A 8 pole wave wound shunt generator delivers 205A at a terminal voltage of 200V. Ra and Rsh are 0.070 and 350 respectively. Neglecting brush drop, determine (i) armature current (ii) current per parallel path (iii) generated voltage and (iv) Power developed.

A 8 pole wave wound shunt generator delivers 205A at a terminal voltage of 200V. Ra and Rsh are 0.070 and 350 respectively. Neglecting brush drop, determine (i) armature current (ii) current per parallel path (iii) generated voltage and (iv) Power developed.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.5P

See similar textbooks

Related questions

Q: In a long-shunt compound generator, the terminal voltage is 220 V when generator delivers 110 A.…

Q: . Discuss about the excitation system of Synchronous generator.

Q: (a) Give comparison between salient pole and non-salient pole type synchronous generator.

A: Note :- We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: Q: (A): Draw the general per-phase equivalent circuit of a two-winding (2-phase) motor, based on the…

A: to explain symmetrical stator winding

Q: What is load capacity? What is the load capacity of a typical residential area, a city? What…

A: LOAD CAPACITY Basically it is the maximum demand,stress or load that can be placed on a given system…

Q: The single line diagram of figure below shows a generator connected through parallel transmission…

A: when a 3 phase fault occurs at any of the middles of one of the transmission line then the…

Q: A shunt generator supplies a 25kW load at 205V through cables of resistance, R = 112mQ. If the field…

Q: A 1000 kVA, 6.6 kV, 3-phase star connected cylindrical pole synchronous generator has a synchronous…

A: Given values are - S=1000kVAVt=6.6kVXs=20ohmUnity power factor.cosϕ=1

Q: Or (a) For a compound de generator, there are three windings which are shunt field winding, series…

A: According to question: The circuit of compound dc generator will be as given below:

Q: How does field distortion affect commutation ? ( DC GENERATOR QUESTION)

A: The armature reaction cause the alteration with the main field and cause the demagnetization or the…

Q: A 4 pole wave wound shunt generator delivers 195A at a terminal voltage of 205V. Ra and Rsh are…

A: It is given that: Vt=205 VIL=195 ARa=0.05 ΩRsh=70 ΩP=4

Q: Discuss about Generator modeling in transient stability and derive the formula for the real and…

A: In transient stability analysis of the generator, because of large disturbance linearisation of…

Q: Explain the concept of load transfer between the DC generators operating in parallel using load…

A: to explain the concept of load transfer between the DC generators operating in parallel using load…

Q: A 6 pole wave wound shunt generator delivers 185A at a terminal voltage of 235V. Ra and Rsh are…

A: Use equivalent model of dc shunt generator to find all remaining parameters

Q: A power plant comprises three turbine-generators rated 1000 MW, 800 MW and 500 MW respectively. The…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: Turbine operating efficiency is not influence to maintain the minimum cost of power generation True…

A: Turbine operating efficiency is an important parameter to maintain the minimum cost of power…

Q: 6. Whether the value of synchronous impedance (Zs) is constant? State the conditions on which it…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Derive net RMS EMF induced in the stator winding, when there is an influence of 1st, 2nd harmonics.

A: EMF induced due to first harmonics is = RMS value is =

Q: Write a report on test Zero Power factor characteristics and loss measurement of Synchronous…

A: consider the given question;

Q: Q3: A synchronous generator with peak generated voltage Vg which is connected to a lighting arrester…

A: Equivalent per phase diagram Apply KVL in loop 1)

Q: Describe constant and variable frequency operation of chopper control. Describe how duty cycle…

Q: A 2 pole wave wound shunt generator delivers 190A at a terminal voltage of 210V. Ra and Rsh are…

A: Since we only answer up to 3 sub parts we will answer the first 3, please resubmit the question and…

Q: a- Compare the excitation of 3-phase induction and synchronous machines.

A: As per the policy, I can attempt only one individual question at a time. Compare the excitation of 3…

Q: A shunt generator supplies a 30kW load at 220V through cables of resistance, R = 110mQ. If the field…

A: The solution can be achieved as follows.

Q: The torque angle of synchronous machine operating from a constant voltage bus, is usually defined as…

A: the torque angle of synchronous machine is operated from a constant voltage bus, is usually defined…

Q: Are sums of components powers equal to zero? Why

A: Yes The sum of components powers equal to zero

Q: A 3-Phase 10Kva, 400 V, 50Hz star connected alternator supplies a rated load at 0.8 power factor…

Q: A 4 pole wave wound shunt generator delivers 205A at a terminal voltage of 240V. Ra and Rsh are…

Q: Calculate the percent voltage regulation for a three-phase wye-connected 2500 kVA 6600-V…

A: In this question we need to find a voltage regulation of the given alternator.

Q: The breadth factor for 3rd harmonic emf of a 3 phase, 4 pole, synchronous machine having 36 stator…

A: Given a 3-phase synchronous machine having, 3rd harmonic, r =3 Number of pole, P = 4 Number of slots…

Q: (a) Sketch the equivalent circuit and obtain the general equation for synchronous generator

A: Synchronous generator: It is an electromechanical device. This is called a synchronous generator…

Q: 6. For a series dc generator with Rs =12, R, = 3 2, and V, = 60 V that delivers 240 W to the load,…

A: Note :- as per guidelines only the first question can be solved, kindly re post the other questions…

Q: Given a four pole IM connected to a 50-cycle 3 phase circuit. Calculate the airgap diameter (rotor…

Q: Explain Synchronous Generator Features, Uses, and Control Methods Using Pictures and Graphics

A: Synchronous generator - The alternator, also known as a synchronous generator, converts mechanical…

Q: A shunt generator supplies a 32kW load at 230V through cables of resistance, R = 110mQ. If the field…

A: A DC Shunt generator 32kW load, supplied at voltage 230V Cable resistance R= 1ohm Armature…

Q: With necessary sketch, Explain the mode of operation of chopper which is turn off due to external…

A: The mode of operation of chopper circuit is turn off due to the external load circuit so it called…

Q: power syste unit quantities instead of actual values. Give the advantages of using such a system.…

A: (a) Advantages Of Per-unit System- It gives a clear idea of relative magnitudes of various…

Q: If all closed-loop poles of a system are in the Left-Half plane and only one closed- loop pole is on…

A: If all the closed loop poles lies in the left half of plane then it is stable. If one pole lies on…

Q: For the radial system shown, the setting of the second zone (in secondary settings) of a relay at V…

A: Given CT 1000: 1 VT ratio -132000 : 120 -1100 :1 Second zone

Q: Compared between three_ phase induction generator and synchronous them at impedance field and EMF…

Q: The torque angle of synchronous machine operating from a constant voltage bus, is usually defined as…

A: The torque angle of synchronous machine operating from a constant voltage bus, is usually defined as…

Q: Four similar synchronous generators are sharing equally the feed to a load of 1 pu referred to the…

A: To find the correct option from the given statements

Q: 2. The transient reactance in a synchronous machine is defined as the ratio of no-load voltage to…

A: The solution is given below.

Q: Illustrate the salient effect of a sudden symmetrical short circuit across the terminals of a…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Derive emf equation of the synchronous generator.

Q: can we apply the principle of electromagnetic induction in a Transformers operation? (short answer)

A: Electromagnetic induction : According to electromagnetic induction whenever there is a change in…

Q: a. List the major components of the excitation system. b. Draw the block diagram of high frequency…

Question

A 8 pole wave wound shunt generator delivers 205A at a terminal voltage of 200V. Ra and Rsh are 0.070 and 350 respectively.
Neglecting brush drop, determine (i) armature current (ii) current per parallel path (iii) generated voltage and (iv) Power
developed.
armature current
current per parallel path
generated voltage
Power developed

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The amplitude of the sinusoidal symmetrical ac component of the three-phase short-circuit current of an unloaded synchronous machine decreases from a high initial value to a lower steady-state value, going periods through the stages of __________ and ________ periods.
For Problem 3.18, the motor operates at full load, at 0.8 power factor leading, and at a terminal voltage of 10.45 kV. Determine (a) the voltage at bus 1, which is the generator bus, and (b) the generator and motor internal EMFs.
Three-phase, 60-Hz synchronous generator is connected through a transformer and paralleltransmission lines to an infinite bus. All reactances are given in per-unit on a common systembase. If the infinite bus receives 1.0 per unit real power at 0.95 p.f. lagging, determinea) the internal voltage of the generator andb) the equation for the electrical power delivered by the generator versus its power angle δ.
A 100KVA, 6.6 kV 3 PHASE star connected cylindrical pole synchronous generator has 20-ohm as synchronous reactance and the armature resistance is negligible and the generator is working at the full load and unity power factor then find the value of the induced emf voltage(line to line). 10 points
a single-phase, 10-kVA, 200-V, generator has an internal impedance Z, of 2 Q. Using the ratings of the generator as base values, determine the generated per-unit voltage that is required to produce full-load current under the short-circuit condition.
A 100KVA, 6.6 kV 3 PHASE star connected cylindrical pole synchronous generator has 20-ohm as synchronous reactance and the armature resistance is negligible and the generator is working at the full load and unity power factor then find the value of the induced emf voltage(line to line).
Discuss system demand and generator loading
why nutral gas based combined cycle power plants are more efficint comparing to open cycle natral gas based power plant
Select generator rating as base value
What is the need to conduct power flow analysis? Discuss about data needed and bus types too.
Derive emf equation of the synchronous generator.
A long shunt generator delivers 25kW at 220V. The shunt, series and armature resistances are 50ohms, 0.02ohms, and 0.05ohms respectively, calculate the generated emf.