Q: A piece of aluminum with a mass of 23.5 grams at a temperature of 0.0°C is dropped into an insulated...
A: Mass of Aluminium = 23.5 Final temperature = 87.2°C
Q: 17. What is the new volume when 8.0L of gas at 50°C and 120 kPa are heated to 60° C and 140 kpa? (Sh...
A:
Q: Starting material multi-step synthesis?
A: The synthesis given is,
Q: Water pollution is defined only as any physical or chemical change in water that: 1 a. Improves the ...
A:
Q: 15. In 1844, cis- and trans-[PtCl2(NH3)2] were discovered. The FDA approved the anti-cancer drug Cis...
A:
Q: Indicate whether the following balanced equations involve oxidation-reduction. If they do, identify ...
A: Note : Since you have posted a question with multiple sub-parts, we will solve first three sub-parts...
Q: 2A-B+C Two trials of the above reaction are run with the same initial concentration of A The first t...
A: Given : We have to calculate rate constant for the second half reaction.
Q: CFCS are responsible for releasing Cl radicals in the ozone layer due to absorption of a. UV radiati...
A: Since you have posted multiple questions, we are entitled to answer the first only.
Q: Refer to figure below. Which point represents solid-liquid-gas equilibria? 1 atm * Phase II. P Thasc...
A: Please find your solution below : Phase diagram is a graph which shows the occurrence of different p...
Q: Calculate the mass of excess reagent remaining at the end of the reaction in which 180.0 g of SO2 ar...
A:
Q: find the pH.
A: This is question with multiple subparts. So, according to bartleby guidelines I need to solve only f...
Q: 1s-1. The reaction 2 N,O5(g) →4 NO2(g) + O2(g) was studied and the rate of change of the concentrati...
A: Given Reaction:- 2N2O5(g) -------> 4NO2(g) + O2(g)
Q: moles of lithium hydroxide would be required to produce 59.5 g of Li₂CO₃ in the following chemical r...
A:
Q: Melting of the ice is a result of a a positive ΔS and a negative ΔH b a positive ΔS and a p...
A: When the water is reaches a temperature nearly 0℃ and below it it get freezes and Ice is formed.
Q: 5. In the titration of 15.00 mL of 0.200 M of a weak base, B:, (Ko = 7.25 x 10³) with 0.100 M HCI. c...
A: Given, Volume of weak base (B) = 15.00 mL Molarity of B = 0.200 M Base dissociation constant = Kb...
Q: Think about the following reaction: 2 A (g)⟶B (g) +2 C (g) Assume that we start with 100.0 mole...
A: Given the reaction: 2 A (g)⟶B (g) +2 C (g) 2 moles of A react to form 1 mole of B and 2 moles of C, ...
Q: Given the following peptide RISAGDLEVK, Determine the formal charge of peptide a. pH=0.5 b. pH=...
A:
Q: Consider a drug molecule that binds to an enzyme with a Kd of 20.281 nM. If the intracellular concen...
A:
Q: 11. Draw the Lewis structure and calculate the formal charge for oxygen atoms in an HCO3 ion? Show y...
A: Lewis’s structure: Lewis’s bonding theory is based on the octet rule. The Lewis structure is a simpl...
Q: CuBr. Cui63.5/223k100=28.4%omg Br: 19.9 *2-159.8/223.3x100 - 71.6%img Na OH Na: 25.0/40x (60-57.5% n...
A: Note: As per our guidelines, we are supposed to answer only the first three questions (i.e. 1 to 3 )...
Q: Refer to figure below. The temperature when the liquid reaches a vapor pressure same as the atmosphe...
A: The vapour pressure v/s temperature curve given is,
Q: Bromobutane (C4H9B1) reacts with ethyllithium ( C2H5L¡ ) as follows: C4H9B. + C2H5LI → C4H9LI + C2H5...
A: • The given equation is, 1C4H9Br + 1C2H5Li → 1C4H9Li + 1C2H5Br • We need to calculate the ...
Q: The reform reaction between steam and gaseous methane (CH,) produces "synthesis gas," a mixture of c...
A:
Q: 6. CH,SF Geometry:
A:
Q: chemical équation 0/5 A major component of gasoline is octane (C3H18). When octane is burned in air,...
A:
Q: Determine the concentration of the stock solution in molarity from which 50.0 mL was taken in order ...
A:
Q: balanced equation
A:
Q: Which of the following substances contain the greatest amount of empty space between their constitue...
A: Space between the constituent molecules in different phases (solid, liquid and gas)
Q: Complete the table below. Round each of your entries to 2 significant digits. You may assume the tem...
A:
Q: 10. Which ion has a higher ability to polarize? a) Na* or Mg* b) Mg²* or Ba?+ Explain your reasoning...
A: The polarizing power of cations depends on the charge density and size of the cation.
Q: Prepare 500 mL 0.1 M acetate buffer, pH = 4.3, from 0.1 M stock solutions of acetic acid and its sa...
A: Buffer is a solution that contains weak acid and its conjugate base in some fixed ratio that defines...
Q: Which one of the following changes would alter the rate constant (k) for the reaction 2A + B product...
A: Rate constant defines as to tells the relation between concentration of the reactant and rate of the...
Q: In the phase diagram below 1 atm Phase II. Phaco I: ....* .. Phase II .... ...* .... ... .... ... O ...
A: Phase diagram: The phase diagram represents the different phases of the substance and the pressure a...
Q: rate
A:
Q: ) The proton NMR spectrum of a compound with formula C5H12O2 is shown below. THE The carbon-13 NMR s...
A: Given: The NMR spectra of C5H12O2 13C NMR - 15ppm, 63ppm, 95ppm To find: Structure of the compound...
Q: How many moles of NO₂ would be required to produce 4.46 moles of HNO₃ in the presence of excess wate...
A: This question is related to stoichiometry. The most important thing before solving numericals relate...
Q: 2. Complete the following nuclear equation and identify X in each case: 4 a + X 2" 26 a.) Mg 12M9 + ...
A: Since you have asked multiparts questions, we will solve the first three sub parts questions for you...
Q: Mixture of NH,CI, NaCl, SiO, Iron Shavings First Separation Technique First Separated Component Rema...
A: The mixture given contains ammonium chloride (NH4Cl), sodium chloride (NaCl), silicon dioxide (SiO2)...
Q: A certain amount of benzene C&H (D= 0.985 g/mL) was dissolved in 0.500 kg CCI4 to produce a solution...
A: Given: Mass of solvent i.e. CCl4 = 0.500 Kg = 500 g. Mole % of solvent i.e. CCl4 = 37.0 % Density of...
Q: Complete the multi-step synthesis below by filling in the missing reagents in boxes below. Write nea...
A: In this multistep synthesis, there is one step where , there is inversion in stereochemistry. This ...
Q: Which of the following molecules can have dipole-dipole interactions as their strongest intermolecul...
A:
Q: What is the osmotic pressure (in atm) needed to maintain a cell that contains 0.749 M of CaCl2, an e...
A:
Q: On analysis, an equilibrium mixture for the reaction 2H2S(g) 2H2(g) + S2(g) was found to contain 1.0...
A: The equilibrium reaction given is, => 2 H2S (g) ⇔ 2 H2 (g) + S2 (g) Kc = 3...
Q: QUESTION 6 What is the mass of 5 atom(s) of copper in grams? Oa. 1.9 × 1021 10-22 g O C. 7.65 × 10-2...
A:
Q: Which buffer(s) would give the amino acid tyrosine an overall negative charge? Select all that are c...
A: Amino acids have an amino group as well as a carboxylic acid functional group. In acidic medium, the...
Q: Ship BOARD [Review Topica) [References) Use the References to access important values if needed for ...
A: Here by using strain energy increment of groups in chair conformation , we have to determine the str...
Q: how many molecules of nitrgoen, N2 are found in 78.2g of N2? The atomic mass of nitrogen is 14.01amu...
A:
Q: How much Hg3PO4 in ppm is formed when exactly 25.00 mL of a 0.3757 M Na3PO4 solution was mixed with ...
A: Given Na3PO4 molarity = 0.3757 M volume = 25 ml HgNO3 molarity = 0.5151 volume = 100 ml
Q: Using a chemical equation to find moles of product from moles ... Wine goes bad soon after opening b...
A:
Q: 7.00 mL of 6.00 x 103 M Fe(NO3)3 (6.00 times 10 to the minus 3rd power MFe (NO3)3) is added to 4.00 ...
A: Given: Concentration of Fe(NO3)3 taken = 6.00 × 10-3 M Volume of Fe(NO3)3 solution taken = 7.00 mL ...
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 2 images
- What pressure of nitrogen gas is required to produce a collision rate of 5.00 × 1019 s−1 at 525 K on a circular patch of surface of diameter 2.0 mm?An effusion cell has a circular hole of diameter 2.50 mm. If the molar mass of the solid in the cell is 260 g mol-1and its vapour pressure is 0.853 Pa at 400K, by how much will the mass of the solid decrease in a period of 2.00 hours?Explain the relationship between the partial pressure of agas and its rate of diffusion.
- At what pressure does the mean free path of krypton (Kr)atoms (d = 3.16 × 10-10 m) become comparable with thediameter of the 1-L spherical vessel that contains them at300 K? Calculate the diffusion constant at this pressure.An effusion cell has a circular hole of diameter 2.50 mm. If the molar mass of the solid in the cell is 260 g mol−1 and its vapour pressure is 0.835 Pa at 400 K, by how much will the mass of the solid decrease in a period of 2.00 h?A space vehicle of internal volume 3.0 m3 is struck by a meteor and a hole of radius 0.10 mm is formed. If the oxygen pressure within the vehicle is initially 80 kPa and its temperature 298K, how long will it take for the pressure to fall to 70 kPa?
- A container of internal volume 22.0 m3 was punctured, and a hole of radius 0.050 mm was formed. If the nitrogen pressure within the container is initially 122 kPa and its temperature 293 K, how long will the pressure take to fall to 105 kPa assuming that the temperature is held constant?Forgot to put the units they are asking for on the previous submission. Am I doing this correctly? A gaseous sample of molecules, with a molar mass of 87.9 g/mol, is contained in a cylinder at a temperature of 362. K and pressure of 101.9 kPa. The collision cross section of a molecule is 0.73 nm2 The collision freqency, z, of the gas under these conditions is ____________ s-1.Calculate the mean free path of carbon dioxide molecules at 25oC and 1.0 bar, if its collisional cross-section area is 0.52 nm2 .
- Relate Graham's Law of Effusion and Diffusion to the cell membrane's semi-permeability. Explain the mechanism how the said law affects the transport within and among the cells. Draw a simple diagram that clearly shows the mechanism.Starting from the definition of Cp and Cv, derive the expression of (Cp-Cv) expressed onlyin measurable quantities. the final answer will be:1. What is the apparent hard-sphere diameter of CO2 at 0°C? The viscosity of CO2(g) at 1 atm and 0°C is 139 μP (micropoise). 2. When equal amounts of hydrogen, H2, and iodine, I2, are mixed together at a total pressure of 1 bar, the partial pressure of hydrogen iodide, HI, vapour produced from by the reaction H2(g) + I2(g) ⇌ 2 HI(g) is 22.8 kPa. Calculate the equilibrium constant for the reaction. 3. The equilibrium constant for the reaction 2HCl(g) + O2(g) ⇌ H2O(g) + Cl2(g) is 13300 at 400 K and 429 at 500 K. Use the van't Hoff equation to determine the standard enthalpy of reaction.