8051 MICROCONTROLLER PROGRAMMING USING ASSEMBLY LANGUAGE, MOST OF THE CODES I GET FROM HERE USES 8086 MICROCONTROLLER, PLEASE DO USE 8051 ASSEMBLY LANGUAGE, I DO NOT NEED ONE WITH 8086. Given arbitrary 8-bit number, check whether it is bigger than signed decimal - 10, if it is bigger than -10, move #Y' to R5, if not move #'N' to R5.

Give a brief explanation of the two hardware methods for determining priority.

How does the width of a register relate to the number of D-flip-flops used in the circuit? Each register is implemented with one D-flip-flop, regardless of the width of the register. Each bit in the register corresponds to two D-flip-flops. Each bit in the register corresponds to a D-flip-flop, so it is 1-to-1. Since D-flip-flops have a Q and Qn output, you only need 1 D-flip-flop for each bit in the register.

Write an assembly program using MARIE that will do the following:Given three numbers (X, Y, and Z), find the product of X and Y (called PROD for reference)Using this product as a dividend, find the quotient and remainder when divided by Z as thedivisor.Use the values:X = 5, Y = 3, and Z = 4