7. CH3 CH3CONA _(7a) _(7b)__. + NaCI CH3 (8). H20 CH3CO CH3 +

Q: Which of the following is more likely soluble in Benzene, C6H6? Explain.  a) CCl4 or NaCl

A: Benzene is  a organic solvent Due symmetry it is nonpolar  Hence organic compounds can dissolve in…

Q: What would happen to the solubility of BaSO4BaSO4in a 0.10 M CaSO4 solution in comparison to its…

A: To check the affect of solubility , we would Calculate solubility of BaSO4 in water and CaSO4 using…

Q: is Cyclohexane soluble in CH2Cl2, water, NaOH, or H2SO4?

A: Cyclohexane has the chemical formula C6H12. Cyclohexane is a non-polar substance. Cyclohexane is a…

Q: 4. A. Identify the set-up: B. Function: organic H.O HO HSO OH snoonbe 15. A. Identify the set up: B.…

A: A. The setup shown in figure is separation by funnel.      B. FUNCTION Basically this separation…

Q: Volume of concentrated reagant required to prepare diluted solutions below: 16 M H3PO4 to prepare…

A: Given Four different diluted solutions whose volume of concentrated reagent is to be determined.

Q: O How much oxygen you need and how much carbon dioxide and water you will produce by fully oxidizing…

A:

Q: 5- The effect of ionic strength on protein solubility is attributed to: a- the decrease in…

A:

Q: 1) O3 Ph 2) Zn, H20 3) NaOH, H2O heat (dehydration) 1) (excess) KMNO4, CH3 NaOH, H2O, heat 9. 2)…

A: Ozonolysis of olefins produce the carbonyl compounds. This carbobyl compound undergoes aldol…

Q: Select the one statement below that is TRUE.

A: The process of osmosis can be properly explained by a U-tube model. If a U-tube is divided into two…

Q: Volume of Volume of 0.1 M HCI solution Volume of Concentration 0.2 M Na,s,0, Time (s) distilled of…

A: Titration is the quantitative method of estimating the strength of the any component. Molarity is…

Q: 1. NaH Me ENO I Me 2. A 1. xs Mel 2. Аg:0, H,0, 4 В 1. NaNg 2. LIAIH, 3. aqueous workup H3O", A но.…

A:

Q: If you titrate 25.00 ml of a 530. mg/L ascorbic acid solution, boil it for 15 minutes and then…

A: KIO3 liberates iodine as: KIO3+5 KI+6 H+→3 I2+6 K++3 H2O

Q: grams of glucose C12H22011 are dissolve 1360grams of water. а. 0.00 b. 0.20

A: Molality is defined as number of solute present in 1000 gm of water.   Mole= MOLality×mass of…

Q: An alcoholic drink contains methanol (CH3OH; density of 0.792 g/mL), in which at high dosage, is…

A: Given that, an alcoholic drink contains methanol (CH3OH: density of 0.792 g/mL), in which at high…

Q: What is the solubility of HgI2 in water? The Ksp for HgI2 is 4.0X10^-29

A: Ksp formula  used HgI2 = Hg2+ + 2I-               S             2S

Q: Indicate the mols present in the following so lution: a) 0.25 M BaCl2 in 1 liter b) 0.25 M C2H5OH in…

A: BaCl2 gives Ba2+ and Cl-.Hence 0.25M and 2×0.25M. That is 0.5MNumber of moles is the product of…

Q: What is the principal organic product formed in the reaction? но, H2SO4 ? reflux

A: Benzyl alcohol when heated with sulphuric acid reflux produces polymerized product.

Q: QUANTITY OF THERMOTOLERANT COLORFORM BACTERIA, WHICH IS ALLOWED IN 100 ML DRINKING WATER OF…

A: Option 4) lack of

Q: Lahen 9 5o1d is Impure, Its muting Point is higher and broader Tran the muhng unt fur pure Sampleã.…

A: When a pure substance is added with an impurities than the Properties like Melting point, boiling…

Q: A sample of 6 M 10 mL H2SO4 is diluted to 100 ml. Calculate the concentration ( in gravimetric…

A: On the dilution of an acid, the concentration (molarity) of the solution decreases. The number of…

Q: A student took 6 g ethanol (density 1.5g/ml) and made a cream of them whose total weight = 200g,…

A: The mass of ethanol is = 6 g The total mass of ethanol and cream is = 200 g The percent…

Q: Extracellular Intracellular Nernst potential (370C, mV) lon Concentration (mM) Concentration (mM)…

A: [Na+]outside =165 mM [Na+]inside =15 mM [K+]outside =16 mM [K+]inside = 220 mM Temperature, T = 37°C…

Q: What is the solubility of KClO3 at 30 oC?  At what temperature will the solubility of NaCl be equal…

A: Given chart is: To find the solubility of KClO3 at 30oC and the temperature at which the solubility…

Q: 6-ROX is a dye with a molecular weight of 631.67 g/mol. A student prepares a stock solution by…

A: Given: mass of 6-ROX = 0.275 g molar mass of 6-ROX = 631.67 g/mol Volume of solvent = 500.0 mL…

Q: Over time, as their free fatty acid (FFA) content increases,edible fats and oils become rancid. To…

A: Rancidity: Rancidity is a general phenomenon where, fat and oil of food or other eatable item get…

Q: An impure sample of  130 mg of adipic acid was dissolved in 1.0 mL of boiling water. What is the…

A: Given:  Mass of adipic acid sample = 130 mg  Volume of water = 1.0 ml  Solubility at 0°C = 0.3 g/100…

Q: Solubility or Miscibility (soluble or insoluble; miscible or immiscible) Compound Cyclohexane…

A: As no particular solvent is mentioned. so we are considering solvent water. I On basis of this…

Q: What are the mole fraction and the mass percent of a solu-tion made by dissolving 0.30 g of KI in…

A: Substitute 0.4 L as volume and I g/mL as the density of water in the expression of density to…

Q: S- BIOL111ASP2020 B Canvas Login at Mary Baldwin Un x Chemistry 121 101 Chem101 Question 1 of 29 In…

A: An acidic substance is the substance that can give H+ ions. They are corrosive and sour in nature.…

Q: If 0.100 mol glucose (C6H12O6) is dissolved in 0.100 L solution, what will be the concentration of…

A:

Q: A 0.1ml serum sample was analyzed for glucose content and found to contain 250 ng. The concentration…

A: Given that:  Volume of serum sample = 0.1ml =0.1ml×1L/1000ml = 10-4L Mass of glucose = 250ng =…

Q: If Mg(OH)2 has a Ksp of 7.0 × 10–7, then what is the solubility of Mg(OH)2 in pure water in g/L?

A:

Q: OH and 0.20M NaCH3COO? !! II 12 2.

A: Buffer : those solution which resist to change the pH when small amount of acid or base add in this…

Q: below? d6-DMSO solution -a.55 -G.45 -0.35 La30 La2s -0.20 Lais 0.00 3.05

A: The characteristic peak is at 4.7ppm which is due to strong dis

Q: A chemist wants to extract a solute from 100 mL of water using only 300 mL of ether. The…

A:

Q: 1-melting point helps to identify unknown samples. true or false 2-the reaction of one mole of hydro…

A: 1-melting point helps to identify unknown samples. True Reason: melting or depression in melting…

Q: 4. All the CaSO4 present in 0.511g of an impure sample of plaster is converted to 0.821g BaSO4 What…

A: Given mass of impure CaSO4 = 0.511 g mass of BaSO4 = 0.821 g The impure CaSO4 is converted into…

Q: What is the solubility of Cd₃(PO₄)₂ in water? (Ksp of Cd₃(PO₄)₂ is 2.5 × 10⁻³³)

A:

Q: 7. cold, dilute OH II OH DH DH OH TV 日

A: The addition of KMnO4  on the double bond is called hydroxylation reaction. In this reaction syn…

Q: Which solution has the highest concentration of sucrose (C12H22O12): a) a solution of 46% by mass…

A: Given,  a) A solution of 46 % by mass of sucrose solution with density 1.21 g/mL. b) A 1.50 M…

Q: H. ОН PCC .COOH COOH or Na,Cr,0/ OH HNO, or HOAC KMNO, or NaOCI Cyclohexanol bp 161.5°C, den. 0.96…

A: The required mechanism is shown below Here initially oxidation of secondary alcohol to a ketone…

Q: Explain how you would create a 1:1000 dilution of your protein stock solution.

A: Solution: In colorimetry generelly we require very dilute solution. So the major step is obtain the…

Q: rbic acid (C6H8O6) + I2 → 2 I− + dehydroascorbic acid (C6H6O6)   Calculate the mass of Iodine that…

A: Molarity is defined as “the mole of the solute per unit volume of the solution”. It is represented…

Q: Bennt yd 9gOOUP 75. How many liters of a 0.500 M sucrose (C12H22011) solution contain 1.5 kg of…

A:

Q: 750 wwi.f Hy 1o0% collectron efficenly

A: Given: Concentration of methane given = 25 µg/mL.

Q: Prepare 100ppm of Cd (NO3).4 H2O in a 500ml

A: Given information, Concentration (in ppm) = 100 ppm Volume of solution = 500 mL

Q: What is the molar concentration of HNO3 (63.0 g/mol) in a solution that has a specific gravity of…

A:

Q: Temperature and concentration values. {H2} {l2} {HI} K (°C) a 25 0.0388 0.000474 0.000163 b 340…

A: At 25 degrees: [H2]=? [I2]=0.0388 M [HI]=0.000474 M K=0.000163 K=[HI]2/[H2][I2]…

Q: 320 g of a sample of Mg with a coating of Mgo on its surface needed 20 ml 0.1 M HCL for complete…

A: