Andrew dissolved 10.00 grams of an iron ore sample in 5.00 L of acid to produce a stock solution. Josh ran a trial of the analytical procedure on the stock solution, but found the solution was too concentrated to be used. So Josh prepared a 1:250 dilution of the sample solution, and, after running the analytical procedure successfully, found the solution contained 1.62 x 10-5 mol/L Fe2+ (aq). What is the mass of iron in the meteorite sample?

Andrew dissolved 10.00 grams of an iron ore sample in 5.00 L of acid to produce a stock solution. Josh ran a trial of the analytical procedure on the stock solution, but found the solution was too concentrated to be used. So Josh prepared a 1:250 dilution of the sample solution, and, after running the analytical procedure successfully, found the solution contained 1.62 x 10-5 mol/L Fe2+ (aq). What is the mass of iron in the meteorite sample?

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter17: Electrochemistry

Section: Chapter Questions

Problem 80AP

See similar textbooks

Similar questions

Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. Ni(NO3)2From the stock solution (1.0 M), determine the volume needed to prepare 0.00, 0.04, 0.08, 0.12 and 0.16 M Ni(NO3)2 solution in 50 mL volumetric flask. Obtain the calculated amounts, place in corresponding volumetric flasks and dilute to mark.
When standardizing two liters of a potassium permanganate solution, approximately 0.0100 M, with a primary standard solution of sodium oxalate, it was planned to use between 30.00 and 45.00 ml of the titrated reagent. In which mass range (in grams) the primary standard should be weighed?
Hydrogen peroxide solutions can easily be decomposed by dust, trace amounts of metals or light. It istherefore necessary to periodically determine the purity of the peroxide solutions.This can be done via a redox titration as follows: The density of a particular surgical grade hydrogen peroxide solution is 1.11g.cm-3. Exactly 10 mL of this solution was pipetted and quantitatively transferred, along with a sufficientamount of a dilute sulphuric acid solution, into a 250.00 mL volumetric flask and made up to the mark. A 25.00 mL portion of this diluted solution is pipetted into a conical flask, and titrated with a0.372 M KMnO4 solution. The endpoint of the titration is determined when the colourless solution in the conical flask turns apersistent bright pink due to the presence of excess permanganate ions. The average titration value is 26.20 mL of the KMnO4 solution 1.Determine the percentage of the hydrogen peroxide in the solution sample.2. Naturally occurring manganese…
Maganite is the leading brand for antacid to alleviate heartburn. Its active ingredient is a saturated solution of magnesium hydroxide (milk of magnesia) which neutralizes the sudden increase of H+ during heartburn. Its manufacturing company performed microtitration to simulate how the drug works upon intake.A 50.0 mL saturated solution was prepared. After filtering each solution, a 5.0 mL aliquot was transferred to a 25.0 mL Erlenmeyer flask and was titrated using pre-standardized 0.0320 M HCl which resembled the gastric acid. The endpoint was reached after the addition of 52.2 μL titrant.1. What is the concentration of hydroxide ions in the solution? Note: Use the scientific notation of 0.00012 = 1.2e-4 2. Determine s and Ksp of Mg(OH)2.Note: Use the scientific notation of 0.00012 = 1.2e-4
Maganite is the leading brand for antacid to alleviate heartburn. Its active ingredient is a saturated solution of magnesium hydroxide (milk of magnesia) which neutralizes the sudden increase of H+ during heartburn. Its manufacturing company performed microtitration to simulate how the drug works upon intake. A 50.0 mL saturated solution was prepared. After filtering each solution, a 5.0 mL aliquot was transferred to a 25.0 mL Erlenmeyer flask and was titrated using pre-standardized 0.0320 M HCl which resembled the gastric acid. The endpoint was reached after the addition of 52.2 μL titrant. What is the concentration of hydroxide ions in the solution? Determine solubility s.
A 11.00 gram sample of Vodka was analysed for its alcohol content. The sample was placed in a300 mL volumetric flask and made to the mark with distilled water. A 20.0 mL aliquot of the dilutedVodka was taken from the volumetric flask and placed in a conical flask containing some distilled water from a previous washing.The 20.0 mL aliquots were titrated against a 0.1302 M Cr2O72-solution and an average titre of13.25 mL was obtained.The reaction between the alcohol and the dichromate solution is given below2Cr2O72–(aq) + 3CH3CH2OH(aq) + 16H+(aq)  4Cr3+(aq) + 3CH3COOH(aq) + 11H2O(l)a) Calculate the amount in mol of Cr2O72– in the average titre. b) Calculate the percentage, by mass, of ethanol in the vodka.
Prepare 100.00 mL of a solution with ALL the following chemicals into together; CHEMICALS PROVIDED solid FeCl3 6H2O, iron(II) chloride hexahydrate (source of FeCl3) dilute hydrochloric acid in the rack – 3.0 M solid sodium salicylate – 99.7% assay Concentrations needed in the 100mL solution FeCl3: 0.020 M HCl: 0.050 M Salicylate (mg/L): 40.25 PLEASE SHOW HOW TO CALUATE AND WORK. The only equations you will need to use are the equations for molarity and dilutions.
Q1)a) In the gravimetric analysis the precipitate should be free from impurities. Give the detailed justification for the above statement by identifying impurities. b) It is required to analyse the metal from its ore sample. Manganese (Mn)present in the ore sample was analysed by forming a precipitate of MnSO4. If 2.98 g of ore sample gives 0.19 g of MnSO4. Calculate the percentage of Mn present in the sample.
Fifty food supplement tablets with a total mass of 66.393 g were crushed into powder to analyse the content of FeSO4·7H2O. 2.988 g of the powder were dissolved in HNO3 and heated to convert all the iron to Fe3+. Addition of aqueous NH3 caused quantitative .precipitation of Fe2O3· X H2O, which was ignited to give 0.0640 g of Fe2O3. Determine the average weight of FeSO4·7H2O in each tablet.
Show complete solution. Round-off your answers to four decimal places The amount of copper in a wire was determined by a redox titration using KMnO4 as the titrant. A 0.4185-g sample was dissolved in acid and the liberated Cu2+ quantitatively reduced to Cu+, using a reductor column. Titrating with 0.0250 M KMnO4 requires 41.27 mL to reach the endpoint. Determine the % w/w CuO in the sample of meteorite. Answer: % CuO = ______
Can you please please please not reject this question. I really need to know this. AND THIS IS NOT A GRADED QUESTION. So can someone please answer this without rejecting this everytime. I really need to learn how to do the calculations for this becuse I have my exam within 2 weeks. So please someone and this is not a graded question. Okay this time I have included all the information. Molarity is included. An experiment was conducted by following the procedure below. Prepare a 50-mL burette for titration. Rinse the clean burette and tip with two 5-mL portions of standardized 0.005 M HCl solution and discard. Fill the burette with standardized HCl, remove the air bubbles in the tip, and record the initial volume (± 0.01mL). Record the molarity of the HCl solution, which is 0.005M Cover the flask with parafilm to avoid contact with carbondioxide from air. Rinse a 25 mL pipet with 1 or 2 mL of the saturated Ca(OH)2 solution and discard. Pipet 25 mL of the filtrate into a clean…
Mark and John, two vinegar enthusiasts, are each tasked to determine the acetic acid content of their respective vinegar concoctions by titration. First, a 1 M-labeled KOH solution was standardized against the KHP (MW = 204.22 g/mol) standard that is 99.4% pure. In the process, 0.540 g KHP was found to require 2.80 mL of the KOH solution to completely react up to the phenolphthalein endpoint. Then, Mark and John both prepared their samples by taking 10.0-mL aliquots of each vinegar and diluting them to 25.0 mL. Using the same titrant and indicator, Mark’s vinegar required 18.60 mL of the standardized titrant to reach the endpoint, while John’s vinegar required 16.50 mL of the same titrant to reach the same endpoint. Question: What is the acetic acid concentration of Mark’s and John’s vinegar in molarity given that the Concentration of KOH is 9386 M?