A silicon transistor is biased with base reistor method. If ß = 100, VBe = 0.7V, zerosignal collector current Ip = 1µA and Vcc = 6V, what is the value of base resistor Rc ?A. 105 ΚΩВ. 530 KAС. 315 КОD. 60KNCDВA

A silicon transistor is biased with base reistor method. If ß = 100, VBe = 0.7V, zero signal collector current Ig = 1µA and Vcc = 6V, what is the value of base resistor Rc ? %3D А. 105 KN В. 530 KA С. 315 КО D. 60KN

A silicon transistor is biased with base reistor method. If ß = 100, VBe = 0.7V, zero signal collector current Ig = 1µA and Vcc = 6V, what is the value of base resistor Rc ? %3D А. 105 KN В. 530 KA С. 315 КО D. 60KN

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter29: Solid-state Electronics

Section: Chapter Questions

Problem 3STP

See similar textbooks

Related questions

Q: 10. The capacitance of a Au-n-GaAs Schottky-barrier diode is given by the relation 1/C² = 1.57x1015…

Q: For the tronsistor in thhe folowing figure.itB is (0.02mA). B H100, then Rc value is:

A: Answer 5 K ohm

Q: Q°: Assume ideal diode. Find the values of the labeled voltage and current. + 3 V + 3 V 5 kn 10 kn Z…

Q: The maximum power dissipation of a transistor is 100mW. If VCE = 20V, what is the maximum collector…

Q: Determine the saturation current in a pan junction diode at 256k if a voltage of 0.0668v produces a…

A: The current through a p-n junction diode is I=IseqVkBT-1 The saturation current is, Is=IeqV/kBT-1

Q: A transistor is connected in common base mode and amplification factor is 0.98 and leakage current…

Q: In the following cascade amplifier, which omits the bias elements, the operating point and…

A: Given : Omits the bias elementsSpecification of the transistor is as follows…

Q: Process in which conductivity of semiconductor can be drastically increase by adding controlled…

A: The conductivity of silicon is increased by adding a very small amount of impurity which is in order…

Q: Q1: Estimate the ratio of the electron densities in the conduction bands of silicon (Eg = 1.14 eV)…

Q: What semiconductor is frequently used for its high reliability at high speed? Explain why.

A: A semiconductor is an electronic device that is based on the electronic properties of semiconductor…

Q: Q1/ At 300K, the intrinsic concentration of Ge is 2.5 x 1019 m-3. Given thet the mobility of…

A: Here at given temperature at 300 k the intrinsic concentration of th Ge is 2.5 × 10¹⁹ m-³. It also…

Q: Calculate the space width for a p-n junction when a reverse bias with 3V is applied at T=350K.…

A: The total space width for a p-n junction when reverse bias voltage is applied is given the following…

Q: A sample of Si is doped with 1016 phosphorus atoms /cm3, find the Hall voltage in a sample with…

Q: Q.1: A transistor has a collector current of 10 mA and a base current of 40 micro-A. What is the…

A: Solution:

Q: 7.6 A silicon pn junction in thermal equilibrium at T = 300 K is doped such that EF- EFi = 0.365 eV…

Q: 6l An n-p-n transistor having aurrent gain a=0.90 is connected in the CB mode and gives a reverse…

A: Given: Current gain=α=0.90 Reverse saturation current=Ico=15μA=15×10-6A Emitter current=4mA=4×10-3A

Q: Here Given the citecuilt diagram with six reesistors. A B Herre a rearteny of eng E. Herre the…

Q: The cascaded amplifier of figure below uses a common collector first stage followed by a common…

Q: 4.) Consider a silicon pn junction at T = 300K. The reverse-saturation current is 4 x 10-13A.…

Q: In a transistor, B = 45, the voltage across 5 k Q resistor which is connected in the %3D collector…

A: In the Question given current gain , resistance and collector voltage and we have to find the base…

Q: A sample of Si is doped with 1016 phosphorus atoms /cm3 , find the Hall voltage in a sample with…

A: Given: The concentration of impurity atoms (n) is 1016 atoms/cm3. The thickness (W) of the probe is…

Q: 1. The energy of an electron in the valence band of a semiconductor is described by E = - Ak? where…

Q: Q1) 1- How do we control the collector current when npn transistor is working in saturation?…

A: QUESTION :-(1) In saturation mode both emitter and collector npn transistor are forward biased. And…

Q: An npn transistor operates as a common emitter amplifier, with a power gain of 60 dB. The input…

Q: 3. At room temperature under the forward bias of 0.15 V the current through a p-n junction is 1.66…

A: In a p-n junction diode, the value for current is, I=1.66 mA=1.66×10-3 A Voltage across diode,…

Q: A light emitting diode is A. heavily doped, B. lightly doped, C. Intrinsic semiconductor, D. Zener…

Q: Sample of Ge of volume (-1 cm) contains about, 3 x104 free electrons, and 3x10 holes, doping donates…

Q: Q10 (a) State in words and in the form of a truth table the actions of the following logic gates.…

Q: An NPN transistor has beta value of 200. Calculate the base current required to switch a resistive…

A: Given : beta value, β = 200 Collector current, Ic = 4 mA

Q: (c) A common emitter BJT circuit and its voltage transfer curve is shown in Fig. 1(c) respectively.…

A: In this question we have to determine the voltages and currents at different points in the circuit.…

Q: Q3 Consider a silicon pn junction at T 300 K with acceptor doping concentrations of 1016 cm-3 and…

A: Given: T=300KNa=1016 cm-3 Nd=1015 cm-3Vrev=5Vni=1.5*1010 cm-3εs=1.035*10-12 F/cm

Q: Q.1. Determine whether each silicon diode in Fig.1 is forward biased or reversed biased. 100 V 10 n…

A: (a) Explanation: Calculate the potential across the diode. VAB=VA-VB Substitute the values. VAB=5…

Q: 3) What is the probability of an electron being thermally promoted to the conduction band in silicon…

A: Given that the value of Egypt and temperature and we have to determine the probability of occupancy…

Q: What are the major differences between MOS and BJT transistors?

A: The major differences between MOS or MOSFET (Metal Oxide Semiconductor Field-Effect Transistor) and…

Q: In the given figure, assuming all transistors are minimum size with channel resistance R-8kN and…

Q: A silicon wafer is doped with 5x1020 phosphorus atoms/m³. Calculate the hole concentrations after…

Q: The value of the collector resistor in an npn silicon transistor amplifier with Bdc= 250, VBB= 2.5…

A: Solution: (i) Calculate the base current. IB=VBB-VBERB Substitute 0.7V for VBE, 2.5V for VBB, 100kΩ…

Q: For the Zener diode regulator shown in the figure below, Determine VL, VR, Iz and the power…

A: Since you have asked multiple question, we will solve the first question for you.if you want any…

Q: A 10V zener diode is used to regulate the voltage across a variable load-resistor. The input voltage…

A: The formula for the Zener diode voltage regulator is:

Q: The transfer characteristic curve of a transistor, having input and output resistance 100 Q and 100…

Q: conceniration (em) The electron and hole concentrations in a sample of silicon are shown in Figure…

Q: .A transistor with a 0.98 is operated as an amplifier in a common base circuit with a load…

Q: Question 14.11: A p-n photodiode is fabricated from a semiconductor with band gap of 2.8 ev. Can it…

A: Given value--- energy band gap = 2.8 eV . wavelength = 6000 nm . We have to find--- can it detect…

Q: An NPN transistor is used in common emitter configuration as an amplifier with 1 kQ load resistance.…

Q: The input resistance of a silicon transistor is 100 Ω. Base current is changed by 40 µA which…

Question

A silicon transistor is biased with base reistor method. If ß = 100, VBe = 0.7V, zero
signal collector current Ip = 1µA and Vcc = 6V, what is the value of base resistor Rc ?
A. 105 ΚΩ
В. 530 KA
С. 315 КО
D. 60KN
C
D
В
A

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Q.1: A transistor has a collector current of 10 mA and a base current of 40 micro-A. What is the current gain of the transistor? A transistor has a current gain of 175. If the base current is 0.1 mA, what is the collector current? A transistor has a collector current of 100 mA and the current gain is 65, What is the emitter current? Q.2: Suppose you measure a VBE of 1v. What is the collector-emitter voltage? What is the collector-emitter voltage in the three preceding examples if the base supply voltage is 5v?
A zener diode is specified as having a brealdown voltage 9.1V, with a maximum power of 364mW. What is the maximum current the diode can handle?
Determine VL, IL, IZ and IR considering that the following values for R = 2.7 k ohms, RL = 450 ohms, with a power supply Vi = 50 V. Using a zener diode with a Vz = 10 V and an IZM = 32 mA. Check to see if the zener conducts with that arrangement. In the case of not driving, what arrangement do you have to make to achieve the diode conducts and stays within the safety margins indicated.
For the silicon transistor in the following figure the Q point is (2v ,1mA) Beta= 100 VBE= 1.3 v Find RB
Explain why Semiconductors are Negative Temperature Coefficient materials?
Photon energy of the light with a given wavelength could be calculated by the following equation (attached in this QnA post):*hint: wavelength of light is not in SI unit, unit conversion is needed. What is the band gap of the semiconductor, if it can only be excited by the light with wavelength equal to or smaller than 500 nm?*hint: the photon energy needs to be greater or equal to the band gap, in order to excite the semiconductor
Q1:- (a) Find the probability that an energy level is empty of an electron if the state is below the Fermi level by 6kT. (b) Is the product of the two types of carriers in doped semiconductor remains constant at a given temperature? Why?
A new material is found to be superconducting below 77 K. How much resistance will a 75 mm long sample of this material have if it is at a temperature of 69.3 K while connected to a 6.4 V AC-power supply? R = How much thermal energy will it generate?Thermal energy generated =
Why does the horizontal Line in the graph in Figure 9.12 suddenly stop at the Fermi energy? Figure 9.12 (a) Density of state for a free electron gas; (b) probability that a state is occupied at T = 0 K; (c) density if occupied states at T = 0 k.
The characteristic energy for KCl is 1.4105eV . (a) Determine for the KC1 molecule, (b) Find the separation distance between the K arid Cl atoms.
The collector current of a transistor is 3.4 A for a base current of 4.2 mA. What is the current gain?
A Pentium IV microchip has dimensions of 217 mm x 217 mm. Suppose each transistor on the chip is made up of a 10 x10 square of atoms (that is 100 atoms per transistor). How many transistors could fit on the Pentium IV chip if the spacing between the silicon atoms is 0.54 nm?