ater flows in a 5-cm-diameter pipe at a velocity of 0.75 m/s. The mass flow rate of water in the
Q: Explain the the mechanical efficiency of a fan is the ratio of the rate of increase of the…
A: Kinetic energy is only mechanical energy of air . If we consider a fan to which we give some power…
Q: A 1.8 kg/s of steam expands in a turbine producing 550 kW of power output. The steam enters at a…
A: Given data: W˙=550 kWm˙=1.8 kg/sv1=18 m/sv2=70 m/sh1-h2=400 kJ/kgz1=900 mmz2=0 Need to determine the…
Q: 1 kg water is flowing through an inclined pipe at inflow velocity of 20 m/s. The pressure at the…
A: Given data, P = 200 kPa m = 1 kg V = 20 m/s Find Total Energy (E)
Q: A 1.8 kg/s of steam expands in a turbine producing 550 kw of power output. The steam enters at a…
A:
Q: team flowing at a rate of 10 kg/h enters a steam turbine at a velocity of 50 m/s and leaves
A:
Q: 1 kg water at velocity 12.5 m/s and 300C enters a 2.54 cm diameter horizontal pipe where there is no…
A:
Q: The ventilating fan of the bathroom of a building has a volume flow rate of 30 L/s and runs…
A: Given data: Density of air ρ = 1.2 kg/m3 Volume flow rate = V = 30 L/s
Q: 2. Water flows in a pipe of 23-cm diameter with an average velocity of 0.73 m/s, the diameter of the…
A:
Q: 1. Ammonia with a specific volume of 1.94 m³ /kg flows at a rate of 3.3 kg/s through a tube with a…
A: As per our guidelines we are supposed to answer only one question. Kindly repost other questions as…
Q: A household radiator has an inlet temperature of 73.2 oC and an outlet temperature of 42.5 oC. The…
A: Given, Initial Temperature (T1 ) = 73.2°C+273 = 346.2 K FInal Temperature (T2 )= 42.5°C + 273 =…
Q: 1. A desktop computer is to be cooled by a fan whose flow rate is 0.34 m³/min. Determine the mass…
A:
Q: Ol at 20°C (p = 888.1 kg/m² and u = 0.8374 kg/m - s) is flowing steadily in a 1.25 cm-diameter,…
A:
Q: Air at 60°C leaves a furnace and passes through a 12-m long, 20-cm × 20-cm square duct at an average…
A: Given data as per the question The temperature of air = 60°C Length of duct =12 m Area =20 × 20 cm2…
Q: (a) Water and alcohol are mixed in a y-duct as shown in Figure Q2 (a). Determine the density of the…
A: Fluid is a state of matter which deforms continuously on the application of force externally,…
Q: hile traveling on a dirt road, the bottom of a car hits a sharp rock and a small hole develops at…
A: Calculateing the intial velocity of the gasoline at hole-u=2ghWhere-g= accerleration due to…
Q: A sealed electronic box is to be cooled by tap water flowing through the channels on two of its…
A: Given data: Power dissipation, Q = 2kW The temperature rise of the water, ΔT = 4°C The specific heat…
Q: Water at the initial pressure of 1 atm and temperature of 15C is flowing through a pump. Final…
A:
Q: Q2: Glycerin with p = 1252 kg/m and µ = 0.27 kg/m-s is flowing through a 5-cm- diameter horizontal…
A:
Q: Water is flowing in a pipe that changes diameter from 20 to 40 mm. If inlet velocity is 40 m/s,…
A: Data given- D1 = 20 mm D2 = 40 mm V1 = 40 m/s
Q: Determine the rate of flow of water through a pipe of diameter 10 cm and length 60 cm when one end…
A:
Q: Underground water is being pumped into a pool whose cross section is 3m x 3m while water is…
A:
Q: Air flows at 70°C with an average velocity of 9 L=10 m m/s through a 10 m long rectangular duct with…
A: Given dataTemperature of the inlet air Ti=700CLength of the duct L = 10mAverage velocity of the air…
Q: The velocity profile in a fully developed laminar flow of water at 40°F in a 250-ft-long horizontal…
A: Solution : The equation of the velocity profile in a fully developed laminar flow is given as : The…
Q: Consider laminar flow of water in a 0.8-cm-diameter pipe at a rate of 1.15 L/min. The velocity of…
A: Given: The diameter of the pipe, D = 0.8 cm The flow rate of pipe, Q= 1.15 L/min
Q: The ventilating fan of the bathroom of a building has a volume flow rate of 50 L/s and runs…
A: Given: The density of the air is ρ=1.20 kg/m3. The volume flow rate of the air Q=50 L/s. The time…
Q: Q2 (a) Water and alcohol are mixed in a y-duct as shown in Figure Q2 (a). Determine the density of…
A: Fluid is a state of matter which deforms continuously on the application of force externally,…
Q: A pipe of diameter 10 cm carries water at a velocity of 5 m/s. Determine (a) the volume flow rate in…
A:
Q: A fluid is flowing in a 0.741 m x 1.698 m channel at the rate of 4.78 m/s and has a specific volume…
A: Given data: A=0.741 m x 1.698 mV=4.78 m/sv=2.739 m3/kg Need to determine the mass of the fluid in…
Q: The driving force for fluid flow is the pressure difference, and a pump operates by raising the…
A: As per given data, del P = 5 kpa, power input = 7 kw. maximum volume flow rate Q (m^3/s) = ? for…
Q: Consider the flow of oil with p = 894 kg/m³ and µ = 2.33 kg/m.s in a 40 cm diameter pipeline at an…
A:
Q: You want to know the power of a fan that is used to send air from a cooling system at 12 m linear…
A: Given data, Temperature of the air at stainless steel pipe, T1 = 25 °C = 298 K Temperature of the…
Q: 1. A hydroelectric power plant has the hydraulic turbine located 60 m below the elevation of the…
A:
Q: Q) Water flowing through a tube of 1.5 cm diameter is heated from 70°F to 88°F while the tube…
A: Given data, Diameter of the tube, d = 1.5 cm = 0.015 m Mean temperature of the water at the inlet of…
Q: Water flows in a 10-cm-diameter pipe at a velocity of 0.75 m/s. The mass flow rate of water in the…
A: Given: The diameter of pipe is D=10 cm. The velocity of water is v=0.75 m/s.
Q: A D0 = 10-m-diameter tank is initially filled with water 2 m above the center of a D =…
A: Given, The diameter of the tank, D0=10 m The diameter of the valve, D=10 cm=0.1 m The length of the…
Q: It is well known that the power consumed by a compressor can be reduced by cooling the gas during…
A: It is a well-known fact that the power consumed by a compressor is reduced by cooling the gas during…
Q: What is the mass flow rate of water in a pipe whose diameter d is 12 cm when the water is moving at…
A:
Q: Consider an air solar collector that is 1 m wide and 5 m long and has a constant spacing of 3 cm…
A: Given:w=1 ml=5 mb=3 cm =0.03 mTi=30°CQ=0.15 m3/sTavg g=20°CTavg c=60°C
Q: A pump increases the water pressure from 8 kPa at the inlet to 700 kPa at the outlet. Water enters…
A:
Q: A pump increases the water pressure from 8 kPa at the inlet to 700 kPa at the outlet. water enters…
A:
Q: 18. A hydroelectric power plant has the hydraulic turbine located 60 m below the elevation of the…
A: Given data Head = 60 m Diameter of pipe = 1m Velocity at inlet = 3 m/s Temperature = 15oC
Q: A 30 cm diameter pipe carries oil of 800 kg/m3 at 2m/s. At another section, the diameter is 20 cm.…
A:
Q: Water flows in a 3-cm-diameter pipe at a velocity of 0.55 m/s. The volume flow rate of water in the…
A: Given Velocity, v = 0.55 m/s Diameter, d = 3-cm Find The volume flow rate of water in…
Q: A wind tunnel is considered to be a steady-state operation, the system receives one hundred fifty…
A: what is 3a) and 3b) is not mentioned hence solving only 1st part Given : m=150 lbm/min=2.5…
Q: Q8. A gas enter a turbine with a velocity of 300 m/s and a temperature of 527 °C and specific…
A:
Q: A fluid with a pressure of 850kPa, a specific volume of 0.35m3/kg, and a velocity of 170m/s enter a…
A: Given:Inlet velocity=C1=170 m/sHeat lost,Q=30KJ=30×103JWork done,W=48KJ=48×103JOutlet…
Q: The air is estimated to lose heat at a rate of 18 kJ/s during this process. Determine (a) the exit…
A: GIven Data At state 1 80KPa,27C and 220m/s m=2.5 Kg/s At state 2 42C Area=400cm2.
Q: 1.8 kg/s of steam expands in a turbine producing 550 kW of power output. The steam enters at a…
A:
Water flows in a 5-cm-diameter pipe at a velocity of 0.75 m/s. The mass flow rate of water in the pipe is:
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 1 images
- How is volume flow rate different than velocity? What happens to volume flow rate in areas where fluid pressure is high?Oil with ? = 876 kg/m3 and ? = 0.24 kg/m·s is flowing through a 1.5-cm-diameter pipe that discharges into the atmosphere at 88 kPa. The absolute pressure 15 m before the exit is measured to be 135 kPa. Determine the flow rate of oil through the pipe if the pipe is (a) horizontal, (b) inclined 8° upward from the horizontal, and (c) inclined 8° downward from the horizontal.The air in a 5-m × 5-m × 3-m hospital room is to be completely replaced by conditioned air every 15 min. If the average air velocity in the circular air duct leading to the room is not to exceed 5 m/s, determine the minimum diameter of the duct.
- An insulated pipe of inside diameter 50 mm contains steam of specific enthalpy2·794 MJ/kg and specific volume 0·0394 m3 /kg. The pipe then reduces to 25 mmdiameter, and the specific enthalpy is then 2·786 MJ /kg and the specific volume is0·1043 m/kg. Determine the mass flow rate of the steam and its velocity in bothsections of the pipeThe 64-W fan in an aircraft environmental system is to circulate air through the ducting. An analysis of the flow shows that the fan needs to raise the pressure of air by 47 Pa to maintain flow. The fan is located in a horizontal duct with a circular cross-section whose diameter = 30 cm at both the inlet and the outlet. Determine the highest possible average flow velocity in the duct. Give your answer in m/s. Assume the fan operates steadily and that the changes in kinetic and potential energies across the fan are negligible. Note: I start this one by finding the volumetric flow rate from the work input and the pressure rise. Then I divide that by the cross-sectional area of the duct to get velocity.The velocity profile in fully developed laminar flow in a circular pipe, in m/s, is given by u(r) = 6(1 - 100r2), where r is the radial distance from the centerline of the pipe in m. Determine (a) the radius of the pipe, (b) the average velocity through the pipe, and (c) the maximum velocity in the pipe.
- The velocity profile in a fully developed laminar flow of water at 40°F in a 250-ft-long horizontal circular pipe, in ft/s, is given by u(r) = 0.8(1 - 625r2), where r is the radial distance from the centerline of the pipe in ft. Determine (a) the volume flow rate of water through the pipe, (b) the pressure drop across the pipe, and (c) the useful pumping power required to overcome this pressure drop.Water is flowing in a pipe that changes diameter from 20 to 40 mm. If inlet velocity is 40 m/s, determine the outlet velocity and the mass flux (mass flow rate)Consider an air solar collector that is 1 m wide and 5 m longand has a constant spacing of 3 cm between the glass cover andthe collector plate. Air enters the collector at 30°C at a rate of0.15 m3/s through the 1-m-wide edge and flows along the 5-mlong passage way. If the average temperatures of the glasscover and the collector plate are 20°C and 60°C, respectively,determine (a) the net rate of heat transfer to the air in thecollector and (b) the temperature rise of air as it flows throughthe collector.
- A garden hose attached with a nozzle is used to fill a 10-gal bucket. The inner diameter of the hose is 2.0cm, and it reduces to 0.8 cm at the nozzle exit. If it takes 50 seconds to fill the bucket with water, determine the mass flow rates of water through the hose.A fan is to accelerate quiescent air to a velocity to 20.00 m/s at a rate of 2.00 m3/s. If the density of air is 1.15 kg/m3. Determine the minimum power that must be supplied to the fan.____WDetermine the mass flow rate (kg/s) of water that must flow through a conduit to carry 15,000 kJ/s of heat energy if the temperature difference is 10 degrees Celsius. Cp water=4.186 k*J/Kg*K