A chemist is studying the following equilibirum, which has the given equilibrium constant at a certain temperature: N,(g) + 3 H,(g) =2 NH;(g) K = 1. × 10¬6 He fills a reaction vessel at this temperature with 10. atm of nitrogen gas and 3.9 atm of hydrogen gas. Use this data to answer the questions in the table bel

A chemist is studying the following equilibirum, which has the given equilibrium constant at a certain temperature: N,(g) + 3 H,(g) =2 NH;(g) K = 1. × 10¬6 He fills a reaction vessel at this temperature with 10. atm of nitrogen gas and 3.9 atm of hydrogen gas. Use this data to answer the questions in the table bel

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter12: Chemical Equilibrium

Section: Chapter Questions

Problem 61QRT

See similar textbooks

Similar questions

. What does it mean to say that a state of chemical or physical equilibrium is dynamic?
12.101 An engineer working on a design to extract petroleum from a deep thermal reservoir wishes to capture toxic hydrogen sulfide gases present by reaction with aqueous iron(II) nitrate to form solid iron(II) sulfide. (a) Write the chemical equation for this process, assuming that it reaches equilibrium. (b) What is the equilibrium constant expression for this system? (c) How can the process be manipulated so that it does not reach equilibrium, allowing the continuous removal of hydrogen sulfide?
Suppose a reaction has the equilibrium constant K = 1.3 108. What does the magnitude of this constant tell you about the relative concentrations of products and reactants that will be present once equilibrium is reached? Is this reaction likely to be a good source of the products?
5.2. What is the difference between a static equilibrium and a dynamic equilibrium? Give examples difference from the examples in the text. What is similar for the two types of equilibria?
12.103 Methanol, CH3OH, can be produced by the reaction of CO with H2, with the liberation of heat. All species in the reaction are gaseous. What effect will each of the following have on the equilibrium concentration of CO? (a) Pressure is increased, (b) volume of the reaction container is decreased, (c) heat is added, (d) the concentration of CO is increased, (e) some methanol is removed from the container, and (f) H2 is added.
Consider the following equilibrium: COBr2(g) CO(g) + Br2(g)Kc = 0.190 at 73 C (a) A 0.50 mol sample of COBr2 is transferred to a 9.50-L flask and heated until equilibrium is attained. Calculate the equilibrium concentrations of each species. (b) The volume of the container is decreased to 4.5 L and the system allowed to return to equilibrium. Calculate the new equilibrium concentrations. (Hint: The calculation will be easier if you view this as a new problem with 0.5 mol of COBr2 transferred to a 4.5-L flask.) (c) What is the effect of decreasing the container volume from 9.50 L to 4.50 L?
Methanol, a common laboratory solvent, poses a threat of blindness or death if consumed in sufficient amounts. Once in the body, the substance is oxidized to produce formaldehyde (embalming fluid) and eventually formic acid. Both of these substances are also toxic in varying levels. The equilibrium between methanol and formaldehyde can be described as follows: CH3OH(aq)H2CO(aq)+H2(aq) Assuming the value of K for this reaction is 3.7 1010, what are the equilibrium concentrations of each species if you start with a 1.24 M solution of methanol? What will happen to the concentration of methanol as the formaldehyde is further converted to formic acid?
At 2300 K the equilibrium constant for the formation of NO(g) is 1.7 103. N2(g) + O2(g) 2 NO(g) (a) Analysis shows that the concentrations of N2 and O2 are both 0.25 M, and that of NO is 0.0042 M under certain conditions. Is the system at equilibrium? (b) If the system is not at equilibrium, in which direction does the reaction proceed? (c) When the system is at equilibrium, what are the equilibrium concentrations?
12.102 A chemical engineer is working to optimize the production of acrylonitrile to be used in the manufacture of carbon fibers. The reaction being used is the combination of propene gas, ammonia, and oxygen. The reaction is normally carried out at moderately high temperatures so all species are in the gas phase. (a) Write the equilibrium constant expression for this reaction. (b) The boiling point of acrylonitrile is 77 °C, and that of propene is -48 °C. What would the equilibrium expression be if this reaction were carried out at room temperature? (c) What characteristic of this reaction might cause the engineer to desire carrying out this reaction at room temperature?
During an experiment with the Haber process, a researcher put 1 mol N2 and 1 mol H2 into a reaction vessel to observe the equilibrium formation of ammonia, NH3. N2(g)+3H2(g)2NH3(g) When these reactants come to equilibrium, assume that x mol H2 react. How many moles of ammonia form?
Chemical Equilibrium II Magnesium hydroxide. Mg(OH)2, is a white, partially soluble solid that is used in many antacids. The chemical equation for the dissolving of Mg(OH)2(s) in water is Mg(OH)2(s)Mg2+(aq)+2OH(aq) a Describe a simple experimental procedure that you could use to study this solubility equilibrium. In your experiment, how would you determine when the solution process has attained equilibrium? b Write the equilibrium-constant expression for this dissolving of magnesium hydroxide. c Suppose equilibrium has been established in a container of magnesium hydroxide in water, and you decide to add more solid Mg(OH)2. What would you expect to observe? What effect will this addition of Mg(OH)2 have on the concentrations of Mg2+(aq) and OH(aq)? d Say you haw prepared an equilibrium solution of Mg(OH)2 by adding pure solid Mg(OH)2 to water. If you know the concentration of OH(aq), can you determine the concentration of Mg2+(aq)? If not, what information do you need that will allow you to determine the answer? e You slowly add OH from another source (say, NaOH) to an equilibrium mixture of Mg(OH)2 and water. How do you expect the concentration of the Mg2+(aq) to change? What might you be able to observe happening to the Mg(OH)2(s) as you add the OH? f Next you remove some, but not all, of the Mg(OH)2(s) from the mixture. How will this affect the concentrations of the Mg2+(aq) and OH(aq)? g If someone hands you a container of Mg(OH)2(aq) and there is no solid Mg(OH)2 present, is this solution at equilibrium? If it is not at equilibrium, what could you add to or remove from the container that would give an equilibrium system? h Consider an individual OH(aq) ion in an Mg(OH)2 solution at equilibrium. If you could follow this ion over a long period of time, would you expect it always to remain as an OH(aq) ion, or could it change in some way?
In Section 13.1 of your text, it is mentioned that equilibrium is reached in a closed system. What is meant by the term closed system. and why is it necessary to have a closed system in order for a system to reach equilibrium? Explain why equilibrium is not reached in an open system.