(a) A supplement tablet containing about 300.00 mg of calcium ion was dissolved, filtered, and diluted to 100.00 mL volume. Several 2.00 ml samples of the total solution were titrated with 0.0100 M EDTA solution. The mean corrected titration volume was 13.65 mL. Calculate the calcium content of the supplement tablet in mg units. (b) A sample of Epsom Salt of mass 0.7567 g was dissolved uniformly in distilled water in a 250.00 mL volumetric flask. Portions of the magnesium ion solution of volume 10.00 mL were titrated using a 0.01000 M solution of EDTA. The mean corrected titration volume was 12.25 ml. Calculate the percentage by mass (% w / w) of the magnesium in the Epsom Salt sample. (c) A 100.00 mL sample of tap water was titrated with O.0100 M EDTA solution. The mean corrected titration volume was 14.80 mL. Determine the total hardness in ppm of calcium carbonate.

(a) A supplement tablet containing about 300.00 mg of calcium ion was dissolved, filtered, and diluted to 100.00 mL volume. Several 2.00 ml samples of the total solution were titrated with 0.0100 M EDTA solution. The mean corrected titration volume was 13.65 mL. Calculate the calcium content of the supplement tablet in mg units. (b) A sample of Epsom Salt of mass 0.7567 g was dissolved uniformly in distilled water in a 250.00 mL volumetric flask. Portions of the magnesium ion solution of volume 10.00 mL were titrated using a 0.01000 M solution of EDTA. The mean corrected titration volume was 12.25 ml. Calculate the percentage by mass (% w / w) of the magnesium in the Epsom Salt sample. (c) A 100.00 mL sample of tap water was titrated with O.0100 M EDTA solution. The mean corrected titration volume was 14.80 mL. Determine the total hardness in ppm of calcium carbonate.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter13: Titrations In Analytical Chemistry

Section: Chapter Questions

Problem 13.5QAP

See similar textbooks

Similar questions

In the determination of water hardness by volumetry, AEDT is used. If the volume of 0.01 M EDTA used to titrate 100 mL of sample was 20 mL, calculate the total hardness expressed in mg/L of CaCO3.
In an experiment to determine the concentration of H2SO4 in a brand of toilet cleanser, 10.0 cm3 of the cleanser was first diluted to 250.0 cm3 with distilled water. 25.0 cm3 of the diluted cleanser were titrated with 0.320 mol dm–3 NaOH solution, using methyl orange as indicator.If 29.2 cm3 of NaOH solution is used, what is the concentration of H2SO4 in the undiluted toilet cleanser?a. 2.30 mol dm–3b. 4.60 mol dm–3 c. 9.20 mol dm–3 d. 11.50 mol dm–3
The concentration of ammonia in a cleaning product was determined by back titration.Firstly, 10.00 cm3 of the cleaning product was pipetted into a large conical flask,containing 250.00cm3 of 0.50 mol/l HCl to give Solution A.Following a period of reaction and shaking, 50.00cm3 of Solution A was removed anddiluted to 250 cm3 with water in a volumetric flask to give Solution B.20 cm3 samples of Solution B were titrated against 0.05 mol/l Na2CO3 solution, givingan average titre of 12.45 cm3. i) Write equations for the reactions that have taken place.ii) Determine the concentration of NH3 in the original cleaning product in mol/l,g/l, ppm, and % w/v.
In a Complexometric Titration Experiment, the preparation of the EDTA solution is as follows: In a 250 mL beaker, weigh 0.10 g MgCl2*6H2O and 1.0 g NaOH. Add approximately 200 mL distilled water and stir to dissolve. Add about 2.0 g of EDTA and transfer the solution quantitatively to a 1-L volumetric flask. Dilute to the mark with distilled water. What is the purpose of adding MgCl2*6H2O? Please show COMPLETE solution.
1. A newly discovered iron ore was weighted (5.408 g) and worked up to produced 0.3785 g of ignited Fe2O3 precipitate. What is the percent purity of the iron in the sample? 2. Distinguish between equivalence point and end point.
The amount of iron in a meteorite was determined by a redox titration using KMnO4 as the titrant. A 0.4185 -g sample was dissolved in acid and the liberated Fe3+ quantitatively reduced to Fe2+, using a reductor column. Titrating with 0.0044 M KMnO4 requires 28.76 mL to reach the end point. Determine the %w/w Fe2O3 in the sample of meteorite. (Fe = 55.845 amu, Fe2O3 = 159.69 g/mol
An EDTA solution prepared from its disodium salt was standardized using 0.250-g primary standard CaCO3 (MW=100.087) and consumed 28.50 mL of the solution. The standard solution was used to determine the hardness of a 2.0 L sample of mineral water, which required 35.57 mL EDTA solution. Express the analysis in terms of ppm CaCO3
25.0 cm3 of sodium hydroxide solution is tritrated against 0.200 mol dm–3 hydrochloric acid until the indicator just changes colour. 27.5 cm3 of the acid are required to reach the end point.Which of the following pieces of apparatus should be used to transfer 25.0 cm3 of the sodium hydroxide solution?a. Burette b. Pipette c. Measuring cyclinder d. Volumetric flask
In order to adjust the Potassium Permanganate solution, 0.0544g Na2C2O4 was taken and necessary experimental procedures were performed on it and the titrant consumption was found to be 7.9 mL. What is the KMnO4 concentration?
A commercial lab received a batch of industrial wastewater samples for analysis. Johnplans to test water hardness of these unknown samples. Prior to complexometric titration,the titrant, EDTA solution needs to be standardized. A 50.00 mL of 5.67 x10-3 M Ca2+standard solution required average of 38.10 mL of unknown EDTA solution to reach itsend point. Based on titration information recorded, work out the correct molarity of EDTAsolution.
1) 100 mL tap water is titrated with 20 mL of 0.02 M EDTA solution to determine the hardness of the water. The second 100 mL tap water is precipitated as CaC2O4 and removed by filtration and the filtrate is titrated with 8.0 mL of the same EDTA solution. What are the concentrations (as ppm) of Ca2+ (40.078 g/mol) and Mg2+ (24.305 g/mol) ions in the water? 2) 10 g of a solution, containing one or more of NaOH, Na3PO4, Na2HPO4, NaH2PO4, H3PO4 and HCl substances, is titrated with 1.0 M NaOH using the phenolphthalein indicator and 34.5 mL NaOH is used. Another 10 g mixture was titrated to reach the bromocresol green end point and 20.50 mL NaOH is used. What is the composition of the solution? What are the percentages of the species(H:1.0078, O:15.99, Na: 22.98, P:30.974, Cl:35.453)?
A 500.0mg of butter was warmed and shaken vigorously with water. The undissolved material was removed by filtering and the aqueous portion was made 1.0M in HNO3 and 0.025M in Fe(NO3)3. This acidified solution was treated with 10.00ml of 0.1755M AgNO3 to precipitate the chloride ion and, after the addition of a small amount of nitrobenzene, 14.22ml of 0.1006M KSCN was required to back titrated the excess Ag+. Calculate the % NaCl in the butter.