An empty vessel which is open at the top has a horizontal capillary tube of length 20 cm and internal radius 1.0 mm pro- truding from one of its side walls imme- diately above the base. Water flows into the vessel at a constant rate of 1.5 cm's. At what depth does the water level stop rising? (You may assume that the flow is steady. Coefficient of viscosity of water = 1.0 x

An empty vessel which is open at the top has a horizontal capillary tube of length 20 cm and internal radius 1.0 mm pro- truding from one of its side walls imme- diately above the base. Water flows into the vessel at a constant rate of 1.5 cm's. At what depth does the water level stop rising? (You may assume that the flow is steady. Coefficient of viscosity of water = 1.0 x

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Fluid Properties-The difference in pressure between theinside and outside of a soap bubble wasobserved to be 1.6 N/m2. If the surfacetension of the liquid is 40 dyne/cm, what will be the diameter of the bubble in meters?
For a gas, which of the following does not vary with temperature? - the gas soecific weight - the gas dynamic viscosity - the gas specific volume - the gas constant R - the gas density
Here, a liquid's density is to be determined by a 1-cm diameter cylindrical hydrometer whose division marks are non visable. The hydrometer is first dropped in water, and the water level is marked. The hydrometer is then dropped into the 'liquid x', and it is observed that the mark for water has risen 0.85 cm above the liquid–air interface. In this case, the height of the originalwater mark is 12.7 cm. As such, how would I determine the density of the liquid?
In a fluid 1 is oil (sg=0.87) and fluid 2is glycerine at 20 degrees Celsius (w=12360N/m cubed) if Patm=98kpa determine the absolute pressure at p1 Here is the diagram in the picture below
Ethylene glycol (antifreeze) has a density of 1.11 g/cm^3. What is the mass in g of 417 mL of this liquid?
Balloons are often filled with helium gas because it weighs only about one-seventh of what air weighs under identical conditions. The buoyancy force, which can be expressed as Fb = ? airgVballoon, will push the balloon upward. If the balloon has a diameter of 12 m and carries two people, 70 kg each Using appropriate software, investigate the effect of the number of people carried in the balloon on acceleration. Plot the acceleration against the number of people, and discuss the results Assume the density of air is ? =1.16kg/m3, and neglect the weight of the ropes and the cage
Capillary rise in the glass tube used for measuring water level isnot to exceed 0.5 mm. Determine its minimum size, given thatsurface tension for water in contact with air = 0.07112 N/m.
A solid ball is floating at a boundary between water and mercury, with 56 % of the ball volume in water. Ball diameter is 1.2 m, water density is 1000 kg/m3 and mercury density is 13560 kg/m3. What is the density of the ball? Round off the answer to an integer in kg/m3, but enter the answer without the unit.
A milkshake has fairly similar density to that of water (m s = 1200 kg/m3) but is far more viscous ( = 1kg/ms) (a) Say you try to drink a milkshake through a straw that is 30 cm long and 5 mm in diameter. Your lungs are capable of creating a vacuum pressure of 3000 Pa. (Vacuum pressure just means a pressure below that of the atmosphere, so plung = patm 3000 Pa.) You Önd that if you place the straw just at the surface of the liquid, you are unable to suck the milkshake through the straw, but if you push the straw deeper into the shake, you can. To what depth, d, would you need to push the straw in order to just start to sip the milkshake?(b) Suppose you push the straw to a depth of 10 cm and suck with a suction pressure of 3000 N/m2. What volume áow rate of milkshake can you produce through the straw
Air is kept at a pressure of 300 KPa absolute and a temperature of 30 degrees Celsius in a 400 liter container.1. What is the density of air if R = 280 N-m/kg-0K?
Determine the capillary rise of kerosene at 68°F IN INCHES in a glass tube having a diameter of 0.25 inches From given: Density of kerosene at 68°F =1.57 slugs/ft^3 Surface tension of kerosene at 68°F =0.0017 lb/ft
The surface tesnion of waterr in contact with air at 20deg C is given at 0.0716 N/m. The pressure inside a droplet of water is to be 0.0147 N/cm^2 greater than the outside pressure, calculate the diameter in mm of the droplet of water.