At the diagram of the simple distillation apparatus and label the following parts or general areas: Round bottom flask Condenser (West) Keck clip (add them in) Clamp – and where they should be used 3-way connector vacuum adaptor Heat source Stir bar Thermometer Thermometer adapter Solution to be distilled Distillate Vapors Flow of water Also, where you would increase the number of theoretical plates to separate mixtures with closer boiling points?

At the diagram of the simple distillation apparatus and label the following parts or general areas: Round bottom flask Condenser (West) Keck clip (add them in) Clamp – and where they should be used 3-way connector vacuum adaptor Heat source Stir bar Thermometer Thermometer adapter Solution to be distilled Distillate Vapors Flow of water Also, where you would increase the number of theoretical plates to separate mixtures with closer boiling points?

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter14: Chromatography

Section: Chapter Questions

Problem 9P

See similar textbooks

Similar questions

Taylor was harvesting her beautiful, pure crystals via vacuum filtration from a methanol/water mixedsolvent system. She poured the solution containing her crystals into the Büchner funnel. Then sherinsed her flask with some warm methanol and poured that over the crystals resting in the Büchner…oops! Tell what happened and why
Volumetric pipettes are designed to deliver a precise amount of liquid, but only if you a. submerge the end of the pipette into a solution you are delivering. b. allow the pipette to drain freely, and leave any residual solution in the pipette. c. hold the pipette at a 45 degree angle and ensure that all the liquid is delivered.
sketch a schematic showing how a liquid sample can be extracted from a liquid pipeline?
DATA Note: Use the videos as references except when data is provided here. Table 1. Selection of Recrystallizing Solvent. Solvents Dissolution at room temperature? (+ or −) Dissolution at elevated temperature? (+ or −) Distilled water - - Acetone + n/a 95% ethanol - + Toluene + n/a Solid sample: Naphthalene Table 2. Mass Measurements. Mass, g Sample solid 0.5021 Empty watch glass 35.7602 Watch glass with recrystallized sample 36.2485 Table 3. Melting Point Determination. Temperature, oC Appearance of Sample in Capillary Tube … Solid 78.4 Solid 79.3 Solid with signs of liquid 79.9 Solid, liquid 80.6 Liquid, solid 81.3 Liquid with signs of solid … Liquid Theoretical Melting Point, oC: 80.2°C (176.4°F) QUESTIONS Which solvent should be used as the recrystallizing solvent? Check if your chosen solvent satisfies all characteristics of a good…
In measuring the surface tension of a liquid (drop weight method), 20 drops of the liquid (r=0.2cm) falling apart from the tip whose diameter is 0.4cm were found to weigh 0.95 gram. What is he surface tension of the liquid? Show complete solution, and round the final answer up to 4 decimal places.
Make a schematic diagram for the procedure below: A. Constant weighing of the crucibles Bring two porcelain crucibles to constant weight by heating to redness for 15 min over a burner (not including the cover; see Figure 1 for heating set-up). Cool the crucibles briefly on clean Al foil-covered wire gauze at room temperature for 5 min and into the desiccator for 25 minutes. Weigh each crucible accurately on an analytical balance. Repeat procedure a and b until two successive weights agree within ± 0.3 mg, be sure that all oxidizable substances on the entire surface of each crucible have been burned off.
Which part of the GC equipment does separation takes place?
After the extraction process, the organic solvent containing the organic compound was cooled and filtered after the crystals appeared. Upon filtration, the filter paper with the crystals are weighed immediately. Assume there were no additional steps in between and after, what are the possible errors committed in this set up?
A 400 mL sample of water is filtered through a pre-weighed filter. After drying to constant weight at 105 ° C, the filter is reweighed, it is determined that the mass had increased by about 142.8 mg. Determine the parts per million of suspended solids in water.
Which of the following description(s) are improperly used related to the process of filtration? Select all that apply Group of answer choices - you can pick more then one: "I filtrated my product" "At this step I filtered" "There was solid leftover in the filtrate" "Filtering was an important part of the experiment"
TRUE OR FALSE __________ 11. The minimum number of centrifuge tubes in a centrifuge machine during its operation is one. __________ 12. Never place reagents directly onto the weighing pan of a balance, always use weighing paper, a beaker, or some other container. __________ 13. To transfer a solution, the stirring rod touches the delivery point of the reagent vessel and the wall of the receiving vessel. __________ 14. An open flame is the heat source for heating or evaporating flammable liquids. __________ 15. Most chemicals used in experiments can be discarded into the sink.
Bleach is a strong and effective disinfectant, but it is readily inactivated in the presence of organic material. Its active ingredient, sodium hypochlorite, is effective in killing bacteria, fungi, and viruses, including the influenza virus. Diluted household bleach disinfects within 10–60 minutes contacttime is widely available at a low cost and may be recommended for surface disinfection in healthcare facilitiesWhy is it necessary to know the accurate proportion in mixing bleach and water in cleaning and disinfecting high-touch surfaces daily in household common areas like tables, hard-backed chairs, doorknobs, light switches, or phones?