Answered: (a) Explain the difference between…

(a) Explain the difference between instantaneous, peak, and RMS quantities, and give some cxamples of when it is appropriate to use cach one.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter16: Electromagnetic Waves

Section: Chapter Questions

Problem 77P: An outdoor WIFi unit for a picnic area has a 100-mW output and a range of about 30 m. What output...

See similar textbooks

Related questions

Q: istance is R, the inductance is L, and the impressed voltage is E(t). (Use i for

Q: For the circuit of controlled half-wave rectifier with RL Load, the source is 120Vrms at 60 Hz,…

Q: late the theoretical output DC voltage of the half-wave rectifier circuit an are it with measured…

Q: At high frequencies, a capacitor becomes a short circuit. Dis- cuss why this is so.

A: To find: At high frequencies, a capacitor becomes a short circuit.

Q: at is the new impedance of this circuit? at is the new current flowing out of the age source? d) How…

A: The solution can be given as follows :-

Q: what is the maximum frequency, if the circuit minimum frequency is 7000 Hz and the banwidth is 21…

A: what is the maximum frequency, if the circuit minimum frequency is 7000 Hz and the banwidth is 21…

Q: Consider a power plant located 25 km outside a towndelivering 50 MW of power to the town. The…

A: Let the length of the transmission line be l, the area of cross-section of the transmission line be…

Q: Record 2 peak to peak time measurements of this trace.

A: Given: The peak voltage in the image is V = 3 V. The frequency of the sine wave is f = 800 Hz.

Q: For a series RLC circuit at resonance, current O minimum O equal to Imms maximum P half of maximum

A: For a series RLC circuit at resonance the inductive reactance is equal to the capacitive reactance…

Q: A delta modulator system is designed to operate at five times the Nyquist rate I with 3 kHz…

A: Write the given values of the problem- Band width(w)w=3 kHzSampling rate=5 NyquistStep size(∆)=250…

Q: The reactance of a capacitor is 65 Ω at a frequency of 87 Hz.What is its capacitance?

Q: If the Carrier frequency is 33Khz of the system build in the lab, and the receiver requires 10…

Q: A square wave e is a cyclic pattern that has a constant absolute value, but alternates between…

Q: Vh at is the maximum instantaneous power disSi- ted by a 3.0-hp pump connected to a 240-Vrms ac…

Q: The current in the circuit shown in the fiqure below equals 71.0% of the peak current at t = 6.50…

Q: For the RLC circult below, calculate: a) The theoretical resonant frequency (fo), of the circuit. b)…

A: *We'll answer only the first question since the question to be answered was not specified. Please…

Q: What is meant by rectifier? Explain the half wave rectification and also calculate its rms value of…

Q: In a series rosistance ductor orcut the current grows to a thrd of its maximum valun in a tme of…

Q: If the propagation losses (PEL) for a link that operates at a frequency of 4 GHz are 120dB, when…

A: Initially data given that, When frequency was 4 GHz the propagation losses was 120dB We have to…

Q: nclude the appr- e value if the ac

Q: Give any four characteristics of series L-C-R circuit at resonance.

Q: The Vo Hage 8 sın (400t) is a series RLC circut , with R= 200 th=0.1H and C-I Nf .( w = lo6) @ what…

A: Since you have posted questions with multiple sub-parts, we will solve the first three for you. To…

Q: T Two capacitors are connected in series as shown below. The nominal capăcitances are C = 110µFand…

A: Overall capacitance Ceq = C1× C2/(C1+C2) Ceq= 110×60/(110+60) Ceq = 38.82 uF or…

Q: om the An AC voltage source has an amplitude of 96. V and frequency 400. Hz. The voltage was zero…

Q: The "Time/Div" setting of an oscilloscope that displays the signal in Fig. has value of 25 ms. The…

A: Given: Time per division is: 25 [ms] An oscilloscope contains small squares which is read as 1 [div]…

Q: A certain circuit breaker trips when the rms current is 15.0 A. What is the corresponding peak…

A: Given, Irms=15A

Q: Assume electricity costs 0.10 dollars per kilowatt-hour kW h Determine the total cost in units of…

Q: (a) For what frequencies does a 22.0 - µF capacitor have a reactancebelow 175 Ω? (b) What is the…

A: (a)Given:C = 22.0 µFXC = 175 Ω

Q: What is the RMS noise voltage associated with a 10 Q resistor at room temperature when the system…

A: Mean square noise voltage is given by- vn2¯=4kBTRhere,kB is Boltzmann'constant=4.138×10-23 J/KT =…

Q: An LRC circuit is set up with an inductance of 1>5 henry, a resistanceof 1 ohm, and a capacitance…

A: Given:- An LRC circuit is set up with an inductance of L=1/5 henry, a resistance ofR= 1 ohm, and a…

Q: Design a RC band stop filter such that it cutoffs frequency ranging from 10 to 10° Hz, Draw…

Q: Find the reactance of a capacitor of capacity 1uF at 1KHZ frequecy.

Q: The change in output voltage, SE, , from a 1/4 arm Wheatstone bridge circuit is 299 micro-volts.…

Q: If a signal passing through a gate is inhibited by sending a low into one of the inputs, and the…

A: Here it is given that a signal passing through a GATE is inhibited by sending a low into one of the…

Q: Each channel of a stereo receiver is capable of an average power output of 100W into an 8 ohms…

A: In the question we need to find the value of rms voltage and the rms current. The formula for power…

Q: .Detarmine the time constant of the circuit. b) Sketch the wave for ms For vc and ic. 30uf t. 10/-

A: We need to calculate time constant of the circuit and plot graphs of Vc and Ic.

Q: A standard TTL gate has a fan-out of 10. Are any of the gates in Figure 14-51 overloaded? If so,…

A: YES FIRST ONE

Q: If the peak value of a 1.5-kHz audio oscillator is 25V, what is the instantaneous voltage when ϴ =…

A: ϴ = 215 degree Vmax=25 V

Q: Hiw. Find the equivalent conductance Ge, for the circuit in figure. 55' -> 12 S Gega los ans-

Q: -Senies RLC circnit Ampli hade of he voltage Sourze is 120V - lesistur has a valve of 80s2 -…

A: Given: Vs=120 VR =80ΩXc= 480 ΩVc=360 V

Q: aximum= 452.30 mVpk Average= 0 RMS=319.82 mV (rms) Which among the measurement is the most…

A: Maximum speed is or velocity the maximum speed one gas particle can have. Magnitude of individual…

Q: A root mean square voltage of 100 volts is applied to a series LCR circet, having R = 10 ohm, L= 10…

Question

Can you answer question 1 part a?

(a) Explain the difference between instantaneous, peak, and RMS quantities, and give some
cxamples of when it is appropriate to use cach one.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Check your Understanding Repeat the calculations from the previous example for I0=0.040A .
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . If AC in a circuit can be thought of as a wave, which kind is it, longitudinal or transverse?
Check Your Understanding If a European ac voltage source is considered, what is the time difference between the zero crossings on an ac voltage-versus-time graph?
In an RLC series circuit, R=200,L=1.0H , C=50F,v0=120V , and f = 50 Hz. What is the power output of the source?
An outdoor WIFi unit for a picnic area has a 100-mW output and a range of about 30 m. What output power would reduce its range to 12 m for use with the same devices as before? Assume there are no obstacles in the way and that microwaves into the ground are simply absorbed.
Consider a power plant located 25 km outside a towndelivering 50 MW of power to the town. The transmissionlines are made of aluminum cables with a 7 cm2crosssectional area. Find the loss of power in the transmissionlines if it is transmitted at (a) 200 kV (rms) and (b) 120 V(rms).
For a Symmetrical Slab AlGaAs Waveguide, calculate the number of Modes that will propagate if the Wavelength is 870 nm and the Thickness is 8.5 um.
What is the root-mean-square voltage Vrms of the source? What is the frequency f of the source?
If the Carrier frequency is 33Khz of the system build in the lab, and the receiver requires 10 cycles of thecarrier to identify a logical one or zero. What is the maximum bit rate of the signal encoded in that system?
Radio-controlled clocks throughout the United States receivea radio signal from a transmitter in Fort Collins, Colorado,that accurately (within a microsecond) marks the beginningof each minute. A slight delay, however, is introducedbecause this signal must travel from the transmitter to theclocks. Assuming Fort Collins is no more than 3000 km fromany point in the U.S., what is the longest travel-time delay?
PLEASE SOLVE ASAP c. Suppose you chose option B. Let R = 10 Ohm. And c=100 microfarads. What should L0 be if the resonant frequency at f is to be 60Hz
How can you convert the wavelength to wave number and absorbance to transmittance? Please shortly write at your own words. Answer should be to the point.(5-6 lines maximum).