A mixture of three proteins was subjected to ion exchange chromatography using CM-cellulsoe as the stationary phase. The elution buffer had a pH of 7.5. Proteins were eluted by increasing the ionic strength of the buffer. Predict the order of elution of the following proteins: Pepsinogen, pI = 1 Cytochrome c, pI = 10.6 Myoglobin, pI = 6.8

A mixture of three proteins was subjected to ion exchange chromatography using CM-cellulsoe as the stationary phase. The elution buffer had a pH of 7.5. Proteins were eluted by increasing the ionic strength of the buffer. Predict the order of elution of the following proteins: Pepsinogen, pI = 1 Cytochrome c, pI = 10.6 Myoglobin, pI = 6.8

Curren'S Math For Meds: Dosages & Sol

11th Edition

ISBN:9781305143531

Author:CURREN

Publisher:CURREN

Chapter10: Reconstitution Of Powdered Drugs

Section: Chapter Questions

Problem 7.6P

See similar textbooks

Similar questions

Given a stock protein solution with a concentration of 6 mg/ml, determine the protein concentration of a solution made by mixing 5 μl of the stock with 5 μl of a buffer.
If you added three proteins (Protein A, pI 5.0; Protein B, pI 6.0; Protein C, pI 7.0) to an anion exchange column equilibrated with bicine buffer, pH 8.5, in what order would these protein be expected to elute as the column was loaded, washed, and then increasing amounts of NaCl were added?
Table 2. Volume of BSA, protein content, and absorbance readings of reference solutions Solution Volume of BSA standard solution (μL) Protein content(μg/mL) Absorbance value At 595 nm 1 0 0 0 2 10 1 0.022 3 30 3 0.065 4 50 5 0.106 5 70 7 0.178 6 100 10 0.299 7 120 12 0.380 Make a graph by plotting the absorbance values versus the BSA protein content (in μg) for theseven reference solutions. When constructing the graph, be…
You obtained the following raw data when setting up a Biuret standard curve: BSA (mg/ml) Absorbancy 540nm 0 0.158 1 0.210 2 0.260 3 0.305 4 0.360 5 0.410 6 0.455 7 0.510 8 0.530 9 0.550 10 0.554 After blanking against a biuret-dH2O sample, the protein concentration of an unknown sample was determined using the same method and an absorbancy of 0.284 was obtained. Set up a standard curve, excluding outliers (experimental and statistical) and determine the protein concentration in the unknown sample in mg / ml (up to 3 significant figures).
Three buffers are made by combining a 1M solution of acetic acid and a 1M solution of sodium acetate in the ratios shown in the table below. Which of these statements is true regarding the prepared buffers? (Ka= 1.7x10-5) pH of buffer 1 < pH of buffer 2 < pH of buffer 3 pH of buffer 1 = pH of buffer 2 = pH of buffer 3 pH of buffer 1 > pH of buffer 2 > pH of buffer 3 pH of buffer 1 = pH of buffer 2 > pH of buffer 3 pH of buffer 1 > pH of buffer 2 = pH of buffer 3
What is the pH of a buffer of a buffer system that contains a weak acid of .19 M and conjugate base of .12 M ? The Ka of the acid is 5.6x 10 -6 pH= pKa + log ( [A- ]/[HA]) please show me step by step
You are given two proteins with a pI of 4.5 and pI of 7.7. In an example of an anion-exchange column, can you use a buffer to separate these two proteins? What buffer protein can be used to separate the two proteins mentioned above?
The protein concentration of a known standard is 100mg/mL If you prepared a serial dilution, mixing 10μL of protein with 40μL of water what would be concentrations of the first 3 dilutions?
Four known amino acids (AA) produce a chromatograph with Rf values as follows: AA1 =0.25, AA2 =0.66, AA3=0.50,AA4=0.80. A mixture of three amino acids yields spots that are 2 cm,5.2cm, and 6.4 cm from the organ. The solvent front is 8.0 cm from the origin. Which three of the four amino acids are contained in the mixture?
You obtained the following raw data when setting up a Bradford standard curve: BSA (mg/ml) Absorbancy 595nm 0 0.225 1 0.310 2 0.420 3 0.510 4 0.610 5 0.720 6 0.810 7 0.915 8 0.950 9 0.980 10 0.990 After blanking against a bradford-dH2O sample, the protein concentration of an unknown sample was determined using the same method and an absorbancy of 0.570 was obtained. Set up a standard curve, excluding outliers (experimental and statistical) and determine the protein concentration in the unknown sample in mg / ml (up to 3 significant figures).
When performing a separation by ion-exchange chromatography, the rate of elution of an amino acid is influenced by three main factors: a. Temperature b. Solution (buffer) pH c. Ionic strength (buffer concentration) of the eluent Briefly, explain how each of these parameters influences elution rate. Please provide only typed answer solution no handwritten solution needed allowed
Consider a crude extract with a mixture of the 5 proteins listed below. Protein A 4.5 pl 160 molecular weight, kDa Protein B 12.5 pl and 65 molecular weight Protein C 5.0 pl, 15 molecular weight Protein D 6.8 pl, 150 molecular weight Protein E 9.5 pl, 45 molecular weight You load this protein mixture onto an anion exchange column at pH 11. Next, you apply a "washing" step by passing through buffer at pH 11. Finally, for your elution step, you apply a pH gradient starting from pH 11 to pH 2.0 (A gradient buffer system allows you to gradually and continuously change the pH of your mobile phase starting from pH 11 up to pH 2). You load this same protein mixture onto a Size Exclusion column. Please indicate the order in which these proteins will elute for both. Group of answer choices Yes or No, please explain your answer. If your protein of interest is protein A, would using anion exchange column be completely successful at separating it from all the other proteins? Group of answer…