A mixture of NaCl, SiO2, and CaCO3 is separated following the procedure given in this experiment. Indicate how each of the following procedural changes would affect the amount of the specified substance recovered. Briefly explain. Hint: Refer to Table 1 for Solubility & Reactivity The recovery of CaCO3 was attempted by adding 3M H2SO4 instead of 3M HCl to the SiO2/CaCO3 residue.

A mixture of NaCl, SiO2, and CaCO3 is separated following the procedure given in this experiment. Indicate how each of the following procedural changes would affect the amount of the specified substance recovered. Briefly explain. Hint: Refer to Table 1 for Solubility & Reactivity The recovery of CaCO3 was attempted by adding 3M H2SO4 instead of 3M HCl to the SiO2/CaCO3 residue.

Organic Chemistry: A Guided Inquiry

2nd Edition

ISBN:9780618974122

Author:Andrei Straumanis

Publisher:Andrei Straumanis

Chapter20: Acidity And Pka Of Phenols

Section: Chapter Questions

Problem 11E

See similar textbooks

Similar questions

TLC, a powerful analytical tool, can be used to monitor the progress of reactions. The synthesis of ethyl-3-coumarincarboxylate can be monitored by TLC by displaying the starting aldehyde 1, and coumarin product 2, which have very distinct Rf values (Hint: Think about the polarity of compounds 1 and 2 in terms of their abilities to H-bonds to silica gel). What can be determine about the progress of the reaction from analysis of the TLC shown below?
Q1: Give one lysis buffer that is commonly used for western blotting experiments and include its components Q3: To make sure that you used a similar amount of samples, what important step should be done before proceeding the electrophoresis stage? Q4. Why is it necessary to store the prepared lysates in a very low temperature?
Please answer questions 4, 5 and 6 on the attached sheet. Please provide the major and any minor products for the SN1 and E1 reactions and explain how they were calculated. Thank you.
If i cannot use ammonia water, what can i use as a substitute to make my acid supernatant to be an alkaline? After being macerated with 95% ethanol and dissolved in 5% acetic acid, I got an acid supernatant and I was supposed to use ammonia water along with dichloromethane but the ammonia water was disregarded due to specific reasons. What can I replace my ammonia water with to make my acid supernatant an alkaline?
In each of the following reactions, one of the reagents contains two reactive groups (either acidic or basic). You have to decide which group will be affected under mentioned conditions. To answer this problem correctly I suggest that you use the following strategy: (i) Write the products of the reaction: conjugate acid and conjugate base. Use curved arrows to track the flow of electrons; (ii) Using Table 3.1 of the textbook estimate and write pKa values for all acidic groups you have in the reaction equation including conjugate acid; (iii) If you wrote the correct reaction the estimated pKa values should confirm that the reaction transformation changes stronger acid to weaker acid and stronger base to weaker.
For the following reactions, draw arrow-pushing mechanisms for each of the reactions that (a) extracted them into the aqueous layer and (b) forced them to precipitate out. Acidic compound precipitated after the addition of HCl.
Help. On standing in 17O-labeled water, both formaldehyde and its hydrate are found to have incorporated the 17O isotope of oxygen. Suggest a reasonable explanation for this observation.
Phenol vs salicylic acid Both of them undergo Esterification where acetic anhydride is added to both of them. Which among the two samples is faster in giving the results and why?
What type of reaction is a Grignard reaction? What is the critical intermediate (which can be isolated and enables the final product)? Why should water be excluded from a Grignard reaction? Since this is the case, why does just addition of a cotton ball work for our reaction setup? Why was extraction by both acid AND base necessary to arrive at highly purified benzoic acid? If we wanted to improve our set-up, we could have added a desiccant between two cotton plugs. Why is this much better than adding drying agents such as Na2SO4directly into the solution? If we had gotten less than 50% yield for the overall process, what is at least one likely source of loss?
the equations used in a certain experiment would have to be modified slightly if an acid with Ka of 1.0x10^-3 or greater were used as an unknown. Assuming such a situation, explain the problems that would result from the use of the equations in their present form. What modifications would you make to give accurate results when using such an unknown?
Please provide a clear solution for me to study it. Thank you!
Draw reaction mechanisms, using curved arrows to show the flow of electrons, for the acid-base reactions used to recover and precipitate benzoic acid and m-nitroaniline, indicating on each side of the reactions if the organic compound would be in the aqueous of organiclayer. make sure the drawing is neat :)