A brick wall, plastered on one face, has a thermal conductance of 2.8W/m^2-K, an inside surface resistance of 0.3 m^2-K/W, and an outsidesurface resistance of 0.05 m^2-K/w. Calculate the total heat resistance.Your answer Naturally occurring gases and tropospheric pollutants that absorb, reflect,and refract the earth's infrared radiation and prevent it from escaping thelower atmosphere are called *ozone - depleting substanceO greenhouse gasescarbon dioxidechlorofluorocarbonshydrochlorofluorcarbonsO hydrofluorocarbonsO refrigerant blends

Dear student, According to the guidelines I am allowed to answer only one…

A brick wall, plastered on one face, has a thermal conductance of 2.8 W/m^2-K, an inside surface resistance of 0.3 m^2-K/W, and an outside surface resistance of 0.05 m^2-K/w. Calculate the total heat resistance.

A brick wall, plastered on one face, has a thermal conductance of 2.8 W/m^2-K, an inside surface resistance of 0.3 m^2-K/W, and an outside surface resistance of 0.05 m^2-K/w. Calculate the total heat resistance.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter9: Refrigerant And Oil Chemistry And Management-recovery, Recycling,

Section: Chapter Questions

Problem 10RQ: What measurement or index takes into considerationboth the indirect and direct global warming...

See similar textbooks

Related questions

Q: A brick wall 3 m high, 7.5 m wide, and 160 mm thick has a thermal conductivity of 0.7 W/(m-°C). The…

Q: Hot water at average temperature of 90°C is flowing through a cast iron pipe (k=40 W/mK) whose inner…

Q: there are times when contact resistance between two surfaces is so small compared to the overall…

A: Given that there are times when contact resistance between two surfaces is so small compared to the…

Q: . Btu/h ft °F) whose inner and outer diameters are 3.5 in. and 4.0 in., respectively, in an…

Q: A pipe with an outside diameter of 2.5 in. is insulated with a 2 in. layer of asbestos (ka = 0.396…

A: Solution:

Q: Consider a closed cylindrical reactor vessel of diameter D= 1 ft, and length L= 1.5 ft. The surface…

Q: Steel pipe (outer diameter 100 mm) is covered with two layers of insulation. The inner layer, 40 mm…

Q: Calculate the heat transfer rate per unit area of a 200 mm thick concrete wall at a surface…

Q: A single-glazed glass window pane is an arched shape, consisting of a semicircle of radius 0.5 m on…

Q: A domestic refrigerator with inner dimensions of 0.7 m by 0.7 m at the base and height 1 m was…

A: Given data:- Thickness of aluminium, t=10 mm

Q: For a flat corrugated galvanized steel (conductivity = 26 W/m.K) roof 1/32 in. thick lined with a ¼…

A: Write the expression for thermal transmittance as follows.

Q: An oil radiator has an outside surface area of 0.18 m2 and operates at a surface temperature of 85…

Q: It is necessary to insulate a flat surface so that the rate of heat loss per unit area of this…

A: Given, QA=450 W/m2 ∆T=400 K

Q: a pipe with an outside diameter of 2.5 inches is insulated with 2 inches layer of asbestos ( K=…

Q: An Aluminum rod, k=206W/(m.°K), 5cm in diameter and 15cm in length, protrudes from a wall which is…

A: Given, Thermal conductivity of the rod (k)= 206W/3°K Diameter of the protrusion (d)= 5cm Length of…

Q: A domestic refrigerator with inner dimensions of 0.7 m by 0.7 m at the base and height 1 m was…

A: Base area = 0.7 m x 0.7 m Height = 1 m Ti = 6 C hi= 11.6 W/m2K ho = 14.5 W/m2K

Q: Question 6 A steel pipe (k = 48 W/m-K) of a heating system carries wet steam at 120 °C. The inner…

A: Given: The conductivity of steel pipe is k1=48 W/m·K. The temperature of the steam is T1=120°C. The…

Q: A hot steam pipe having an inside surface temperature of 250°C has an inside diameter of 8 cm and a…

A: The thermal resistance of a hollow pipe can be calculated using the formula given below as-…

Q: A hot steam pipe having an inside surface temperature of 250°C has an inside diameter of 8 cm and a…

A: GIVEN DATA- A COMPOSITE CYLINDER GIVEN COVERED WITH DIFFERENT INSULATION WE HAVE TO FIND HEAT…

Q: A spherical furnace has an inside diameter of 6ft and an outside diameter of 8ft. The furnace shell…

A: Given data r1 = 3 ft r2 = 4 ft r3 = 4.5 ft r4 = 5 ft Thermal conductivity of inner shell (kA) =…

Q: Calculate the thermal resistance of a copper tube with diameter1=0.153 mm diameter2= 0.157 mm and…

A: Styrofoam diameter should be more than diameter 2 (0.157 mm) .it cannot be 0.09 mm ,so it should be…

Q: A 3 inch schedule 40 pipe is covered with two layers of…

A: Given data: 3 inch schedule-40 pipe means nominal diameter is 3 inch and it's outside diameter is,…

Q: A steam pipe (inner diameter = 150 mm and outer diameter = 160 mm) having thermal conductivity 58…

A: Given, T1 = 320 °CT2 = 40 °CL = 1 mkpipe = 58 W/m °Ckins1 = 0.18 W/m °Ckins2 = 0.09 W/m °CInternal…

Q: fin made of AL metal with thermal conductivity (199 W / mK). Fin dimensions 3 cm long and 2.5 mm…

A: given data: fin metal : Al : k = 199 W/mK length; l = 0.03 m thickness; t = 2.5 mm wall temperature;…

Q: Please answer: Calculate the correct rate of heat loss through the vertical walls of a boiler…

A: Given that, Dimension of furnace wall, l×b×h=4×3×3 m3Thermal conductivity of inner brick, kb=0.4…

Q: There is a 1.20-cm-thick stagnant air pocket. A) What thickness of cork would have the same…

A: Given data, (1) Stagnate air pocket t1 = 1.2 cm K1 = 0.023 W/m.k Cork K2 = 0.046 W/m.k t2 =…

Q: A wall with a thickness of 2 cm will be constructed from a material with a heat conduction…

Q: Blowtorch is used to connect the two pipes together. Length of the pipe section shown is 150 cm with…

A: Given: L = 150 cm t = 4 mm Di = 85 cm Do = Di + 2t = 85 + 8 = 93 cm thermal conductivity, k = 167…

Q: A domestic refrigerator with inner dimensions of 0.7 m by 0.7 m at the base and height 1 m was…

A: inner dimensions = 0.7 m by 0.7 m at the base height = 1 m Ti = 6 ˚C. T two 10-mm-thick layers of…

Q: steel rod (k = 30 W/m degree) 1 cm in diameter and 7 cm long protrudes from a wall which is…

A: Given:K=30 W/mCd=1 cmL=7 cmTb=100°Ch=50 W/m2KT∞=30°C

Q: e steel. The overall heat-transfer coefficient, considering convection on both sides of the plastic,…

A: given:k=16W/mcthickness t=4mmoverall heat transfer U=120W/m2ctemperature difference across the…

Q: e The side walls of a refrigerator are made from two thin layers of sheet metal, each 1/8 in. thick,…

A: Given data as per the question The thickness of metal sheet =1/8 in =0.0104 ft The thickness of the…

Q: A cold-storage room is constructed of an inner layer of 11 mm of pine with thermal conductivity of…

A: Given:- Length of pine(thickness) Lp=11mm=0.011m Length of concrete(thickness) Lc = 75mm=0.075m…

Q: A domestic refrigerator with inner dimensions of 0.7 m by 0.7 m at the base and height 1 m was…

Q: A wall is constructed of two layers of 1 cm thick plaster board (k = 0.17 W/m.K) placed 12 cm apart.…

A: GIVEN DATA- A COMPOSITE WALL GIVEN WE HAVE TO FIND THERMAL RESISTANCE AND HEAT TRANSFER

Q: There is a 1.20-cm-thick stagnant air pocket. A) What thickness of cork would have the same…

A: Given data: ◆ The thermal conductivity and thickness of stagnant air-pocket: Lair = 1.20 cm = 0.012…

Q: Heat flows through a composite slab, as shown below. The depth of the slab is 1 m. The k values are…

Q: pipe with an outside diameter of 2.7 inches. insulate with a 2 inches. layer of asbestos (ka =…

A: Given Data

Q: A plane brick wall, 25 cm thick, is faced with 5 cm thick concrete layer. If the temperature of the…

A: It is very conceptual numerical of heat transfer subject. Used concept is Heat transfer through…

Q: A steel pipe 150mm external diameter conveys steam at a temperature of 260°c and it is covered by…

Q: The case-to-ambient thermal resistance of a power transistor that has a maximum power rating of 15 W…

A: Write the equation for the required power. Power=T-T∞ResistanceRcase-ambiant

Q: A) If you increase cross-sectional area effectiveness will drop B) epsilon is proportional to…

A: Option c is correct none of the above

Q: Pin fins are provided to increase the heat transfer from a hot surface. The perimeter of each fin is…

A: Arrangement 2 will have higher heat transfer rate.

Q: 2. A refrigerated cold room wall has a thickness of 100mm and a thermal conductivity 0.14 W/m-K. The…

Q: A wall is constructed of 5.0 cm of copper [k = 400 W/m°C] and 5.0 mm of asbestos sheet [k = 0.17…

A: GIVEN DATA For Copper L=5cm K=400 W/m'C For Asbestos L=5mm…

Q: One vessel having a carbon-steel wall of thickness 5 mm carrying saturated steam and water at 423K.…

Question

A brick wall, plastered on one face, has a thermal conductance of 2.8
W/m^2-K, an inside surface resistance of 0.3 m^2-K/W, and an outside
surface resistance of 0.05 m^2-K/w. Calculate the total heat resistance.
Your answer

Naturally occurring gases and tropospheric pollutants that absorb, reflect,
and refract the earth's infrared radiation and prevent it from escaping the
lower atmosphere are called *
ozone - depleting substance
O greenhouse gases
carbon dioxide
chlorofluorocarbons
hydrochlorofluorcarbons
O hydrofluorocarbons
O refrigerant blends

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

CFCs are more harmful to the stratospheric ozone layer than HCFCs because they contain _____.
While discussing the reasons the use of R-134a is being discontinued in some countries: Technician A says that the chemical composition of the refrigerant has been proven to be harmful to the earth’s ozone layer. Technician B says that R-134a leaks contribute to the undesirable greenhouse effect. Who is correct?
What is different in bitween Ozone and Smog.
Either for gas turbines OR for internal combustion engines, for the sustainable renewable energy future of Mauritius, explain which fuel(s) can be used and explain the combustion process with the help of relevant equations and diagrams. Show clearly how sustainability is achieved through the proper thermal engineering processes. Only few information provided in the images.
What is the average efficiency of internal combustion? (Indicate the types of internal combustion engine and corresponding efficiency.)
Convert the pounds of fuel oil burned per year into pounds of liberated CO2 per year for all appliances. (About 1.3 pounds of CO2 is released for each pound of fuel oil that is combusted. So, pounds of CO2 per year = pounds of fuel oil burned per year * 1.3) ___________________ Pounds of CO2 per year
Which of the following CANNOT be used as a source for the production of hydrogen? a. Gasoline b. Methanol c. Carbon dioxide d. Natural gas
What measurement or index takes into considerationboth the indirect and direct global warming effects of refrigerants? A. Total equivalent warming impact (TEWI) B. Greenhouse effect number C. Global warming number D. Greenhouse effect index
Vortexing in a cooling tower occurs in the A. inlet piping. B. basin of the tower. C. outlet piping. D. pump discharge.
When a hydrocarbon fuel is burned, almost all of the carbon in the fuel burns completely to form CO2 (carbon dioxide), which is the principal gas causing the greenhouse effect and thus global climate change.
The rating of the ability of a gasoline to burn smoothly in an internal combustion is its a. octane rating. b. boiling point. c. energy value. d. fuel density. e. molar mass.
Explain the effect of noise on humans when they are undergoing prolong andcontinuous exposure?