Answered: A straight cylindrical interconnect…

A straight cylindrical interconnect line is 2 mm long and 200 um in diameter. What is the fastest allowable voltage transition (di/dt) if the line inductive voltage must be < 100 mV?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.27MCQ: In terms of line-to-line capacitance, the line-to-neutral capacitance of a single-phase transmission...

See similar textbooks

Related questions

Q: What is the dispersion taking place in long transmission lines? State the condition to obtain…

A: In long transmission lines frequency dispersion takes place. In which transmission lines have…

Q: Taking the dielectric strength of air to be 30 kV/cm, calculate the disruptive critical voltage for…

A: Critical disruptive voltage, vc=g0r logedrwhere g0=breakdown strength of air d=distance between…

Q: Why is the Geometric Mean Distance (GMD) of two different conductors the same in a transmission line…

A: GMR stands for geometric mean radius which is also known as self GMD it is mean of the distance of…

Q: Why the Capacitance effect is neglected in Short Transmission Line. Note please don’t handwringing

A: The explanation is as follows.

Q: Calculate the inductance of a 3- phase, 100 km long double circuit line shown in the figure below…

Q: PASSAGE A step index fibre has core and cladding indices 1.466 and 1.460 respectively. The fibre…

Q: The dimensions of a coaxial transmission line are a = 4 mm, b= 17.5 mm, and c = 20 mm. The…

A: It is given that: a=4 mm=4×10-3 mb=17.5 mm=17.5×10-3 mc=20 mm=20×10-3 mσc=2×107…

Q: An air co-axial transmission line has a solid inner conductor of radius ‘a’ and very thin outer…

A: In the given question co-axial cable is having an inner radius "a" and outer conductor radius "b"…

Q: Q5:A terminated transmission line with Z0 = 60 has a reflection coefficient at the load of r = 0.4…

A: Given Zo = 60 Reflection coefficient at load = 0.4 ,60°

Q: For a lossless trabsmisison line, the characteristic impedance is 80 ohm. If the capacitance per…

A: A transmission line can be characterized by 4 parameters: 1. Resistance per unit length (R) in ohm/m…

Q: The capacitance per unit length and the inductance per unit length for a lossless transmission line…

A: Characteristic impedance (Z0) of a transmission line is defined as the impedance of the transmission…

Q: is desired to construct uniform transmission lines using polyethylene (εr = 2.25) as the dielectric…

Q: Calculate the weight due to ice on a transmission line where the Total weight of conductor = 3.2…

Q: A Three-Phase, 180 KV, 75 Hz Transmission Line consists of 1.2 cm radius conductors spaced at 2.4…

Q: 2. A 3-phase, 132 KV , 50 Hz, 100 Km, single circuit bundle conductor transmission line as shown in…

Q: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4…

A: Given, A single phase transmission line consists of two conductors. Radius of each conductor (r)=…

Q: Three phase, 260 kV, 50 Hz transmission line consists of 3.2 cm diameter conductor spaced 0.002 km…

Q: A 3-phase, 440 kV transmission line consists of 2:5 cm radius conductor spaced 3 meters apart in…

Q: Derive the electric field equation at a distance 'r' due to an infinitely long line with line charge…

Q: A loss less transmission line of length 3.125m with characteristic impedance 502, is operating on…

A: Note :- As per guidelines we are supposed to answer only three subparts at a time. So, I request you…

Q: A transmission line has characteristic impedance of 75 Ω and it is connected to receiver with…

A: According to the question we have to find the value of i. Reflection Coefficient; ii. VSWR

Q: 69KV line has a horizontal configuration. The distance between adjacent conductors is 6ft. What is…

A: Given, A 69 kV transmission line has a horizontal configuration. The distance between adjacent…

Q: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4…

A: 1..>>Capacitance of line without effect of ground Radius of conductor is 0.4cm Distance…

Q: What is the justification in neglecting line capacitance in short length transmission lines?

Q: A lossless coaxial cable transmission line has L = 200 uH/ft and C = 100 nF/ft. The inner diameter…

Q: With a neat diagram show the reflections occurring in a transmission line. Hence explain thec…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: A shielded, twin-wire line has a dielectric of relative permittivity 2 and a characteristic…

Q: Estimate the corona loss for a 3-phase, 110 kV, 50 Hz, 150-km-long transmission line consisting of…

Q: A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.4 F/m, and 7.5 H inductance per…

Q: Please help with this conceptual electromagnetic question. A length of transmission line that is…

A: A length of transmission line that is terminated with a short. is it always inductive, or always…

Q: State the secondary transmission line constants and talk briefly about them.

A: According to the question we have to State the secondary transmission line constants and talk…

Q: A 376-2 lossless air transmission line is connected to a complex load composed of a 749-2 resistor…

Q: 4.6. One circuit of a single-phase transmission line is composed of three solid 0.5- cm radius…

A: Given arrangement of conductor assume it is conductor x and y Radius of conductor x is = rx Radius…

Q: A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.4F/m, and 7.5 H inductance per…

A: It is given that: Nominal capacitance= C=0.4 F/mInductance per meter=L=7.5 H/mDiameter of inner…

Q: Show that in a transmission line terminated with a pure positive reactive charge, the magnitude of…

Q: A parallel-wire transmission line has separation between conductors equal to four times the…

Q: Find the characteristic impedance and signal velocity for a transmission line consisting of two…

A: Given: A transmission line consisting of two parallel strips with a width ω and a separation d.…

Q: The ratio of the inner conductor perimeter to the outer conductor perimeter of a coaxial cable is…

Q: The conductor of a single-phase 60-Hz line is a solid round aluminum wire having a diameter of 0.412…

A: Inductance: It is a passive two-terminal electrical component and measured in Henry (H). When…

Q: A single-phase transmission line is composed of two solid round conductors having a radius of 0.45cm…

A: In this question we will find inductance per conductor and inductance of single phase transmission…

Q: In medium transmission line, capacitance is considered as O a. Lumped parameter O b. Distributed…

A: Given : Generally depending on the type of the medium we classify them parameters. Distributed…

Q: A 50Ω transmission line uses an insulating material with ǫr = 3. When terminated in an open circuit,…

Q: A Three-Phase, 220 KV,50 Hz Transmission Line consists of 2.0cm radius conductors spaced at 2.0…

Q: la. Two conductors of a single phase line, each of 2 cm diameter, are arranged in a vertical plane…

A: Given values, Vertical distance between two conductor is 120 cm Identical line spaced horizontal at…

Q: A lossless coaxial cable has the two conductor diameter ratio of 2.0. Find its inductance,…

A: we need to find out inductance, capacitance and Z0.

Q: What different types and modern usage areas of transmission lines and waveguides ? Explain and…

A: Transmission lines are used to transmit power from generating stations to distribution an dfrom…

Q: A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.9 Farad/meter, and 8 Henry/m…

Concept explainers

Fiber Optics

Fiber optics is a technology used to transmit the facts such as light or pulses with fiber or plastic over long distances. Visual fibers are about the width of a human hair strand and, when tied directly to a fiber-optic cable, can transmit multiple long-distance records and faster in different ways.

Question

8.
A straight cylindrical interconnect line is 2 mm long and 200 um in diameter.
What is the fastest allowable voltage transition (di/dt) if the line inductive voltage must be
< 100 mV?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For a single-phase, two-wire line consisting of two solid cylindrical conductors of same radius, r, the total circuit inductance, also called loop inductance, is given by (in H/m) 2107ln(Dr) 4107ln(Dr) where r=e14r=0.778r
In terms of line-to-line capacitance, the line-to-neutral capacitance of a single-phase transmission line is Same Twice One-half
A single-phase overhead transmission line consists of two solid aluminum conductors having a radius of 3 cm with a spacing 3.5 m between centers. (a) Determine the total line inductance in mH/m. (b) Given the operating frequency to be 60 Hz, find the total inductive reactance of the line in /km and in/mi. (c) If the spacing is doubled to 7 m, how does the reactance change?
An air co-axial transmission line has a solid inner conductor of radius ‘a’ and very thin outer conductor of inner radius ‘b’. Determine inductance per unit length of the line.
A 55 -km long, 50 Hz, single-phase, 2-wire, transmission line is composed of 26 -mm diameter solid conductors. If the separation between conductors is 2.8 m., What is the inductance per conductor per unit length in (mH/km)?
A 50 -km long, 30 Hz, single-phase, 2-wire, transmission line is composed of 49 -mm diameter solid conductors. If the inductance per conductor of the line is 1.011 in mH/km, what is the separation distance between conductors in meter?
An 8000 V, 60 Hz, single-phase, transmission line consists of two hard-drawn aluminumconductors with a radius of 2 cm spaced 1.2 m apart. If the transmission line is 30 km longand the temperature of the conductors is 200C,a. What is the series resistance per kilometer of this line?b. What is the series inductance per kilometer of this line?c. What is the shunt capacitance per kilometer of this line?
A coaxial, air-gapped transmission line consists ofa solid inner conductor of radius a and a thin outerconductor of inner radius b. Determine theinductance of the line per unit length?
Find the characteristic impedance and signal velocity for a transmission line consisting of two parallel strips with a width ω and a separation d. You can ignore fringing fields by assuming that they are sections of concuctors infinitely wide.
Determine the loop inductance, and the capacitance of a 1 km length of single-phase twin line having conductors of diameter 10 mm and spaced 800 mm apart in air.
A microstrip line is composed of zero thickness copper conductors on a substrate having εr = 8.4, tan = 0.0005 and thickness 1.5 mm. if the line width is 0.5 mm,and operated at 6Ghz, determine the characteristic impedance.
It is desired to construct uniform transmission lines using polyethylene (εr = 2.25) as the dielectric medium. Assuming negligible losses, find the inner radius of the outer conductor (in mm) for a 76 Ω coaxial line, where the radius of the center conductor is 0.6 (mm).