Answered: a) For the power electronics circuit…

a) For the power electronics circuit shown below sketch the waveform of the load current. b) If V,=200V, f,=50HZ, E=80V, R=102 and a=80°, find the average load current when: i- a=10° ii- a=120°

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter3: Magnetic Starters

Section: Chapter Questions

Problem 30SQ

See similar textbooks

Related questions

Q: A resistance of 100ohms, an inductance of 75.0 mH, and a capacitor of 4.0 microF are connected in…

Q: At full load, a commercially available 100 hp, three-phase induction motor operates at an efficiency…

A: Output power of induction motor is given as, 1 hp = 746 W. Therefore, output power in watt is ;…

Q: For the circuit shown. If the peak voltage V, -120 L 20 V, X = 4.Y=2, and Z = 4. Answer the…

Q: 1. A resistance of 1000, an inductance of 75.0 mH and a capacitor of 4.0 uF are connected in series…

A: In this question we will find current , voltage across each circuit element and power dissipated in…

Q: A 415 V, 50 Hz, three-phase, star-connected motor takes a line eurrent of 20.0 A when operating at a…

A: Initially motor is operating at 415V , 20 A at lagging pf of 0.7 Input kW of this motor…

Q: Q3. Each phase of a delta-connected load comprises a resistance of 300 and an 80µF capacitor in…

Q: A step down chopper has input dc voltage of 220 V and R = 10 Ω in series with L = 65 mH. If the load…

A: Given a step-down chopper has, Input DC voltage, Vs=220 V Resistor, R = 10 Ω in series with inductor…

Q: Q4: A) A 3-phase, 50 Hz, 400 V motor develops 100 H.P. (74-6 kW), the power factor being 0.75…

A: The Given is three phase, 50Hz, 400V and 100Hp motor of Power factor is 0.75 lagging and efficiency…

Q: n ac motor is connected to a 560v, 60hz line. The motor has a current draw at full load of 53A. A…

A: Power factor is defined as -the cosine of angle between voltage and current.…

Q: 2- Calculate the effective, reactance and apparent capacities provided by the circuit source shown…

Q: A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of 158…

Q: a) The network shown in Figure 1 has a total active power of 2253 W. Determine: i) the total…

Q: An impedance coil is connected in series with a fixed resistor, and a 120-V, 50-cycle Source is then…

Q: 8. The circuit below is similar to Problem 7 and operates at a frequency of 10 kHz. Circuit element…

Q: For each of the following circuits calculate the active power, reactive power, power factor and…

Q: ww C R www is 7.5 mH 12 Q2 Z ?For the circuit shown above, what is the maximum average power that…

Q: 6. A 240-Vma 50-Hz supply serves a load that is 10 kW (resistive), 15 KVAR (capacitive), and 22 KVAR…

A: Dear,as per company guidelines we can answer only 3 sub-parts at a time, kindly post other sub-part…

Q: A coil of inductance 80 mH and resistance 60 is connected to a 200 V, 100 Hz supply. 10. Calculate…

Q: Example: For the circuit shown: a)- find the overall complex power and pf. b)- find the value and…

Q: Rioad load BjoLoad Road (50 points) 网Load load source load source An electric dryer with an…

A: Suppose there is a voltage source v(t). The resistance of the circuit is R and inductance is wL.

Q: 20 Vrms source supplies a parallel RLC circuit with the following values: R=100 ohms, XL=200 ohms…

Q: A circuit comprises a coil of inductance 113.68mH, resistance 3on in series with a variable…

Q: An ac circuit having a resistance of 62, an inductor of 0.12H and a capacitance 50µf in series, is…

Q: Q4. Assuming that in the circuit of figure belowv, (t) = 8 cos(2t-40°), find the average power…

A: Given circuit shown vs(t)=8cos(2t-40°)

Q: 1. A load has the following information: o Line Voltage: 220V o Line current: 5A o Frequency: 60 Hz…

A: The solution is given below

Q: A resistor of 25Ω is connected in series with a capacitor of 45μF. Calculate (a) the impedance, and…

Q: 1. The admittance of a network is (0.05– j0.08) S. Determine the values of resistance and reactance…

A: Admittance- The admittance is reciprocal of impedance. The unit of admittance is Mho.…

Q: A circuit consisting of a resistor in series with an inductance consumes 210W at a power factor of…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Each phase of a star connected load consists of a resistance of 100 2 in parallel with a capacitance…

Q: A single-phase, 50 Hz, RLC circuit draws a current of 3.5 A. The value of the R, L and C are 80 N,…

A: Given that f=50HzR=80 ohmL=175 mHC= 30 μFI=3.5 A Now calculate inductive and capacitive impedance of…

Q: A dc transmission facility is modeled by the approximate series circuit shown below. If the load…

Q: Electrical system in a factory, X kW heater and 245 kVA inductive power coefficient of 0.65 It…

Q: The load at a certain factory consists of the following: 10 kW, pf = 0.6 lagging 15 kW, rf = 0.5…

Q: A circuit comprises a coil of inductance 113.68mH, resistance 302 in series with a variable…

Q: 5. A voltage having frequency of 50 Hz and expressed by V = 200+j100 is applied to a circuit…

Q: 1. A resistance of 1000, an inductance of 75.0 mH, and a capacitor of 4.0 uF are connected in series…

Q: 6. A 240-V,ms 50-Hz supply serves a load that is 10 kW (resistive), 15 KVAR (capacitive), and 22…

Q: 2. A resistor of 25 2 is connected in series with a capacitor of 50 µF. Calculate (a) the impedance,…

Q: 14. A series circuit composed of a resistance of 24 ohms, an inductance of 0.09 henry and a…

Q: A 100 kva load operates at 0.75 lagging power factor when connected to a 230v, 60hz AC source. The…

A: An a.c circuit differs from a d.c circuit in many respects. First, in a d.c circuit we consider…

Q: 3. A circuit having a resistance, an inductance and a capacitance in parallel, is connected across a…

Q: The admittance of a network is (0.05– j0.08) S. Determine the values of resistance and reactance in…

Q: A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of 158…

Q: A series resistance-capacitance (R-C) circuit is connected to a 230 volt 60 cycle source. If the…

A: When R and C are connected in the circuit then Resistance is only responsible for the active power…

Q: A 3-phase, 50 Hz, 400 V motor input power is 84000W the power factor being 0.72 lagging. A bank of…

Q: 3. A series circuit composed of a resistance of 24 ohms, an inductance of 0.09 henry and a…

Q: Consider the system shown. E is a standard 120 V input. If the three loads are 45 W, 60 W and 75 W…

A: Given data, There are three loads which take 45 W, 60 W and75 W. E is a standard input voltage…

Q: Calculate the capacitance

Q: An impedance coil is connected in series with a fixed resistor, and a 120-V, 50-cycle Source is then…

Question

a) For the power electronics circuit shown below sketch the waveform of the
load current.
b) If V,=200V, f,=50HZ, E=80V, R=10Q and a=80°, find the average load
current when:
i-
a=10°
ii-
a=120°

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The impedance of an electrical circuit is (30 − j50) ohms. Determine (a) the resistance, (b) the capacitance, (c) the modulus of the impedance, and (d) the current flowing and its phase angle, when the circuit is connected to a 240V, 50 Hz supply.
A resistor of 50 ohms, a 200mH inductor, and a 1.5 x 10-4 F capacitor is connected in parallel to a 120-volt, 60 cps source. Calculate: a) the equivalent impedance b) the current in each load c) total current d) the total real, reactive, and apparent powers e) power factor.
A 3-phase, 50 Hz, 3000 V motor develops 600 H.P. (447·6 kW), the power factor being 0·75 lagging and the efficiency 0·93. A bank of capacitors is connected in delta across the supply terminals and power factor raised to 0·9 lagging. Each of the capacitance units is built of five similar 600-V capacitors. Determine the leading Kvar taken by each three sets.
Exercise 2: Resistance-Capacitance Series Circuits on an AC Supply Calculate (a) peak to peak voltage (b) time period (c) Total impedance (d) Total voltage and (e) Voltage across the resistor for the circuit given.
A 3- phase , 50 Hz, 400 motor develops 100 H.P. ( 74.6 kW ), the power factor being 0.75 lagging and efficiency 93%. A bank of capacitors is connected in delta across the supply terminals and power factor raised to 0.95 lagging . Each of the capacitance units is built of 4 similar 100 V capacitors . Determine the capacitance of each capacitor .
At full load, a commercially available 100 hp, three-phase induction motor operates at an efficiency of 97% and a power factor of 0.88 lag. The motor is supplied from a three-phase outlet with a linevoltage rating of 208 V. 1. a) What is the magnitude of the line current drawn from the 208 V outlet? (1 hp=746 W.) 2. b) Calculate the reactive power supplied to the motor.
A 3-phase, 50Hz, 415V motor develops 100 H.P.(74.6kW), the power factor being 0.85 lagging and efficiency of 95%. A bank of capacitors are connected in delta across the supply terminals and power factor is increased to 0.96 lagging. Each of the capacitance units is build of four similar 100 V capacitors. Determine the capacitance of each capacitor.
Calculate the capacitance and charging current of a single-core cable used on a 3-phase, 66 kV system. Thecable is 1 km long having a core diameter of 10 cm and an impregnated paper insulation of thickness 7 cm. Therelative permittivity of the insulation may be taken as 4 and the supply at 50Hz.
TOPIC: Ohm's Law, Power and Generating Direct CurrentDirect Current Circuit AnalysisInductor, Capacitor, Generating Alternating Current Please Answer: V6 R45 R2345
A coil has a resistance of 4 and an inductance of 9.55 mH. Calculate (a) the reactance, (b) the impedance, and (c) the current taken from a 240V, 50 Hz supply. Determine also the phase angle between the supply voltage and current
A coil with an inductance of 100 mH is connected in series with a resistance of 20 Ω. To this system If 110 V AC with a frequency of 25 Hz is applied, the impedance, current, resistance and coil of the system Find the voltage at the terminals, active, reactive and apparent power values of the system.
. A power station has a connected load of 48 MW. The energy generated for the year is 61,500 MWh. If the station has a load factor of 35%, solve the demand factor of the station. Answer: 0.4179 or 41.79% Subject: Distribution System and Substation Design