is an example of non-flame atomizer d)In flame AES, no light source is required. What is the advantages of Axial torch configuration over Radial configuration in Inductive Couple Plasma-Optical Emission Spectrometer (ICP-OES) a)Increased radiation intensity – a longer path length b)Excellent tolerance to dissolve solids c)Can analyze S, P, and Halogens d)Excellent torch lifetimes
2. How many milliliters of water would you need to make a 10-2 dilution using 10ml of a culture?