A 4 pole shunt generator has an armature current of 60 A. It has 128 armature conductors connected to the wave. The brushes are shifted by 2 commutator segments. Then find the demagnetizing and cross magnetizing ampere turns per pole.

Q: Simplify F(A,B,C₁, D₁E) = {m (0₁4, 7, 8, 9, 12, 16, 18, 20, 22, 23, 24, 25, 26, 27, 28, 30) using a)…

A: Given function: A five-variable function, F which is expressed as, F(A,B,C,D,E) = Σm…

Q: A d.c. A shunt generator delivers a load current of 80 A at 400 V. Its armature and field…

A: Solution: Given data: shunt generator: V=400 V, load current IL=80 A, armature resistance  Ra=0.2Ω,…

Q: Discussion of power quality aspects that need to be considered before installing the power factor…

A: power factor correction aims to improve power factor and therefore power quality. It reduces the…

Q: What is the reserve capacity, if the maximum demand of generation of power is 50 MW, the load factor…

A: Given, Maximum demand MD=50 MW. Load factor LF=60%=0.6. Plant capacity factor PCF=50%=0.5.

Q: Simplify the following equations: X = ABC + AC

A: Given, The expression is X=ABC+A¯C.

Q: Draw the following functions: 1-Y=X - [X]; for -2 < x < 2

A:

Q: The coil of a relay takes a current of 0.15 A when it is at the room temperature of 25°C and…

A: We and relay coil with, At 25° C it takes Current (I) = 0.15 A Supply voltage (V) = 80 V   Minimum…

Q: Consider the following section of a multiloop circuit, with current directions as indicated: zero B…

A: Given circuit,

Q: Determine the product of (1 + i) and (1-3i) (A) 4-2i B) 2-2i C) 2-4i (D) 2+4i

A: Given: To determine the product of 1+i and 1-3i.

Q: Calculate the distribution factor for a single-phase alternator having 8 slots/pole (1) when all the…

A: We have been asked to find the distribution factor (Kd) of the a single-phase alternator having 8…

Q: 1.You are synthesizing a chip composed of some logic with an average activity factor of 0.1. You are…

A:

Q: 1A ( 4 ww 3Ω 8F + - The circuit above is in DC steady state. What is the value of v, in volts? VC 5Ω…

A:

Q: Bandwidth is the:  A) a measure of the width of a range of frequencies B) the rate of data transfer…

A: In filter circuit   it allows only certain range of frequency . The range of frequency is called…

Q: 6 In terms of their constructional features, transformers are classified in to: Core and Shell Types…

A: A transformer is an electrical energy transfer static device that either steps up or steps down the…

Q: B. Find, graphically, y(t) = f(t) * h(t) where h(t) = 8(t)- 8(t-1) and f(t) is the signal shown 2 1…

A: Given:

Q: PROBLEM Consider a parallel connection of two subsystems shown below U(S) 1 s+1 3 s+4 Obtain the…

A: Given: Parallel connection of two subsystems is shown,

Q: An electrical circuit consisting of an inductor, L, and a capacitor, C, in series is shown in Figure…

A:

Q: Write an 8085 microprocessor Assembly Language Program to add two 16 bits numbers? If the frequency…

A:

Q: Two lengths of conductors are made from, i) a single solid copper wire of radius 5 mm, and, ii) a…

A: Given data: i) single solid copper wire, radius, r = 5 mm ii) Bundle of 25 copper wire, radius, rb =…

Q: Find the F.T. of the following Signals using differentiation prop. №. 2 2 +t Ans F(w) = 4(sinc(w) -…

A: A function's differentiation in the time domain is equal to multiplying its Fourier transform by a…

Q: Exercise (3): Show that Z = dz di(z,t) dz R+ joL VG+jwC using the equations: v(2,1)= V(z)e and…

A: Given : ∂vz,t∂z=-Riz,t-L∂iz,t∂z∂iz,t∂z=-Gvz,t-C∂vz,t∂z vz,t=Vzejωtiz,t=Izejωt Find:  The equation of…

Q: 35. Fig. 29.17 shows the single line diagram of a 3-phase transmission line. The three phase short…

A: Given a single line diagram of 3-phase transmission line. The two fault points are F1 and F2.

Q: . A Si diode at a temperature of 25°C has VD = 0.7V at Is = 10nA. The temperature is raised to…

A:

Q: 7.8 The cost of a 3-phase overhead transmission line is Rs (25000 a + 2500) per km where 'a' is the…

A: We have an 3-phase overhead line which has, Cost of transmission line = 25000 a + 2500 Rs/KM a =…

Q: Q2\ For the circuit shown in Figure below, Determine the range of V, that will maintain V₁ at 8 V.…

A: In this question we need to find a range of input voltage that will maintain Vl at 8 V.

Q: Is it more efficient to heat your home with a natural gas furnace or an electric furnace? Explain?

A: Natural gas furnace and electric furnace both are used to generate heat. But the natural gas has the…

Q: The field winding of a 4-pole dc generator consists of 4 coils connected in series, each coil being…

A: We have an DC generator having,   Poles (P) = 4 Number Coil  = 4 Each coil turns = 1200  Initial…

Q: Simplify the following functions, and implement them with two level NAND gate circuits: F (A, B, C,…

A: It is given that: F (A, B, C, D)=A′+B+D′+B′C

Q: 10. When there is 12 mA of current through a 1.2 kn resistor, the voltage across the resistor is

A:

Q: H.W A 15nc Point charge is at the origin in Free Space calculate V₁ if Point Pi Vielf beated P,…

A: An area of space surrounding an electrically charged particle or object known as an electric field…

Q: Figure P2.11 40 V (+ a. Find i. find the power supplied by the voltage source. 2.5 ΚΩ

A: Given circuit:

Q: C₁ = [0.05P2 + 20P₂ + 30]; $ hr C₂ = [0.056P2 + 15P₂ +40]; hr Here P₁ and P₂ are in MW. Each…

A:

Q: List the eight degenerate two-level forms and show that they reduce to a single operation. Explain…

A: Two-Level Logic:- A logic design that only employs two logic gates between input and output is…

Q: Electric hairdryer consumes 500 W of power. The voltage supplied by wall outlet is Vrms = 84.85 V.…

A: Given, Power consumed by electric hair dryer P=500 W. Voltage supplied by wall outlet Vrms=84.85 V.…

Q: A 12 pole, 50 Hz, 3 phase induction motor has rotor resistance of 0.12 ohm and standstill reactance…

A: We have an 3-phase induction motor having, Poles (P) = 12 frequency (f) = 50 Hz Rotor resistance…

Q: Find the equivalent inductance between A and B if L₁ = 6 H, L₂ = 6 H, L3 = 20 H, L4 = 8 H and L5 =…

A: Given circuit, L1=6 HL2=6 HL3=20 HL4=8 HL5=10 H

Q: What is the current through the resistor in the following circuit, if AV=20 V and R= 100 S2? A. 20…

A: Given circuit, where, Voltage, ∆V=20 V Resistance, R=100 Ω

Q: Find the value of current I in given figure

A:

Q: Low power factor has some adverse impact on both the transmission line and on the consumer…

A: “Low power factor has some adverse impact on both the transmission line and on the consumer…

Q: A 6 pole wave wound d.c. shunt generator has 500 conductors. A generator delivers 50 kW of power at…

A:

Q: A protective put can be used for risk management.   A. TRUE B. FALSE

A: ANSWER      TRUE          A protective put can be used for risk…

Q: hybrid parameter his (a) (c) O + V₁ ww R₁ (aR3 + R₂) R₂ + R₂ (1-α) R₂ R₂ + R3 ww network as shown.…

A:

Q: 2. What is the current through R₂? VS1 15V R1 68 A. 3.19 A B. 319 mA D. C. 1.73 A 173 mA VA R2 30 22…

A: Circuit is given as;

Q: The graph of a network has 12 nodes and 7 independent loops. The number of branches of the graph is…

A: Given the graph of the network has, Total number of nodes, N=12. Total number of independent loops,…

Q: 22. Find Ck for Sequence X (n) =) 0.1.1.9.1.1.0.1.1.1

A:

Q: 1. Find voltages V₁, V2, and V3. SA ← 20 4.2 Mr t V₂ 62 10 A

A: We need to find out node voltage for given circuit

Q: 3.1 3.2 3.3 3.4 3.5 3.6 Utwag November 2016 Does diagram 4 tell you to screw the nut in or to…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Two signals m(t) and m₂(t) both band limited to 5 KHz are to be transmitted simultaneously over a…

A: Given:

Q: speed from full-load to no-load is 2 % in one machine and 3 % in the other; the characteristics…

A: It is given that: Two  50 MVA , 3 phase alternator working in parallel: for machine 1⇒full load to…

Q: Determine the transfer function G(s)=θ1(s)/T(s). *note second picture is for clarity

A: In the given questions we need to calculate the transfer function of the given mechanical systems.

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.