A I, FE= Z0.252 = looV ETllov 日 T220v 0.22 by I need this at nodal solution

Q: Convert into rectangular, polar and exponential form: Given: Z1= 2-j3

A: To convert the given complex number into rectangular, polar and exponential form: Z1 = 2-j3

Q: Calculate the Apparent power (complex in VA), real power (real part in W) and reactive power…

A: Let the current flowing through 40 Ω from top node to bottom node is I1 and the current…

Q: Which of the following phasor diagram correctly depicts the phase relationship of the source e and…

A:

Q: A 50 ΩΩ transmission line is matched with a load ZlZl. If the frequency of operation is 100MHz100MHz…

A: When the impedance of the load is same as the characteristic impedance of the transmission line ,…

Q: A impedance of Z = 2553.13°Q is connected across a source with a voltage of 169.706 sin (157.080t)…

A: f) To find the simplified power waveform equation

Q: 1) Derive the following expression for the calculation of capacitance of three phase system…

A: 1) The expression for the calculation of capacitance of the three-phase system considering the earth…

Q: (b) A three-phase system has voltages expressed in time domain as follows: Von (t) = 110cos(wt +…

A: If time domain signal is of the form Vm cos(wt+phi) than phasor representation of the signal is Vm…

Q: Compute the reactive power for -j252 with a voltage source, Vg = 24020° (rms) 12.5 N 15 2 V, -j25 N…

A: In this question we will find reactive power in capacitor...

Q: 1. Determine (in polar form): a) Z₁, b) overall p.f., c) Ir. d) Pr. e) Sr. f) Qr бя дет 20020х неод…

A: To find the following in polar form a) ZT b) overall p.f. c) IT d) PT e) ST f) QT

Q: (b) Determine the following expressions in polar form. (i) v(t) = 40 cos(200t – 60°) V (ii) i(t) =…

A:

Q: 12V 2012 4052 * 50Ω www – 10Ω 30Ω

A:

Q: vi(z,t) = sin(@t - kz) v2(Zt) = sin([@ + A@]t- [k+ Ak]z) %3D Derive analytically an expression for…

A: Given two fields is - v1z,t=sinωt-kzv2z,t=sinω+∆ωt-k+∆kz

Q: The voltage V, in the frequency-domain circuit shown in (Figure 1) is 120./0° V (ms). • Part A Find…

A:

Q: 02 of 2) i) Convert i(t) = 4 sin(6t – 60°) A to phasor form: ii) If L = 50mH with w=1000 rad/s, what…

A:

Q: (a) A load has impedance, Z = (50 + j14) N. Convert this value of Z into polar form, |Z|40, where Z…

A:

Q: 0=685-1922,2=0.00497 Neper / mile 1=0.0352 rad /mik at 1000 Hz. If Z₁ = 2 and E= 10 Vrms with Zgs…

A: Given, l=1000 miles Zo=685-j92 ohm α=0.00497 Np/mile β=0.0352 rad/mile f=1 KHZ ZL=2000 ohm E =10Vrms…

Q: For a driven series R⁢L⁢C circuit, the voltage amplitude V0 and frequency f of the voltage generator…

A:

Q: Q3 (a) In Figure Q3(a), the load impedance, Zi is adjusted until it absorbs the maximum average…

A:

Q: 1T 1L Q.12: The non-sinusoidal applied voltage for the circuit shown is: (e,=5+4sin1000t+2sin3000t)…

A:

Q: (b) Determine the following expressions in polar form. (i) v(t) = 40 cos(200t – 60°) V (ii) i(t) =…

A:

Q: I, = 2 A Z 0° %3D IR YT 20 XL 50 E ll +

A: We need to find out admittance and current and power factor for given circuit

Q: السؤال 4 The Thevenin impedance of a source is ZTh = 101+ j 582, while the Thevenin voltage is VTh =…

A:

Q: e the load impedance ZL which will dra nding maximum power. 10L20° v

A: Since you have asked a multiple question we will solve the first question for you, If you want any…

Q: STION 8 the phase in degrees (with respect to the +x axis) when dividing two complex numbers, Z1/Z2?…

A: In this question we will find phase of given number... Note:- as per our guidelines , I will answer…

Q: = 2. Express y - ₁ + y₂ as a single sinusoidal function if y₁ and Y₂ = 40 cos(wt+ 60°) A) Solve by…

A:

Q: e Figure below, calculate Z₁.

A: MOSFET (Metal–oxide–semiconductor field-effect transistor)- It is a type if transistor which is…

Q: three-phase A system in Figure shown, Find the phase and line currents. Draw phasor diagram. K 120…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: Q1/ Use nodal voltage method, find the magnitude and direction of * .current I 10 V½ A В + Özsv 4 50…

A:

Q: 9. An impedance draws a current i(t) = 10sin(wt-30°) ampere from a voltage v(t) = 220cos(wt-65°)…

A: In this question,  Find the current and voltage in phasor form (peak and rms form)  Phasor form is…

Q: Obtain the Zin for the circuit shown. j30 2 ... 50 Ω ell j100 2 60 Ω Zin 40 Ω j20 Q Zin = Blank 1+…

A: if two impedances Z1 and Z2 are connected in series than equivalent impedance is Z1+Z2. if two…

Q: = The Thevenin impedance of a source is ZTh 89+ j 68, while the Thevenin voltage is VTh = 346 + j373…

A:

Q: HowiAlossless TL with charneteristic impedance of z. is terminated in Zr=3Zo use crank dingram to…

A: A lossless transmission line with a characteristic impedance of Zo is terminated in ZL=3Zo . We need…

Q: 80022 j125022 -J4502 Vs = 100 Sin (wt) V Soive for polar & Phasor form of Ziz, VR, V₂, Vc

A:

Q: Q6/ Determine the impedance Zx for the AC bridge shown in the figure below Z, =270 2230 Z, =420 2…

A:

Q: 62 Find power factor of given circuit ww 30/0° V rms O -j22 42

A: Power factor is the ratio of true power by apparent power. The value of power factor lies in between…

Q: Find the phase inductance of the three-phase circuit shown in the figure, if the separation between…

A: Given:S=45cm=0.45md=2.1793cm = 0.021793mr=0.0108965m Formula to calculate phase inductance is:…

Q: Pmine the following from the given R-L-C series circuit: ) Impedance Z ii) Current i iii) Voltage…

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: Compose the node equation. Multiply with the least common factor to remove fractions. 10 Q j10 O j10…

A:

Q: (b) The current through i(t) = Im cos(wt + 30°), Im = 5 mA, w = 6.283 rad/s, and the voltage across…

A:

Q: Between i1 = -30cos(ωt + 50°) and v1 = 24sin(ωt - 10°), calculate the phase angle. Sketch and state…

A:

Q: Compose the mesh equations. 10 Q j10 Ω j10 Ω ... ell A) 10 v [1] sine ) i5 v j5 V sine -j10 O [12]…

A: In this question,   We need to determine the current I1 and I2 as shown the circuit?

Q: 1. A series AC circuit consisting of R = 200 2 and L = 320 mH are connected across V = 20 VL0°, 100…

A: 1) For a series AC circuit consisting of R and L  Determine the following :  Inductive reactance,…

Q: Z, 5+/5 Z3 1-12 Z2 j4

A: The given figure is: Vf=100∠0°

Q: 10 Q j10 O j10 O ... ell A) 10 V [1] sine [ 12] j5 V sine :-j10 2 @mesh 1: Z11l1 + Z12l2 = Source,…

A: In this question,   We need to determine the impedance Z as shown in the circuit using the mesh…

Q: Three Impedances each of (6 - j28)2 are connected in mesh across a three-phase 415V ac supply.…

A: Phase current=phase voltgeimpedance. line current=3×phase current active power=3×I2R. reactive…

Q: 9VRMS 3/30°N ZL 3430°2 12-30°A

A:

Q: 3. For the AC network shown in Figure 3, the source voltage is 120V (RMS). 4Q2 j6Q ww a) 120/10° V…

A: Given:

Q: Problem #2 Zn the Circuit Shown below if Ve = 8 145, Calculate Ÿs ' -jz sz I, 22 R, V Vs V.

A: we need to find out Vs in the given circuit.

Q: IL Q.12: The non-sinusoidal applied voltage for the circuit shown is: (e;=5+4sin1000t+2sin3000t) V.…

A: Given data: eT=5+4sin1000t+2sin3000t V R=5 Ω XC=-18j Ω XL=2j Ω

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.