A sample of gas contains 0.1500 mol of CH4(g) and 0.3000 mol of O,(g) and occupies a volume of 17.0 L. The following reaction takes place: CH4(g) + 202(g)→CO2(g)+ 2H,0(g) Calculate the volume of the sample after the reaction takes place, assuming that the temperature and the pressure remain constant.

A sample of gas contains 0.1500 mol of CH4(g) and 0.3000 mol of O,(g) and occupies a volume of 17.0 L. The following reaction takes place: CH4(g) + 202(g)→CO2(g)+ 2H,0(g) Calculate the volume of the sample after the reaction takes place, assuming that the temperature and the pressure remain constant.

Chemistry: An Atoms First Approach

2nd Edition

ISBN:9781305079243

Author:Steven S. Zumdahl, Susan A. Zumdahl

Publisher:Steven S. Zumdahl, Susan A. Zumdahl

Chapter8: Gases

Section: Chapter Questions

Problem 97E: Hydrogen azide, HN3, decomposes on heating by the following unbalanced equation: HN3O(g)N2(g)+H2(g)...

See similar textbooks

Similar questions

In a typical automobile engine, a gasoline vapor-air mixture is compressed and ignited in the cylinders of the engine. This results in a combustion reaction that produces mainly carbon dioxide and water vapor. For simplicity, assume that the fuel is C8H18 and has a density of 0.760 g/mL. (a) Calculate the partial pressures of N2 and 02 in the air before it goes into the cylinder; assume the atmospheric pressure is 734 mmHg. (b) Consider the case where the air, without any fuel added, is compressed in the cylinder to seven times atmospheric pressure, the compression ratio of many modem automobile engines. Calculate the partial pressures of N2 and O2 at this pressure. (c) Now consider the case where 0.050 mL gasoline is added to the air in the cylinder just before compression and completely vaporized. Assume that the volume of the cylinder is 485 mL and the temperature is 150C. Calculate the partial pressure of the gasoline vapor. (d) Calculate the amount (mol) of oxygen required to bum the gasoline in part (c) completely to CO2 and H2O. (e) The combustion reaction in the cylinder creates temperatures in excess of 1200K. Due to the high temperature, some of the nitrogen and oxygen in the air reacts to form nitrogen monoxide. If 10% of the nitrogen is converted to NO, calculate the mass (g) of NO produced by this combustion. (f) Hot-rod cars use another oxide of nitrogen, dinitrogen monoxide, to create an extra burst in power. When such a power boost is needed, dinitrogen monoxide gas is injected into the cylinders where it reacts with oxygen to form NO. Calculate the mass of dinitrogen monoxide that would have to be injected to form the same quantity of NO as produced in part (e). Assume that sufficient oxygen is present to do so.
93 The complete combustion of octane can be used as a model for the burning of gasoline: 2C8H18+25O216CO2+18H2O Assuming that this equation provides a reasonable model of the actual combustion process, what volume of air at 1.0 atm and 25°C must be taken into an engine to burn 1 gallon of gasoline? (The partial pressure of oxygen in air is 0.21 atm and the density of liquid octane is 0.70 g/mL.)
A collapsed balloon is filled with He to a volume of 12.5 L at a pressure of 1.00 atm. Oxygen, O2, is then added so that the final volume of the balloon is 26 L with a total pressure of 1.00 atm. The temperature, which remains constant throughout, is 21.5 C. (a) What mass of He does the balloon contain? (b) What is the final partial pressure of He in the balloon? (c) What is the partial pressure of O2 in the balloon? (d) What is the mole fraction of each gas?
A mixture at 33 °C contains H2at 325 torr. N;at 475 tore and O2at 650. torr. What is the total pressure of the gases in the system? Which gas contains the greatest number of moles?
A chemist weighed out 5.14 g of a mixture containing unknown amounts of BaO(s) and CaO(s) and placed the sample in a 1.50-L flask containing CO2(g) at 30.0C and 750. torr. After the reaction to form BaCO3(s) and CaCO3(s) was completed, the pressure of CO2(g) remaining was 230. torr. Calculate the mass percentages of CaO(s) and BaO(s) in the mixture.
Nitrogen trifluoride is prepared by the reaction of ammonia and fluorine. 4 NH3(g) + 3 F2(g) 3 NH4F(s) + NF3(g) If you mix NH3 with F2 in the correct stoichiometric ratio, and if the total pressure of the mixture is 120 mm Hg, what are the partial pressures of NH3 and F2? When the reactants have been completely consumed, what is the total pressure in the flask? (Assume T is constant.)
Butyl mercaptan, C4H9SH, has a very bad odor and is among the compounds added to natural gas to help detect a leak of otherwise odorless natural gas. In an experiment, you burn 95.0 mg of C4H9SH and collect the product gases (SO2, CO2, and H2O) in a 5.25-L flask at 25 C. What is the total gas pressure in the flask, and what is the partial pressure of each of the product gases?
Hydrogen azide, HN3, decomposes on heating by the following unbalanced equation: HN3O(g)N2(g)+H2(g) If 3.0 atm of pure HN3(g) is decomposed initially, what is the final total pressure in the reaction container? What are the partial pressures of nitrogen and hydrogen gas? Assume the volume and temperature of the reaction container are constant.