An analyst determines the Cl^- content of rain water with ion chromatography. The data for the calibration line in the range 5 to 50 milli equivalents per liter (mEq/L) is shown in the table below. Additionally, a blank sample was analysed 5 times and the following results obtained: 1.1, 0.5, 0.1, 0.9 and 1.2 ppm Ct Calculate the detection limit (DL) for the method with a 98.3% confidence level. Use ALL data and show equations

An analyst determines the Cl^- content of rain water with ion chromatography. The data for the calibration line in the range 5 to 50 milli equivalents per liter (mEq/L) is shown in the table below. Additionally, a blank sample was analysed 5 times and the following results obtained: 1.1, 0.5, 0.1, 0.9 and 1.2 ppm Ct Calculate the detection limit (DL) for the method with a 98.3% confidence level. Use ALL data and show equations

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter28: High-performance Liquid Chromatography

Section: Chapter Questions

Problem 28.14QAP

See similar textbooks

Similar questions

A protein consists of two types of peptide chains (A and B) with an unknown stoichiometry (AxBy). When you ran this protein directly on reversed phase-HPLC with UV monitor set at 280 nm, two peaks were resolved. Mass spec determined that the peaks represented Chain A and Chain B, respectively. The peak area is 500,000 for Peak A (Chain A) and 100,000 for Peak B (Chain B). The molecular masses of Chain A and Chain B are 25,000 and 5000, respectively. The extinction coefficients for Chain A and Chain B are 1 mL/mg.cm and 0.5 mL/mg.cm, respectively. Please calculate x/y.
Calculate the amount of phycocyanin in Sample 1 in mg where A620=0.211 and A650=0.086, taking into account the dilution factor as per question 6 (100ul), and the total volume of extract as per question 4 (140ml) . Note your answer to 2 decimal places
The Ksp of PbF2 is 3.3 x 10^-8
You obtained the following raw data when setting up a Biuret standard curve: BSA (mg/ml) Absorbancy 540nm 0 0.158 1 0.210 2 0.260 3 0.305 4 0.360 5 0.410 6 0.455 7 0.510 8 0.530 9 0.550 10 0.554 After blanking against a biuret-dH2O sample, the protein concentration of an unknown sample was determined using the same method and an absorbancy of 0.251 was obtained. Set up a standard curve, excluding outliers (experimental and statistical) and determine the protein concentration in the unknown sample in mg / ml (up to 3 significant figures).
For an enzyme reaction followed spectrophotometrically at 340 nm the Vmax was calculated at 0.14 ∆A340/min (ε340 = 5.22 mM-1.cm-1). The 1 mL reaction in a 1 cm cuvette contained 30 ng of an enzyme (Mr of 100 000 g/mole). Calculate the Kcat for this enzyme.
Calculate the amount of phycocyanin in Sample 1 in mg where A620 = 0.193 and A650 = 0.095, taking into account the dilution factor of 100 ul, and the total volume of extract 45ml. Note your answer to 2 decimal places.
Ksp for BaCrO4 is 1.17x10^-10
You obtained the following raw data when setting up a Bradford standard curve: BSA (mg/ml) Absorbancy 595nm 0 0.225 1 0.310 2 0.420 3 0.510 4 0.610 5 0.720 6 0.810 7 0.915 8 0.950 9 0.980 10 0.990 After blanking against a bradford-dH2O sample, the protein concentration of an unknown sample was determined using the same method and an absorbancy of 0.523 was obtained. Set up a standard curve, excluding outliers (experimental and statistical) and determine the protein concentration in the unknown sample in mg / ml (up to 3 significant figures).
In order to improve the peptide separation by using a HPLC system, trifluoroacetic acid acts as mobile-phase modifier was added during the preparation of mobile phase. The preparation was performed by a postgraduate student as following:“2.851 g trifluoroacetic acid (MW: 114.02 g/mol) was made up to 500 cm3 in a graduated flask. To this solution, 50 cm3 of ethanol was added, and after mixing the mobile phase was placed in the solvent reservoir and pumping was commenced at 1.5 cm3 min-1.”Based on the given preparation procedure, identify THREE mistakes that were made.
give answer asap
Give 5 reallife application of asymmetric synthesis? do asap fast or else i will downvote
https://m.youtube.com/watch?v=vM1SP346XBc&list=PLeJOSNLNZfHubfLdq0kOayASeUllMOGn4&index=4 I watched this the lecture video over and over and I am allowed to work with someone but I am having trouble with part B and I provided the YouTube link of the data or video attached to this lab