A 150 pounds of (NaCI) is dissolved in the solution in container A and 100 pounds of (NaCI) is dissolved in the solution in container B. The system is closed in that the well-stirred liquid is pumped only between the containers, as shown in Fig. (A)Calculate the number of pounds mixture Of salt at time t in 3 gal/min containers A and B. (B) what is the relation between the variables x1(t) and x2(t) that holds at time t. Explain why this relation makes intuitive sense. Use this relation to help find 100 gal 100 gal mixture the amount of salt in tank B at t = 15 min. 2 gal/min

A 150 pounds of (NaCI) is dissolved in the solution in container A and 100 pounds of (NaCI) is dissolved in the solution in container B. The system is closed in that the well-stirred liquid is pumped only between the containers, as shown in Fig. (A)Calculate the number of pounds mixture Of salt at time t in 3 gal/min containers A and B. (B) what is the relation between the variables x1(t) and x2(t) that holds at time t. Explain why this relation makes intuitive sense. Use this relation to help find 100 gal 100 gal mixture the amount of salt in tank B at t = 15 min. 2 gal/min

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter33: Automated Methods Of Analysis

Section: Chapter Questions

Problem 33.6QAP

See similar textbooks

Similar questions

Two tanks are connected by a series of pipes as shown below. Tank 1 initially contains 150 grams of salt dissolved in 20 liters of water, while tank 2 contains 50 grams of salt dissolved in 10 liters of water. Beginning at time t = 0, pure water is pumped into tank 1 at a volumetric flow rate of 3 liters per minute. This causes brine to flow between the tanks, and to flow out of both tanks at the volumetric flow rates shown in the Fig. 2. Determine the salt concentration in each tank (C, and C2) at any time t>0.
A tank, containing 1520 liters of liquid, has a brine solution entering at a constant rate of 3 liters per minute. The well-stirred solution leaves the tank at the same rate. The concentration within the tank is monitored and found to be c(t) = e(-t/800)/80 kg/L. Determine the amount of salt initially present within the tank. Initial amount of salt = ? kg. Determine the inflow concentration cin(t), where cin(t) denotes the concentration of salt in the brine solution flowing into the tank. cin(t) = ? kg/L
A 0.064 kg of octane vapor (MW = 114) is mixed with 0.91 kg of air ( MW = 29 ) in the manifold is 86.1 kPa, and the temperature is 290 K. Assume octane behaves ideally, what is the total volume of this mixture. Show unit analysis and conversion on solution. Round off to four decimal places.
A solution containing 100 lbm KNO 3/100 lbm H 2O at 80°C is fed to a cooling crystallizer operated at 25°C. Slurry from the crystallizer (KNO3 crystals suspended in saturated solution) is fed to a filter, where the crystals are separated from the solution. Use the solubility data in Figure 6.5-1 to determine the production rate of crystals (lbm/lbm feed) and the solid-to-liquid mass ratio (lbm crystals/lbm liquid) in the slurry leaving the crystallizer.
. Compatible Polymers A and B are to be blended to achieve a glass-transition temperatureof 60 oC. Tg’s of Polymers A and B are 30 and 85 oC, respectively, using an appropriateequation determine the composition of the blend.
Polycarbonate, PC, is used for aircraft canopies. A batch of this polymer was found to fail prematurely when impacted by a 4 pound bird during qualification studies. You suspect that the problem is due to a molecular weight difference for this particular batch of polymer compared to previous batches. You decide to perform dilute solution viscosity studies to determine the Mol.wt. Assume density is 1.2g/cm3 What solvent would you use? Justify your answer Please answer very soon will give rating surely
A lake with a surface area of 525 acres was monitored over a period of time. During a one-month period the inflow was 30 cubic-feet/second (cfs), the outflow was 27 cfs, and a 1.5-in. seepage loss was measured. During the same month, the total precipitation was 4.25 in. Evaporation loss was estimated as 6.0 in. Estimate the storage change for this lake during the month.
An environmental study was performed to measure the transport of a DDT (a banned pesticide) throughout the globe. A lake in northern Canada was sampled to see if low levels of DDT were present there in spite of it not being administered within 1000 miles of that location. 1.000 L of the lake water was spiked with 100.0 uL of a 2.451 ug/L solution of tetrachlorobenzene, which acted as the internal standard. The entire 1.000 L spiked solution was concentrated onto an SPE column. After washing the SPE column with ~5 mL of pure water, the analyte and internal standard were eluted from the SPE column using ~5 mL of CH2Cl2 solvent. The eluted sample was evaporated under a stream of nitrogen to a final volume of 1.000 mL. 1 uL of this final solution was analyzed using GC-MS, and gave a signal of 24835 for DDT and 11597 for tetrachlorobenzene. To calculate the response factor, a standard solution was prepared consisting of 1.482 ug/L of DDT and 2.451 ug/L of tetrachlorobenzene.…
A chart is prepared by plotting In Ksp versus 1/T, using data obtained by performing a lab experiment. Refer to the attached photo for reference on how to solve these equations. Particularly #5 should be useful: A linear fit of the data in the chart yields the equation y = (-5.0020x10^3)x+(2.100x10^1) with an R2 value of 0.9922. Determine the enthalpy (deltaH in kJ) associated with dissolving KNO3. Answer in scientific notation with appropriate sigfigs.
Electrolytic manganese dioxide can be prepared from manganese carbonate ore by crushing,milling and leaching the ore in sulphuric acid. Manganese sulphate is crystallised from thesolution, redissolved and electrolysed to give the manganese dioxide.If the crystallisation were performed in a 30m3 tank and the concentration of the solutionentering the tank were 160 grams per litre and left the tank at 40 grams per litre, how muchMnSO4.5H2O would be produced.
50 mg of granular salt is briefly stirred into a glass container of 1/5 liter volume filled with water. After briefly mixing, some salt is still seen at the bottom of the class. The visible salt is filtered from the water, weighed and determined to have a mass of 20 mg. What is the dissolved phase concentration of salt remaining in the water? Provide your answer to the nearest whole number in units of mg/l.
Table 1 below shows the data for the filtration of fruit juice to produce clarified fruit juice at 298.2 K. Table 1: Total volume of filtrate collected at certain time V * 103 (m3) t (s) 0.5 17.3 1.0 41.3 1.5 72.0 2.0 108.3 2.5 152.0 3.0 201.7 The filtration process was conducted at a constant pressure of 46.2 kN/m2. The area of the plate-and-frame the press was 0.0439 m2, and the pulp concentration was 23.47 kg solid/m3 filtrate. a) Convert the data in Table 1 into a graph. You can either use Excel or graph paper. Your graph should be self-explanatory. b) Using the graph in (a), estimate the specific cake resistance and the resistance of the filter medium to filtrate flow.