Three Impedances each of (6 - j28)2 are connected in mesh across a three-phase 415V ac supply. Determine the phase current, line current, active power, reactive power and apparent power drawn from supply. phase current (Ip) Line current real power reactive power Apparent power

Three Impedances each of (6 - j28)2 are connected in mesh across a three-phase 415V ac supply. Determine the phase current, line current, active power, reactive power and apparent power drawn from supply. phase current (Ip) Line current real power reactive power Apparent power

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.42P: A balanced -connected impedance load with (12+j9) per phase is supplied by a balanced three-phase...

See similar textbooks

Related questions

Q: Transform

Q: An impedance (6 + j8) Ω is connected across 220 V, 60-Hz mains in parallel with another circuit…

A: Admittance- Admittance is reciprocal of impedance. It is easily flow of current through it. The SI…

Q: i. Calculate the power factor of the load ZL. ii. Calculate i) by how much the required reactive…

Q: In a 390V, 57 Hz, three phase system, the value of the reactive power without capacitor bank is…

A: Given in the question: The system voltage is: V = 390V The system frequency is, F = 57Hz The…

Q: 2. A 60 Hz ídeal transformer ís rated at 4800/240 V. A load with impedance Z=12+ j9N is connected…

A: Turns ratio=primary voltagesecondary voltage power factor is the angel between voltage and current.

Q: What is the main direct cause of reactive power in AC system? A. Resistance of transmission lines B.…

A: The explanation is as follows.

Q: Three Impedances each of (8 - j18) are connected in mesh across a three-phase 410V ac supply.…

A: In this question we need to find a line current , phase current , real power and reactive power of…

Q: 18: A series resistive inductive load is energized from a 240V(RMS), 50HZ single phase A. supply,…

A: Given a series RL circuit having, Energized voltage, V = 240 V (rms) Frequency, f = 50 Hz Active…

Q: II. Problem Solving A 400 resistor is connected in parallel to a coil having a resistance of 102 and…

A: We need to find out current for given circuit

Q: Q27/ (b) Three Impedances each of (10 – j18)Ω are connected in mesh across a three-phase 425V ac…

A: Given Supply line voltage Vline=425 V Z1=10-j18 ΩZ2=10-j18 ΩZ3=10-j18 Ω The phase voltage is,…

Q: 14 15 16 The total current and phase angle The power factor of the circuit The total impedance

A: The frequency of the input ac signal is 50 Hz. So, the angular frequency of the ac signal will be…

Q: 22 (a) Three-phase generator consist of three set of single-phase generators, with voltages equal in…

Q: 3. Three impedances of 4+j3 ohm are A-connected to a three phase 208V source, find RMS values of the…

Q: For the circuit shown in figure 1, calculate the equivalent impedance of the network, assuming a…

Q: For a 3-phase ac device, full load current is 40A, line voltage is 450V and reactance value is…

Q: Two alternators are operating in parallel and sharing a common load. For increasing the load shared…

A: The explanation is as follows.the answer for the question is true.(a)

Q: A series circuit connected across a 200V, 60 hz line, consists of a capacitive reactance of 30 ohms,…

Q: Problem 4: A three phase motor draws 30 kVA at 0.80 power factor lagging from a 480 V three phase…

A: The data are given as KVA ratingS1=30kVA,Power factorpf1=cosϕ1=0.8 laggingso, ϕ1=36.87°.1) Without…

Q: Given a parallel circuit shown below, determine the: a. Branch current b. Total current c. Total…

Q: Given a tee connected system with power factor of 80 percent and true power of 2,500 kW. Calculate…

A: In this question we need to find a reactive power.

Q: a transmission line has an impedance of 4 12 Ohms/phase, Find the per-unit impedance of this line on…

Q: Three loads, each of resistance of 20 Q and inductance of 120 mH are connected in star with a…

Q: The instantaneous values ofthe voltage across a two element series circum and the current flowing…

Q: e phase angle of the complex power is negative, then the circuit is said to be resistive. elect one:…

A: In this question we will find circuit nature if complex power phase angle is negative...

Q: Complete Solution: A 250 - kVA, 0.5 lagging power factor load is connected in parallel to a 180 - W,…

Q: Three Impedances each of (14- j18)N are connected in mesh across a three-phase 415V ac supply.…

A: Introduction: The finished terminal of one winding is connected to the start terminal of the next…

Q: Impedances Z1 = 5.83∠- 59° ohms and Z2 = 8.94∠63.43° ohms are in series and carry an effective…

A: This a simple question of power calculation. Solution given below.

Q: 4Ω ww- ell Determine the load impedance that z, maximizes the average power drawn from the circuit.…

A: For dc source the maximum power transfer states that maximum power is abstract by load resistance if…

Q: The positive sequence harmonics component will add current to the neutral wire. Select one: O True O…

A: we know that positive sequence components are displayed by 120 degrees each other and sum of…

Q: An AC circuit with R, Land C in parallel, has the following branch currents. Resistive branch - 12 A…

A: The solution can be achieved as follows.

Q: = 7200 ∠ - 130 ° V VBN = 7200∠110 ° V? Also, find VCN

A: The sequence components are equal in magnitude and displaced by 120 degree. The angle between the…

Q: Consider a 3-phase delta-star configuration with a generator and a 3-phase load. The generator…

A: In a delta connected source, the phase and line voltage are equal. So, the phase and line voltage at…

Q: 3. The power factor of each phase of a balanced wye-connected 5-ohm impedance is 0.6 lagging. This…

Q: 12. A certain load takes 300 kW at 400 V. A three phase capacitor bank rated 15 kVA per phase is…

A: As per our policy, i have attempted 1 question Given data Reactive power of capacitor is QC=15 kVA…

Q: Determine the apparent power, power factor & power factor angle when connected in a) series; b)…

Q: 5 Assume a Thévenin equivalent source composed of V, in series with Ze (a) Prove that maximum…

Q: Problem 6 (AC Power Analysis) Find the complex power (S), apparent power (S), real power (P),…

A: In this question, In this circuit, find the complex power, apparent power S, real power P and…

Q: Determine the primary line current of the following three phase circuit using a 5:1 step-down…

A: Converting the star connection of resistance to delta we get (By star delta conversion ) value of…

Q: A parallel pair circuit of two impedances Z(1)= 11 + j 23 and Z(2)= 6 - j 13 is supplied with an AC…

Q: From the circuit below, determine secondary winding voltage Vsec if the primary winding voltage Vpri…

A: Given Vp = 120 Rms Transformer ratio is N1:N2 = 6 :1 Find Vsec

Q: A three phase star connected load has an impedance of 12 + j18 Ω per phase. A voltage of 440 V 3…

Q: Two single-phase ideal voltage sources are connected by a line of impedance of 0.7 + j2.4 Q as shown…

A: Different Powers are described below. Active Power(P): The power which is deployed and absorbed by…

Q: 17.) A single-circuit three-phase transposed transmission Iine is composed of four bundled ACSR…

A: A single circuit three-phased transposed transmission line as seen in the figure is composed of four…

Q: The substation power factor is found from the total reactive and real powers of the various loads…

Q: □6 Assume a Thévenin equivalent source composed of V, in series with Zeq = Ree+1X (a) Prove that…

Q: As shown in the figure, two single-phase loads are connected in parallel to a voltage source of 200…

A: First calculate current in the individual loads and than calculate total current from the source.…

Q: A 3-phase, 20 MVA, 10 kV alternator has internal reactance of 5% and negligi resistance. Find the…

Question

Three Impedances each of (6 - j28)2 are connected in mesh across a three-phase 415V ac supply. Determine the phase current, line current, active power, reactive
power and apparent power drawn from supply.
phase current (Ip)
Line current
real power
reactive
power
Apparent power

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
A source supplies power to the following three loads connected in parallel: (1) a lighting load drawing 10kW. (2) an induction motor drawing 10kVA at 0.90 power factor lagging, and (3) a synchronous motor operating at 10hp,85 effIciency and 0.95 power factor leading (1hp=0.746kW). Determine the real, reactive, and apparent power delivered by the source. Also, draw the source power triangle.
In a balanced system, the phasor sum of the line-to-line voltages and the phasor sum of the line-to-neutral voltages are always equal to zero. (a) False (b) True
A single-phase source has a terminal voltage V=1200volts and a currentI=1530, which leaves the positive terminal of the source. Determine the real and reactive power and state whether the source is delivering or absorbing each.
Two balanced Y-connected loads, one drawing 10 kW at 0.8 power factor lagging and the other IS kW at 0.9 power factor leading, are connected in parallel and supplied by a balanced three-phase Y-connected, 480-V source. (a) Determine the source current. (b) If the load neutrals are connected to the source neutral by a zero-ohm neutral wire through an ammeter, what will the ammeter read?
The power factor for an inductive circuit (R-L load), in which the current lags the voltage, is said to be (a) Lagging (b) Leading (c) Zero
Consider a three-phase Y-connected source feeding a balanced- load. The phasor sum of the line currents as well as the neutral current are always zero. (a) True (b) False
A 60Hz, single-phase source with V=27730 volts is applied to a circuit element. (a) Determine the instantaneous source voltage. Also determine the phasor and instantaneous currents entering the positive terminal if the circuit element is (b) a 20 resistor. (C) a 10mH inductor, and (d) a capacitor with 25 reactance.
A balanced -connected impedance load with (12+j9) per phase is supplied by a balanced three-phase 60-Hz,208-V source, (a) Calculate the line current, the total real and reactive power absorbed by the load, the load power factor, and the apparent load power, (b) Sketch a phasor diagram showing the line currents, the line-to-line source voltages, and the -load currents. Use Vab as the reference.
3. Two impedance Z1= 12+j 16 ohms and Z2= 4- j4 ohms are connected in parallel across 240 volts , 60 hertz AC supply, Find the total power factor and total current in rectangular form.
Circuit elements with an inductance of 200 mH, a capacity of 50 μF and a resistance of 10 Ω connected in parallel. if we apply average value of 198 V sinusoidal AC voltage to the system . Find the line current, impedance and phase angle of the circuit. (Take Frequency in 60 Hz)
Convert the wye-connected load to its delta equivalent. What is the per phase impedance of the delta equivalent load? What is the total real and total reactive power consumed by the three-phase load regardless if wye or delta?