Air at 300°C flows over a flat plate of dimensions 0.50m by 0.25m. If the convection heat transfer coefficient is 250 W/m2K, determine the heat transfer rate from air to one side of the plate when the plate is maintained at 40°C. (ans.8.125 KW)
Q: The top surface of the passenger car of a train moving at a velocity of 70 km/h is 2.8 m wide and 8…
A: Write the given data Note the relative velocity of the air will be same as the velocity of the…
Q: An average man has abody surface area of 1.8m2 and a skin temperature of 33degrees celcius .The…
A: The data given is, Surface area of the body, As = 1.8 m2 Skin temperature of the body, Tskin = 33℃…
Q: A long 9 cm-diameter steam pipe whose external surface temperature is 70 0C passes through some open…
A:
Q: 1- Air at 288.8 k and 101.32 kPa with a free stream velocity of 3.05 m/s is flowing parallel to a…
A: Given:
Q: Air at 20oC and 1 atm flows over a flat plate at 35 m/s. The plate is 75 cm long and 100 cm depth…
A: Velocity boundary layer thickness The thickness of the velocity boundary layer is normally defined…
Q: For laminar forced convection over a flat plate, if the free stream velocity increases by a factor…
A:
Q: What does the friction coefficient represent in flow over a flat plate? How is it related to the…
A: Drag force is a force acting on a body (moving or stationary)which is present in a moving or…
Q: Calculate the ratio of thermal-boundary-layer thickness to hydrodynamic-boundary- layer thickness…
A:
Q: Consider a 50-cm-diameter and 95-cm-long hot water tank. The tank is placed on the roof of a house.…
A: Given data Diameter of the pipe = 50 cm =0.5m Length of the pipe = 95cm = 0.95m Final temperature of…
Q: Q1. A 6-mm-diameter electrical transmission line carries an electric current of 50 A and has a…
A: Given data: The diameter of the electrical transmission is d=6 mm=0.006 m The electric current in…
Q: A metallic airfoil of elliptical cross section has a mass of 50 kg, surface area of 12 m2, and a…
A:
Q: calculate the convection heat transfer rate over a surface of area 1 m^2 having heat convection…
A: GIven Data Surface area , As=1m2. Heat convection coefficient, h=40 W/m2K Temperature difference,…
Q: The upper surface of a metal plate is being cooled with parallel air flow while its lower surface is…
A: The properties of air at 15 degrees Celsius are: The Reynolds number of the flow is
Q: Four power transistors, each dissipating 12 W, are mounted on a thin vertical aluminum plate (k =…
A: The properties of air at 40 degrees Celsius and 1 atm pressure are: The Reynolds number of the flow…
Q: 7-92 Air at 20°C (1 atm) is flowing over a 5-cm-diameter sphere with a velocity of 3.5 m/s. If the…
A: Given DataT∞=20°CTs=80°CV=3.5m/sD=5cm
Q: Consider the following fluids at a film temperature of 300 K in parallel flow over a flat plate with…
A: Given data Film Temperature =Tf = 300 KVelocity = v = 1 m/sDistance from leading edge = 20 mm = 0.02…
Q: Q1/ A heating system is to be designed to keep the wings of an aircraft cruising at a velocity of…
A: Given that , v=900km/hh=12200mT1=55.4°CP1=18.8kPa
Q: Air at 300 degrees Celsius flows over a plate of dimension 0.5 m by 0.25 m. If the convection heat…
A:
Q: Q9) Consider a 50 cm diameter and 95 cm long hot water tank. The tank is placed on the roof of a…
A:
Q: Castor oil at 36 °C flows over a 6 m long and 1 m wide heated plate at 0.06 m/s. For a surface…
A: Given: The temperature of castor oil, To = 36 C The length of plate, L = 6 m The width of plate, b =…
Q: Engine oil at 60°C flows over a 5 m long flat plate whose temperature is 20°C with a velocity of 2…
A: Given :- Too=60oc Ts=20oC Length= l=5m Width =W= unit length =1m Velocity =V=2m/s Density = e= 876…
Q: Airstream at 1 atm flows, with a velocity of 15 m/s, in parallel over a 3-m-long flat plate where…
A: Write the properties of air at 20°C. Write the expression of the characteristic length of the…
Q: Four power transistors, each dissipating 12 W, are mounted on a thin vertical aluminum plate 22 cm *…
A: Given data as per question No. of transistors = 4 Heat dissipated by each transistor = 12 w…
Q: Explain, motorcycle engine is either considered as free or forced convection. Justify your answer
A: Motor cycle engine is the 4-stroke petrol engine. Large amount of heat is created from the 2-stroke…
Q: Air at a temperature of 25oC flows parallel over a flat plate with free-stream velocity of 2 m/s.…
A:
Q: Flue gases from an incinerator are released to atmosphere using a stack that is 0.6 m in diameter…
A: Given : The diameter of stack = 0.6 m The height of the stack = 10 m Surface temperature of the…
Q: Air is flowing in parallel over the upper surface of a flat plate with a length of 4m. The first…
A: Heat supplied is the heat supplied for power generation or for the useful work of a machine. This…
Q: Air is flowing in parallel over the upper surface of a flat plate with a length of 4 m. The first…
A: Write the given data with suitable variables: L=4 mT=50 °Cv=0.5 m/sTa=10 °C
Q: Air at 25 ° C blows over the hot steel plate whose surface temperature is maintained at 150 ° C. The…
A: Given data: The temperature of the air is T∞=25°C The surface temperature of the plate is Ts=150°C…
Q: 1) Engine oil at 80°C flows over a 6-m-long flat plate whose temperature is 30°C with a velocity of…
A:
Q: Consider steady, laminar, two-dimensional flow over a hot plate. Does the convective heat transfer…
A: Given: Consider steady, laminar, two-dimensional flow over a hot plate The wall shear stress is…
Q: A carbon steel plate (thermal conductivity = 45 W/m°C) 600 mm x 900 mm x 25mm is maintained at…
A:
Q: Explain, motorcycle engine is either considered as free or forced convection. Justify your answer.
A: Convection is described as a phenomenon in which the alteration of heat takes place by the motion of…
Q: Example 1: Engine oil at 60°C flows over the upper surface of a 5-m-long flat plate whose…
A:
Q: Consider a 50-cm-diameter and 95-cm-long hot water tank. The tank is placed on the roof of a house.…
A:
Q: What is lift? What causes it? Does wall shear contribute to the lift?
A: given: What is lift? What causes it? Does wall shear contribute to the lift?
Q: 2.0 Engine oil at 100°C and a velocity of 0.25 m/s flows over both surfaces of a 0.8-m-long flat…
A:
Q: Required information Hot engine oil at 150°C is flowing in parallel over a flat plate at a velocity…
A:
Q: Caster oil at 36°C flows over a 6 m long and 1 m wide heated plate at 0.06 m/s. For a surface…
A: The answer is given below
Q: 0.5 W of heat passes from the bottom of a silicon chip (k = 130 W/m-K) and then dissipated to the…
A:
Q: A 5.0-cm-diameter cylinder is heated to a temperature of 200 oC, and air at 30 oC forced across it…
A: Given data: d=5 cmh=180 W/m2KT1=200°C=473 KT2=30°C=283 Kε=0.7T∞=10°C=283 K Need to determine the…
Air at 300°C flows over a flat plate of dimensions 0.50m by 0.25m. If the
convection heat transfer coefficient is 250 W/m2K, determine the heat transfer
rate from air to one side of the plate when the plate is maintained at 40°C.
(ans.8.125 KW)
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 2 images
- Determine the rate of heat loss from the wall of a building resulting from a 16 km/h wind blowing parallel to its surface. The wall is 24 m long and 6 m high, its surface temperature is 27C, and the temperature of the ambient air is 4C.Air is flowing in parallel over the upper surface of a flat plate with a length of 4 m. The first half of the plate length, from the leading edge, has a constant surface temperature of 50°C. The second half of the plate length is subjected to a uniform heat flux of 86 W/m2. The air has a free stream velocity and temperature of 0.5 m/s and 10°C respectively. The properties of air at Tf = 30°C are k = 0.02588 W/m∙K, ν = 1.608 × 10−5 m2/s, and Pr = 0.7282. Determine the local convection heat transfer coefficients at 1 m and 3 m from the leading edge.Air is flowing in parallel over the upper surface of a flat plate with a length of 4 m. The first half of the plate length, from the leading edge, has a constant surface temperature of 50°C. The second half of the plate length is subjected to a uniform heat flux of 86 W/m2. The air has a free stream velocity and temperature of 0.5 m/s and 10°C respectively. The properties of air at Tf = 30°C are k = 0.02588 W/m∙K, ν = 1.608 × 10−5 m2/s, and Pr = 0.7282.Determine the local convection heat transfer coefficients at 1 m from the leading edge.
- Air is flowing in parallel over the upper surface of aflat plate with a length of 4 m. The first half of the plate length,from the leading edge, has a constant surface temperatureof 50°C. The second half of the plate length is subjected toa uniform heat flux of 86 W/m2. The air has a free streamvelocity and temperature of 2 m/s and 10°C, respectively.Determine the local convection heat transfer coefficients at1 m and 3 m from the leading edge. Evaluate the air propertiesat a film temperature of 30°C. Is the film temperatureTf = 30°C applicable at x = 3 m?During a cold winter day, wind at 55 km/h is blowing parallel to a 4m high and 10m long wall of a house. If the air outside is at 5 degrees Celsius and the surface temperature of the wall is 12 degrees Celsius , determine the rate of heat loss from the wall by convection. What would your answer be if the wind velocity has doubled? From Table A-1:thermal conductivity, k = 0.0246 W/m degrees Celsiusviscosity, v = 1.4 x 10^-5 m^2/sPrandtl no. Pr = 0.717Air at 1 atm 5°C with a free-stream velocity of 2 m/s flows in parallel with a stationary thin 1x 1m^2 flat plateover the top and bottom surfaces. The flat plate has a uniform surface temperature of 35°C. Determine theaverage convection heat transfer coefficient. (Answer: 5.46 W/m2·K)
- . Castor oil at 36 °C flows over a 6 m long and 1 m wide heated plate at 0.06 m/s. For a surfacetemperature of 96 °C, determine (i) the thermal boundary layer thickness at the end of the plate,(ii) the local heat transfer coefficient at the end of the plate, and (iii) the rate of heat transfer fromthe entire plateQuestion No. 3: During a cold winter day, wind at 55 km/h is blowing parallel to a 4-m-high and 10-m-long wall of a house. If the air outside is at 5°C and the surface temperature of the wall is12°C, determine the rate of heat loss from that wall by convection. What would your answer be if the wind velocity was doubledAir at 60°F flows over a 10-ft-long flat plate at 7 ft/s. Determine the local friction and heat transfer coefficients at intervals of 1 ft, and plot the results against the distance from the leading edge.
- Air at 300 degrees Celsius flows over a plate of dimension 0.5 m by 0.25 m. If the convection heat transfer coefficient is 250 Watts per Sq.m Kelvin, determine the heat transfer rate from the air to one side of the plate if the plate is to be maintained at 40 degrees Celsius.A long 8-cm-diameter steam pipe whose external surface temperature is 90°C passes through some open area that is not protected against the winds. Determine the rate of heat loss from the pipe per unit of its length when the air is at 1 atm pressure and 7°C and the wind is blowing across the pipe at a velocity of 50 km/h.An average man has abody surface area of 1.8m2 and a skin temperature of 33degrees celcius .The convection heat transfer coefficient for a clothed person walking in still air is expressed as {h,8.6V^0.53}FOR 0.5<v<2m/s,where V is the walking velocityin m/s.Assuming the average surface temperature of the clothed person to be 30degrees celcius, determine the rate of heat loss from an average man walking in still air at 10degrees celcius by convectionat a walking velocity of (a)0.5m/s (b)1.0m/s (c)1.5m/s (d)2.0m/s