Q2.A three phase full wave uncontrolled bridge rectifier has an AC input voltage of 90 V RMS at 60 Hz anda resistive load of 4400.a. What is the average output voltage?b.What is the average output current?c. What should be the voltage blocking capability of the diodes?

Given, A three phase full wave uncontrolled bridge rectifier, Vin= 90V rms (line…

A three phase full wave uncontrolled bridge rectifier has an AC input voltage of 90 V RMS at 60 Hz and a resistive load of 44002. a. What is the average output voltage? b. What is the average output current? What should be the voltage blocking capability of the diodes? C.

A three phase full wave uncontrolled bridge rectifier has an AC input voltage of 90 V RMS at 60 Hz and a resistive load of 44002. a. What is the average output voltage? b. What is the average output current? What should be the voltage blocking capability of the diodes? C.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Related questions

Q: Calculate the dissipation in power across 2002 resistor for the FM signal v(t)= 20 cos(6600t+…

A: The expression of the FM signal is given as vt=20cos6600t+10sin2100t The power dissipated in 20-ohm…

Q: State and explain Carson's Bandwidth Frmula. Need urgently help.

A: In the following section, Carson's bandwidth formula has been explained.

Q: The magnetic field due to an infinitely long wire at a certain point is 'B'. If the distance of the…

A: Given: Magnetic field due to infinity long wire ,B1=B Distance between point and wire, d1=d If the…

Q: Prove the following Boolean identities. (i) XY+YZ+ YZ=XY+Z (ii) A.B+A.B+A.B=A+B

A: The given Boolean identity can be verified by using the postulates and theorems of Boolean algebra.

Q: Explain Hall effect transducer also state Different values of hall coefficient with different…

A: The Hall effect transducers are based on Hall effect which was discovered in 1879. The Hall effect…

Q: A 6-bit R-2R ladder D/A converter has a reference voltage of 6.5V. It meets standard linearity. Find…

Q: Infinite uniform line charges of 5 nC/m lie along the (positive and negative) x and y axes in free…

A: You have asked multiple questions, but in part, b) the data is insufficient so we will solve the…

Q: (e) This microprocessor uses the specifications shown in Figure Q1(e) for 16-bit floating point…

A: Being a base-16 sustem,the hexadecimal numbering system therefore uses 16(sixteen) diffrent digits…

Q: image483

A: a) The capacitance of the capacitor with the dielectric is calculated as shown below:…

Q: Calculate the mesh currents in the circuit. 45 V Μ ΖΩ Μ ΤΩ 12 Ω ΦΩ M .24 ½2 3Ω 30 V

Q: Consider this figure and answer the following questions. V₁ = V2 = is+ V3 = 3A (†) Us VI V2 www + V3…

A: Given: Circuit is

Q: What is the required bandwidth according to the Carson's rule, when a 100 MHz carrier is modulated…

A: Given information: The carrier frequency is fc=100 MHz The modulating frequency is fm=1 kHz The…

Q: Rotor resistance of a three-phase induction motor is 0.080 per phase. Maximum torque is available at…

A: We have an equivalent circuit of induction motor with, Maximum torque occurs at 12% slip = 0.12 Slip…

Q: A Nickel resistance thermometer, has a sensing wire diameter of 0.0025 cm. The resistance at 0°C is…

A: We have a nickel resistance thermometer with, Sensing wire diameter (d) = 0.0025 cm Resistance at 0°…

Q: Which of the following statements best describes electric polarization forces on neutral objects? O…

A: a). The expression occurs when an electric field distorts the negative cloud of electrons around…

Q: 1) A coil composed of 100 turns has an inductance of 5 mH. If the number of turns is doubled without…

Q: Question 1 Quuo Determine the amount of current (mA) flowing in the circuit if the charge seen at…

A: Given: Charge seen at cross sectional area, Q=0.0052C Time, t=30ms

Q: Current source shown below is converted in to voltage source. Choose the correct voltage source…

Q: the attached

A: Given: a) Write down the equation of 1st order Transfer Function in standerd form and the unit step…

Q: (a) Calculate the synchronous speed of an eight-pole induction motor when supplied with power from a…

A: Given: An induction motor has following specifications, Number of poles, P=8 Frequency of source,…

Q: 100V 비 2.=52 Ry=152 ~ 3 R2=52 R3=1022 m Ro=202 Find the TOTAL POWER of P1, P2,P3,P4, Psand Po ks:…

Q: 4. A single-loop negative feedback system has the loop transfer equation: L(s) = Ge(s)G(s) = K(s +…

A: GIVEN: L(s)=Gc(s)G(s) =K(s+2)2(s(s2+1)(s+8)) FIND: (1) sketch…

Q: Q5 T(s) = 62.5(x + 2.5) (s² +65 +25)(s+ 6.25) a) What are poles and zeros of the transfer function…

A: For the given transfer function answer the following Questions : Ts=62.5s+2.5s2+6s+25s+6.25 or we…

Q: So-called analog computers use circuits to solve mathematical problems, particularly when they…

Q: A RL series circuit is shown below. What will be the circuit time constant? _X_ t = 0 48V 4ΚΩ VL 16H

A: Given: Series RL circuit,

Q: Two circuits A and B are connected in parallel with a supply of 200 V, 50 Hz. In circuit A, an…

Q: 2.a. Find the total resistance between 'a' and 'b' for the circuit given below. 20 2 ww 50 162 ww 20…

A: It is given that:

Q: Use superposition theorem to find current in 100 resistor in the figure below. 10/0°V 10 (2 ww E₁ j…

Q: 2. The below figure shows the results of magnetic particles inspection experiment. What can you…

A: Introduction: Magnetic particle inspection is non-destructive testing to determine any discontinuity…

Q: 29. Determine Zx in the circuit shown below. * + I= 31.5 (24° A V-50/60v 1+j10 2+j20 3+j30 O 4+ j40…

Q: In the circuit shown below, the maximum power transferred to the resistor R is 30 502 :5V 20 6 V 50…

A: Given circuit,

Q: a) Find the spectrum of x(t) = e²t u(1-t) b) Find the inverse Fourier transform of X (w) = j

Q: FACULTY OF SCIENCES DEPARTMENT OF PHYSICS QUESTION NO. 2: MANDATORY/DOPTIONAL / BONUS In the figure,…

A: Given- C =0.4 uF ε= 20 V R1 = 10 k ohm R2= 15 k ohm

Q: (b) The two n-MOSFET's have VT=+1 V, μCox = 20 μA/V2, L= W = 5 μm, while VDD = +5 V and VGG = +4 V.…

A: Given: VT=+1 VμCOX=20 μA/V2L=W= 5μmVDD=5 VVGG=4 VVIN=0 V Find: Operating region of the MOSFET, when…

Q: A resistance wire strain gauge ss of 100 MN/m². The modulus of elasticity of steel is 200 GN/m².…

A: Given, Given, Gauge factor = 2 Stress = 400 MN/m2 Elasticity of Steel (Y) = 200 GN/m2

Q: Find the decimal equivalent of the binary number (1011.011)2

A: Binary numbers are those numbers which have 2 in their base and decimal numbers are those numbers…

Q: Draw the G(s) = approximate magnitude and phase Bode plots for: 100(8+1) s(s/100+1) 100(8+1)…

Q: What is the maximum modulating frequency allowed in commercial FM broadcastings? a. 40 KHz b. 75 KHz…

A: The correct option along with the explanation has been provided in the following section.

Q: 2- Using the nodal analysis to find V₂ for the network. 3LER, ISA RIZER. Iz 2A R3 452 R₂&n 4A + V₂

Q: If a 4-pole induction motor has a synchronous speed of 1500 r.p.m., then, supply frequency is

A: Given an induction motor with, Total number of poles, P = 4 Synchronous speed, Ns=1500 rpm Supply…

Q: If the peak voltage of a 60-Hz AC generator is 250 V, what is the instantaneous voltage after the…

A: According to the question, it is given that Peak Voltage Vpeak = 250 V Frequency of AC generator =…

Q: The conductors of a three phase transmission line are symmetrically arranged in a triangle. If the…

Q: A current of 3 A flows for 5 minutes. What charge is transferred?

Q: The voltage across 20 Resistor where v= 10volts is 20 W O a. 4V O b. 10V 0 с. 3V O d. 2V 10 www M 20…

A: Given circuit: V=10 volts

Q: 9.9 Answer: Use a A-to-Y transformation to find the current I in the circuit shown. I = 4/28.07° A.…

Q: To achieve 75 percent modulation of a carrier of V, 190 V, what amplitude of the modulating signal V…

A: Modulation index is given, m=75 %=0.75 Amplitude of carrier signal Vc=190 V

Q: Where did the -0,4V come from??

A: In the given circuit, one of the requirements is to achieve maximum gain and it can be achieved by…

Q: Calculate the maximum frequency deviation for the FM signal v(t) = 10 cos (6000t+ 5sin2200t) a. 2200…

Q: Design experiments to find the relationships between charge, voltage, and stored energy for a…

A: Let: The charge stored by the capacitor = Q The voltage across the capacitor = V The capacitance…

Q: A 25 MVA, 13.2 kV alternator with solidly grounded neutral has a subtransient reactance of 0.40 p.u.…

Question

Q2.
A three phase full wave uncontrolled bridge rectifier has an AC input voltage of 90 V RMS at 60 Hz and
a resistive load of 4400.
a. What is the average output voltage?
b.
What is the average output current?
c. What should be the voltage blocking capability of the diodes?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How is a solid-state diode tested? Explain.
3. For the half-wave rectifier given in the figure below, find the average values ofthe output voltage and current, and the ripple factor of the output voltage.
Figure shows an AC source G having an effective voltage of 240 V, 60 Hz is connected to a single-phase full-wave rectifier. The resistance for R is 53 Ω and ripple-to-ripple current is 15%.Determine the DC voltage and DC current across the resistor. Hence, determine the power absorbed by the load. Assuming all diodes are ideal.
A three-phase, half-wave uncontrolled rectifier is fed from an ideal three-phase voltage source of 380V, 50 Hz. The load is resistive with R=15 2. Calculate: (a) The average output voltage and average load current of the rectifier. (b) The d.c. and a.c. power dissipations in the load. (c) The diode ratings. (d) What is the lowest ripple frequency of the output voltage waveform?
The half-wave rectiﬁer as shown is operating at a frequency of 60Hz, and the rms value of the transformer output voltage vI is 12.6V±10%. What are the nominal and worst case values of the dc output voltage VO if the diode voltage drop is 1V?
What is the purpose of a rectifier circuit? Describe the operation of a half-wave rectifier and a full-wave rectifier using diodes. Draw network and input-output voltages of both cases.
Explain the working operation of the V-I characteristics of the Silicon-Controlled Rectifier.
Question 1: a) Draw the circuit diagram and explain the working of Half Wave Rectifier (HWR). b) With the help of a neat circuit diagram, explain the working principle of a Centre tapped Full Wave Rectifier. Also, Draw the expected output voltage wave forms with/without using a capacitor parallel with the load. Show the factors affecting voltage ripples and how to eliminate these ripples as much as possible.
Q#2: what do you know about Full Wave Bridge Rectifier operation explain in detail?
Half wave rectifier and full wave rectifier circuit, what is the relationship between the input voltage waveformand resistor voltage waveform if the diode is shorted? Does the input voltage waveform and resistor voltage waveform has the same peak value when the diode is present? Explain why.
What is the PIV rating of each silicon diode in volts for a bridge type rectifier where the voltage in the secondary transformer is 100V peak? Assume 2.2K ohms load.
1- Connect the half-wave rectifier with resistive load (RL=1KΩ ) and setthe parameters value of peak amplitude equal (220) volt, frequency equal(50) HZ.2- Draw the output waveform for the DC output and the r.m.s value of theoutput voltages.3- What is the value of the peak inverse voltage on the diode in half -waverectifier?