(c) A common emitter BJT circuit and its voltage transfer curve is shown in Fig. 1(c)respectively. Assume the transistor common-emitter current gain, ß = 50, VBE (on) =0.7 V, Rg = 100 kn and Rc = 1 k2.(i) Determine the input voltage at the point x.(ii) Calculate the base current, Ig and collector current, Ic at the point x.+VccVo(V)Rc5-VoRBV, oww-RAR-IBVBE0.5V,(V)15Fig. 1(c)-END OF QUESTION-

In this question we have to determine the voltages and currents at different points in the circuit.…

(c) A common emitter BJT circuit and its voltage transfer curve is shown in Fig. 1(c) respectively. Assume the transistor common-emitter current gain, ß = 50, VBE (on) = 0.7 V, Rg = 100 kN and Rc = 1 kQ. (i) Determine the input voltage at the point x. (ii) Calculate the base current, Ig and collector current, Ic at the point x.

(c) A common emitter BJT circuit and its voltage transfer curve is shown in Fig. 1(c) respectively. Assume the transistor common-emitter current gain, ß = 50, VBE (on) = 0.7 V, Rg = 100 kN and Rc = 1 kQ. (i) Determine the input voltage at the point x. (ii) Calculate the base current, Ig and collector current, Ic at the point x.

Modern Physics

3rd Edition

ISBN:9781111794378

Author:Raymond A. Serway, Clement J. Moses, Curt A. Moyer

Publisher:Raymond A. Serway, Clement J. Moses, Curt A. Moyer

Chapter12: The Solid State

Section: Chapter Questions

Problem 4P

See similar textbooks

Similar questions

In a transistor circuit given determine IB, IC, IE, VCE, αdc and VBC.Neglect VBE, take β=100 1.VBB=10V,Vcc=15v,Rc=10k,Rb=1M,
The input resistance of a silicon transistor is 100 Ω. Base current is changed by 40 µA which results in achange in collector current by 2 mA. This transistor is used as a common emitter amplifier with a loadresistance of 4 KΩ. The voltage gain of the amplifier is-
Consider a n-type Si crystal at room temperature (300K) doped with 6 x1016 cm-3 arsenic impurity atoms and with certain number of shallowholes. Find out the equilibrium electron concentration, hole concentrationand Fermi level EF with respect to Ei, and the conduction band edge EC.For Si at 300K, the value of ni is 1.45 x 1010 cm-3 and k = 1.38 x 10-23 J/K,1eV = 1.60 x 10-19J. The band gap energy, Eg, of Si is 1.2eV.Solution:n @ Nd = 6 x 1016 cm-3.In equilibrium condition, hole concentration = 3.5 x 103 cm-3.EF – EI = 0.396eVEC – EF = 0.164eV.
At T = 300 K, how far above the Fermi energy is a state forwhich the probability of occupation by a conduction electron is 0.10?
An unknown semiconductor has a band gap, Eg =1.1 eV and NC = NV where NC and NV are effective density of states in the conduction and valence band respectively. It is doped with 1015 cm-3 donors, where the donor level is 0.2 eV below conduction band minimum EC. Given that EF is 0.25 eV below EC, calculate intrinsic carrier density (ni), and the concentration of electrons and holes in the semiconductor at 300 K
Calculate the transistor’s Collector current if it is driven by a small Base current of 1.96mA with a Emitter current of 100mA
Integrated circuits are composed of very high purity silicon which is doped with small and highly controlled quantities of Phosphorus (group VA) and Boron (group IIIA). For Silicon that has been doped with B with the concentration of 6.5E21 atoms per cubic meter, compute the (a) weight percent and (b) the atom percent of B present.
For silicon at T = 500 K with donor density N_D = 5* 10^{13} cm^ and acceptor density N_A = 0 calculate the equilibrium hole concentration in cm^{-3}. In this problem, you can assume the bandgap energy and effective masses are independent of temperature and use the room temperature values for them. Values within 5% error will be considered correct.
What is the probability that, at a temperature of T = 300 K, an electron will jump across the energy gap Eg (= 5.5 eV) in a diamond that has a mass equal to the mass of Earth? Use the molar mass of carbon in Appendix F; assume that in diamond there is one valence electron per carbon atom.