A cylindrical liquid storage tank weighing is to be pushed over a change of elevation of 0.25m by a horizontal force F as indicated in the figure. Which of the following gives reaction at A?

Q: A light ball (weight 2.0-g) filled with a very light gas, the ball is connected to a spring as shown…

A:

Q: What would be the maximum weight W of the block shown in the following figure, so that the tension…

A:

Q: 3.70 The plane rectangular gate can pivot about the support at B. For the conditions given, is it…

A:

Q: A 100.kg box suspended from the extreme side of the horizontal truss. Assume that the truss’s weight…

A:

Q: is a homogeneous ball of weight N 1000 resting on a smooth wall and resting on B8 an arm of length 5…

A:

Q: The circular gate ABC in Fig.  has a 1-m radius and ishinged at B . Compute the force P just suffi…

A: Given: The radius of the gate, r = 1 m Depth of the point B from the free surface of water, h = 8 m…

Q: 4- The 200 kg, 5 m wide rectangular gate shown in Figure is hinged at B and leans against the floor…

A:

Q: Q3- The Figure shows a steel tube which supports a flowerpot that has weight = 400 N. The tube is…

A: Solution:                 Consider 'A' as the origin.Then cp-ordinates of B,c &D from the give…

Q: 3 m Hinge 2. The gate shown is rectangular and has dimensions 6 m by 4 m. What is the reaction at…

A: Draw the schematic diagram for the above problem.

Q: Q2) A cylindrical body of length 0.9 m and of sp.gr = 0.7 is floating in water as shown in fig.2.…

A:

Q: Example (3): Determine the weight of the body (B) required to keep the system shown in fig. (3) in…

A: Given: WA=273.34 N Consider the Free Body diagram:

Q: Example: A cylinder 2.2 m in diameter and 3.3 m long supported as shown in Figure retains water on…

A: For solution refer below images.

Q: A bucket hangs off the end of a rod rigidly attached to a pulley. A spring acts as a counterbalance.…

A:

Q: Q3: The diagram shows the open bonnet of a car. The bonnet is vertical force V held open at an angle…

A: 1) Draw the FBD for the given question. The other two forces will be the reaction force at the hinge…

Q: Poles 4500 g

A: Level h:

Q: Two identical rollers, each of weight W = 100 lbf, are supported by an inclined plane and vertical…

A: Given; W=100 lbf Angle θ=30° To Find, RA,RB and RC

Q: In the figure below, a diver who weighs 65kg stands at one end of a diving board preparing for a…

A: Given Data:  Mass of diver, md=65 kg Mass of board, mb=20 kg

Q: A 150 lb cylindrical tank is at rest as shown as shown in the figure. Determine the force P required…

A: The free-body diagram of the cylindrical tank is shown below.

Q: A 40 kg boy climbs up an 8-meter ladder. The ladder weighs 700-N and rest against a vertical wall in…

A: m=40kg M = 700N  L=8m  Angle with ground = 70°

Q: Physics - Finish A particle of mass m is suspended by massless string inside a trolley of mass m as…

A: Write the given value using suitable variables. Here mA signifies trolley mass, and mB signifies…

Q: A 65-kg woman wishes to walk on the muddy soil in able to cross her way but the mud cannot withstand…

A:

Q: The block shown in the figure below is acted on by its weight, W = 1300 Lbs, a horizontal force H =…

A:

Q: PROBLEM 2 For the figure shown, determine the following if the mass of the person is 50kg and the…

A: Dear student, as per the guidelines of Bartleby we are authorized to answer the first question only.…

Q: What would be the maximum weight W of the block, shown n the following figure, so that the tension…

A: Correct ans is 22.32N

Q: In the mechanism shown, find the force P and all reaction forces. Ignore weight forces and friction

A: Considering that the mechanism is in equilibrium with the action of the applied torque and external…

Q: 1. (a) The gusset plate in Figure la is subjected to the forces of four members; F is 10 kN and the…

A:

Q: * Anautomobile stuck in a maddy field is being, moved by using a cable fastened to a tree as shown…

A: Draw the F.B.D of the wire at the point where the force P is applied. From the Lami’s theorem,

Q: Hinge

A: For solution refer below images.

Q: 1. In a room with a ceiling height of 2.6 meter, a 2.5 meter plank is supported by a cable attached…

A:

Q: 1. The telephone pole AB weighing 3730 N is resting in a hole that is 2 m deep. If the contact force…

A:

Q: Determine the reaction forces at the support A and the tension force T in the cable needed to…

A:

Q: The diagram shows the open bonnet of a car i Jyuell. The bonnet is held open at an angle of 60° to…

A: Consider the free body diagram shown below for the given system.

Q: Each of the cage system supported as in the figure Since the mass of the bar is 40 kg, each bar…

A:

Q: 2. The 1-m diameter cylinder in the figure is 8 meters long (dimension perpendicular to the paper)…

A:

Q: The mass of the board suspended below is 70 kg. What is the tension in the rope, and what is the…

A: Consider the free body diagram shown below for the given board.

Q: Two horizontal beams are used to balance the masses A, B, and C, as shown in the figure. Each beam…

A: Given data: Mass of block C, mC = 30 kg. Draw the diagram of the lower rod. Apply equilibrium…

Q: The uniform crate shown in the figure weighs 200 lb. It is pulled up the incline by a counterweight…

A: The relation between the displacements of block of weight 'W' and the crate will be determined, and…

Q: As shown in the figure, three cylinders have a weight of 15 lb, 40 lb, 20 lb was stacked up on a…

A:

Q: Consider the two boxes suspended from a combination of ropes in the figure to the right. (a) If the…

A: Ans(a)  Apply the condition of equilibrium  ∑Fx=0T1sin30°-T2sin50°=0T1=T2×1.532  ......(1)

Q: A 50-kg smooth cylinder is at rest in a box that has smooth walls at right angles to each other. If…

A: To find: The reaction of the bottom of the box on the cylinder. Given: The mass of cylinder is m=50…

Q: The Cylinder weighs 1000 kg, rest on an plane which is inclined at 34° from the horizontal. The…

A:

Q: A 150 kg box is supported by a beam Z and cable K as shown in the figure below. Determine the forces…

A: Given data: Mass of the box, m = 150 kg. Draw the free-body diagram of the system, Apply Lami's…

Q: Question-2 The circular gate ABC has a Im radius and is hinged at B. Compute the force P just…

A: The unit of specific weight is given wrong in the question. It must be N/m3 for the given values. I…

Q: Q2: For the system shown in figure, all chains are of negligible weight, if the tensile force in…

A:

Q: Q2) A cylindrical body of length 0.9 m and of sp.gr = 0.7 is floating in water as shown in fig.2.…

A: Write the given data. L=0.9 mSG=0.7MG=-0.03 m In this problem, the distance between meta-centre M to…

Q: Two smooth spheres of weight W and radius r each are in equilibrium in a horizontal channel of A and…

A:

Q: A ball of weight 120 N rests in a right angled groove as shown in Fig. The sides of the groove are…

A:

Q: A rectangular gate (6m x 4m) is e hinged at A and supported by a stopper as shown. Find the reaction…

A: Given: The area of gate, A = 24 m2 The centre of pressure measured from A, yp = 3+0.4641 = 3.4641 m…

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.